In a step-up converter, the duty ratio is adjusted to regulate the output voltage V, at 48 V. The input voltage varies in a wide range from 12 to 36 V. The maximum power output is 120 W. For stability reasons, it is required that the converter always operate in a discontinuous-current-conduction mode. The switching frequency is 50 kHz. Assuming ideal components and C as very large, calculate the maximum value of L that can be used.

In a step-up converter, the duty ratio is adjusted to regulate the output voltage V, at 48 V. The input voltage varies in a wide range from 12 to 36 V. The maximum power output is 120 W. For stability reasons, it is required that the converter always operate in a discontinuous-current-conduction mode. The switching frequency is 50 kHz. Assuming ideal components and C as very large, calculate the maximum value of L that can be used.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

2. Given the circuit a. State how each switch can be realized using transistors and/or diodes, and whether the realization requires single-quadrant, current/voltage bi-directional two quadrant switch or four quadrant switches then redraw the circuit. b. Solve the converter to determine the inductor currents, capacitor voltages and conversion ratio. Ignore all losses.
For a buck converter, the following specifications are given: Vin = 600 V, L= 10 mH, and R = 1 N. a) Calculate the duty cycle required to deliver 200 A de into the load. b) Derive an expression for the peak-to-peak current ripple seen by the load. c) Estimate the switching frequency necessary to limit the peak-to-peak current ripple to no more than 5 A.
Can you solve the question step by step clearly ?
Operate the Buck converter circuit in discontinuous conduction mode. Identify the parameter values that needs to be modified in order to do so
What is the difference of the readings between B/A and A/B sections in the oscilloscope of Multisim?
Working principle of boost DC TO DC converter
You are an electrician working on an overhead crane. The crane uses a large electromagnet to pick up large metal pipes. The magnet must have a minimum of 200 VDC to operate properly. The crane has an AC source of 240 V. You are given four diodes that have a peak voltage rating of 400 V each. These diodes are to be used to form a bridge rectifier to convert the AC voltage into DC voltage. Is the voltage rating of the diodes sufficient? To the nearest volt, what will be the DC output voltage of the bridge rectifier?
Q5. For the following center tapped transformer, show the waveform across each half of the secondary winding and across Ri, when a 100 V peak sine wave is applied to the primarywinding. What is the PIV rating must the diode have? (Use constant voltage drop model for the Silicon diode) D1 IN4001 RL out OV 10 kN IN4001 alll
Name thr converter
A load consists of XL=70 and XC=150 are connected in parallel across 120 Volt supply.The reactive power of the circuit is.......
(b) If such a circuit is to be used to supply an average of 10 V across the load, calculate the turns ratio of the transformer required. The input mains voltage is 240 V rms at 50 Hz. You may assume ideal diodes in your analysis. Note again that there is to be no smoothing of the load voltage.
Creating buck-boost converter diagram using the following: Voltage: 12V-5V The diagram includes voltage regulator.