Explain five (5) applications of the hall effects With the aid of a diagram, explain how a P-N Junction is form. iii. State five (5) application of PN Junction, and explain the property of the PN junction that make those application possible. Explain what carrier mobility is and elaborate on the factors that influence carrier mobility. A 80 V rms is stepped down to 18V rms by a transformer. The output from the transformer is rectified using a half wave rectifier circuit and connected to a 47.5 Ω load resistor. Draw a circuit diagram of this arrangement and the waveform at each stage. Calculate the following about the circuit in Figure 2.1 (If silicon diodes are employed in the rectification); the peak value of the output voltage considering the drop across each diode, the average voltage, iii. The current through the load resistor, The current diode, The frequency of the output signal, Calculate the efficiency of the full wave rectifier expressed in percentage. vii. Sketch a graph of the input and output voltage against time. If a 480 ?F capacitor is added to the output in Figure 2.1, calculate the following: Vripple. Average voltage, Vdc. iii. Sketch a graph of the input and output voltage against time of the capacitor.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Question

Explain five (5) applications of the hall effects
With the aid of a diagram, explain how a P-N Junction is form.

iii. State five (5) application of PN Junction, and explain the property of the PN junction that make

those application possible.

Explain what carrier mobility is and elaborate on the factors that influence carrier mobility.
A 80 V rms is stepped down to 18V rms by a transformer. The output from the transformer is

rectified using a half wave rectifier circuit and connected to a 47.5 Ω load resistor.

Draw a circuit diagram of this arrangement and the waveform at each stage.

Calculate the following about the circuit in Figure 2.1 (If silicon diodes are employed in the

rectification);

the peak value of the output voltage considering the drop across each diode,
the average voltage,

iii. The current through the load resistor,

The current diode,
The frequency of the output signal,
Calculate the efficiency of the full wave rectifier expressed in percentage.

vii. Sketch a graph of the input and output voltage against time.

If a 480 ?F capacitor is added to the output in Figure 2.1, calculate the following:
Vripple.
Average voltage, Vdc.

iii. Sketch a graph of the input and output voltage against time of the capacitor.

Expert Solution

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Single Phase Controlled and Uncontrolled Rectifiers

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions