In a series RLC circuit driven by sinusoidal input signal, the phase between the current and the input voltage is plotted in the next graph. If the inductance L= 5 mH and the resistance R= 1 k2 then the capacitance in the circuit (in units of uF) is about: 1.6 1.2 0.8 0.4 -0.4 -0.8 -1.2 -1.6 1 10 100 1000 Frequency (f), kHz Phase ( ), rad

In a series RLC circuit driven by sinusoidal input signal, the phase between the current and the input voltage is plotted in the next graph. If the inductance L= 5 mH and the resistance R= 1 k2 then the capacitance in the circuit (in units of uF) is about: 1.6 1.2 0.8 0.4 -0.4 -0.8 -1.2 -1.6 1 10 100 1000 Frequency (f), kHz Phase ( ), rad

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

4. Find Idc, Vdc and the capacitance that will force the Vr(pp) to 2mV. Draw the output waveform across the capacitor. Fin=60HZ. TX1 D1 Ge Vac Lst 230V Lp 1 RL 12-0-12 Center tapped CL 1k D2 Ge 2
Describe the resulting waveforms when the capacitors (initially 20uF and then replaced with 100uF) were connected in parallel with the load
Shown in the figure below is an "RLC" circuit driven by an AC power source. The AC power source has an RMS voltage of Vps(RMS) = 9.35 Volts and is running at a frequency of f = 113000 Hz. The resistor has a resistance of R = 1980 , the capacitor has a capacitance of C = 1.08e-09 Farads, and the inductor has an inductance of L = 3.71e-03 Henries. mm Vps Write the FORMULA for the total impedance of the circuit Ztot = Write the FORMULA for the phase of the total impedance of the circuit øztot Determine the numerical value of Ztot = 2384 Determine the numerical value of @Z tot Determine the current through the circuit: ● R www I(PEAK) = I(RMS) = ● ● Determine the voltage across the inductor: • VL(PEAK) = Volts Volts VL(RMS) = Amps Amps Determine the voltage across the capacitor: Vc(PEAK) = Volts Volts Vc(RMS) = = 33.85 a capacitive switcher Ω degrees C If a second circuit were connected in parallel with the resistor, this circuit would be considered as: O a high-pass filter a radio tuner O…
Shown in the figure below is an "RL" circuit drive by an AC power source. The AC power source has an RMS voltage of Vps (RMS) = 9.84 Volts and is running at a frequency of f = 8.585e+04 Hz. The resistor has a resistance of R = 2170 and the inductor has an inductance of L = 3.54e-03 Henries. Vps R ww Write the FORMULA for the total impedance of the circuit Ztot = Determine the numerical value of Ztot = 2890.5 Determine the numerical value of $z= = 41 Determine the current through the circuit: • I(PEAK) = 4.81E-3 • I(RMS) = 3.404E-3 Determine the voltage across the resistor: • VR(PEAK) = 7.387 • VR(RMS) = 5.22 ✔✔ Amps ✔Amps Write the FORMULA for the phase of the total impedance of the circuit z... = | tan-1 2701 R x Volts X Volts Determine the voltage across the inductor: • VL(PEAK) = 9.184 • VL(RMS) = 6.49 ✔ Volts Volts L R²+ WL- ✔ degrees 2 If a second circuit were connected in parallel with the inductor, this circuit would be considered as: O a low-pass filter O a capacitive switcher…
For a given series RC circuit with resistance R= 50 ohm and capacitance C= 1.5uF connected to an ac voltage source of 60 V, 2500 Hz, then the magnitude of current through the circuit is Select one: a. 5.45A b. 3.45A c. 0.915A d. None of these
What are coupled waveforms? Are they at either end of the same magnitude?
PROBLEM 1: In a series R-L circuit the p.d. across the resistance R is 16V and the p.d. across the inductance L is 6V. Find the supply voltage and the phase angle between current and voltage.
By convention, the sign of reactive power to an inductance is and the sign of reactive power to a capacitance is
Please
Problem E Provide steady-state waveforms for the cap voltage and output voltage on the same timeline. R1 vc(t) Vout (t) C1 til C1 0.2 uF All R 10k +10V IC1 Vcc/-Vcc +8v/ -8V -10V R2 R3
Shown in the figure below is an "RC" circuit drive by an AC power source. The AC power source has an RMS voltage of Vps (RMS) = 11.58 Volts and is running at a frequency of f = 1.326e+04 Hz. resistor has a resistance of R = 3750 2 and the capacitor has an capacitance of C = 3.17e-09 Farads. Vps R ww Write the FORMULA for the total impedance of the circuit Ztot = Write the FORMULA for the phase of the total impedance of the circuit tot = Determine the numerical value of Ztot = Determine the numerical value of Pztot= Determine the current through the circuit: • I(PEAK) = • I(RMS) = Determine the voltage across the resistor: Amps Amps S2 C degrees
Solve for the total capacitance of the circuit. Select one: a. 5.28 micro Farads b. 6.64 micro Farads c. 8.42 micro Farads d. 5.92 micro Farads