In a DC circuit, the inductor can be * replaced with a current source replaced with a voltage source O replaced with an open circuit O replaced with a short circuit
Q: An AM radio station using double side band transmitted carrier system employs a carrier of frequency…
A: Given, In an AM signal Carrier frequency, fc=2.1 MHz Modulating signal frequency, fm=4 kHz
Q: Express the following two signals in terms of the unit step sequence u[t]. Justify your answer with…
A: Unit step signal- If step signal has unity magnitude, so those step signal is known as a unit step…
Q: uce a report by applying the concep rials relating to a tricycle as shown ollowing incorporated: The…
A: 1) Some tricycles, such as cycle rickshaws (for passenger transport) and freight trikes, are used…
Q: Given the figure above, determine the switch or switches that must be turned on if the situation…
A: In this questions, we need to tell about which switches will be in close position to circulate the…
Q: 1.1.3 Sketch the signal y(n)= x(n+1)[8(n+3)+8(n)+8(n-3)].
A:
Q: B/A shunt generator delivers 450 A at 230 v and the resistance of the shunt field and armature are…
A:
Q: A 3 phase line having an impedance of (5+j20)ohm per phase delivers a load of 30MW at a power…
A: It is given that: Z=5+j20 Ω =20.61∠75.96° Ωso, R=5 Ω and X=20j Ωcosϕ=0.3Y=0 (neglected)V=33 KVSo,…
Q: 16.35 Obtain the transfer function H(s) = V/V, for the circuit of Fig. 16.65. VS + 0.5 F 1 H m 2i 3…
A:
Q: 4. Considering an edge triggered T flip-flop, answer the following THREE questions (a) Write out its…
A:
Q: Problem: A certain rectifier filter produces a dc output voltage of 75 V with a ripple voltage of…
A: Given that : Rectifier filter Vdc= 75 v Peak to Peak ripple voltage Vrpp = 0.5 v
Q: If the magnitude of a transfer function is given to be 2000 in linear scale, |H| = 2000 , what would…
A: Given: Magnitude of transfer function on linear scale, H=2000
Q: Compare the motor action with generater action principle.
A: Comparision of the motor action with generater action.
Q: The half wave dipole antenna height of transmitter is 175 m and antenna height of receiver is 18 m.…
A: Given: The height of the transmitter is ht=175 m.The height of the receiver is hr=18 m.The field…
Q: 2/ Find the transmission parameters for the two port network 54₁ 1₂ 1₁ 2002 www ww 30 Ω
A: Given data, Circuit diagram is given as,
Q: Determine Vout for Vin=169 V, R₁-234 Ohm, R₂-28 Ohm Un R₁3 www R23 -Vout
A: Given, The circuit is, Specifications: Vin=169 VR1=234 ΩR2=28 Ω
Q: 5) The diode current given that n = 2, Is = 40 nA, VD=0.5 V with thermal voltage V₁ = 25.27 mV @ 20…
A: Given, The specification of a diode circuit are η=2Is=40 nAVD=0.5 VVT=25.27 mVT=20°C
Q: (a) Find the s-domain expressions for the z-parameters of the two-port circuit shown in Fig. (b)…
A: Given circuit :
Q: Given the circuit below, which of the below value(s) would change if the inductance value were…
A: Formula to calculate iL(t) is: iL(t)=i(∞)+i(0+)-i(∞)e-tTwhere, T is time constantT=LRi(0) is initial…
Q: (A) Consider the following system, Draw the Polar Plot for the open loop T 100 G(s) = (S+2)(S+4)…
A: Rules for Drawing Polar Plots- Substitute, s=jω in the open loop transfer function. Write the…
Q: During spot welding of MS sheets 6mm thick, 2000A current is passed for 0.5µs. Sheet interface…
A: Solution- Due to passing of current heat generated (H) = i2.R.t…
Q: An AM radio station using double side band transmitted carrier system employs a carrier of frequency…
A:
Q: The open-loop transfer function of a unity feedback system is 16 G(s)= s(s+2) (a) Determine the…
A:
Q: Determine the voltage V, in the circuit shown below
A:
Q: i. Name two amplifiers from your study that provide a negative voltage gain. ii. Draw these two…
A:
Q: A three-phase Y-connected 230-V (line-to-line) 7.5-kW 60-Hz six-pole induction motor has the…
A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…
Q: What is the minimum current carrying capacity of the generator side disconnect switch if transformer…
A: Types of Electrical Machine Transformer Induction machine Synchronous machine DC Machine
Q: 1. In the given triangle, charges Q1= 50x10^-9 C and Q2= -40 X10^-9 were placed as shown. Find the…
A:
Q: Find the voltage vo(t) in the circuit of Fig. by means of the Laplace transform.
A: For the circuit given as follows- The s-domain circuit is drawn as shown below-
Q: For the op-amp shown below the values of I, and Vx respectively are: a) OmA, 7sinwt v. b) 7mA, 7v.…
A: In this questions, we need to find the input current at inverting terminal of opamp. Also we need to…
Q: A balanced 3-phase delta connected load of 160 kW, connected to a balanced line voltage of 1100 V,…
A:
Q: Given: VDS 4V Find: a. ID b. VD and Vs c. VGS + VGS 20 V '3 ΚΩ ID 4 V ' 1.2 ΚΩ
A: Given here a FET based circuit and asked to find the ID , VD , VS , VGS . given circuit is
Q: / In the circuit of Fig (2) R=480 02, L-0.4H, C=2.5 µF and Vs=120V A. Calculate the characteristic…
A:
Q: A conductor carries a current that is equivalent to a 5-amp continuous current in one direction and…
A: In a full wave rectifier that convert the complete cycle of AC into a pulsating Direct current. It…
Q: A common emitter transistor amplifier working in active mode of operation has collector current of 1…
A: Given: A common emitter transistor amplifier working in active mode has, Collector current, IC=1 mA…
Q: Question: What would the pole pass frequency be for a AC induction moor running at 878 RPM? ( assume…
A:
Q: (B) Explain what's different between First order system and Second order system simplify, Give…
A: Electric control system;- It is interconnection of devices from which desired output can produce.…
Q: Determine the voltage V, in the circuit shown below
A: It is given that:
Q: calculate the magnetic flux density for the current distribution in free space to be A = (3x²y+yz)…
A: Magnetic flux is the total magnetic field pass through a given area. It is denoted by ϕB and the…
Q: An information signal to be transmitted digitally is a rectangular wave with a period of 70.4 μse…
A: An sampling frequency is the average number of samples obtained per second. Frequency is the inverse…
Q: Problem 26 O 27. (11) Consider three capacitors, of capacitance 3100 pF, 5800 pF, and 0.0100 F. What…
A: This question belongs to circuit theory . It is based on the concept of equivalent capacitance .…
Q: Simplify the following block diagram. 63 G, ܣܩܟ H1 G4 H 62
A: Given data, Block diagram is given as,
Q: the GSM radio cellular system uses GSMK in a 200.KHZchannel with a channel data rate of 270.833 KBS.…
A: Given: GSM radio cellular system uses GSMK in a 200 KHZ channel.Channel data rate of 270.833 KBS.…
Q: Given the nominal first order model What is the time constant and the gain for G(s) = 5 s+0.25 A.…
A: Given: The nominal first order model, Gs=5s+0.25
Q: The effective power of a motor, which is connected to a 220 V electricity network, is 400 W. Please,…
A: We need to find current for given power and voltage
Q: Q3/ Determine if each of the following signals is a power signal, an energy signal, or neith (a) ₁…
A: We need to check whether the given signal are energy or power signal .
Q: B/ A shunt generator delivers 450 A at 230 v and the resistance of the shunt field and armature are…
A: In this question, We need to determine the generated emf of the DC shunt Generator. In the DC…
Q: Q2/ Find the input impedance for the circuit below Zin 10 Ω ww j12 Ω j15 Ω ell 20 Ω j40 Ω -j5 Ω
A: Given Data,
Q: (B): Obtain the transfer function V₂(s)/V₁(s) of the electronic cct. shown in Fig. (3) C₁ ਮੁਰੰਮਤ '…
A:
Q: A Voice signal is sampled at the rate of 8000 samples per sec And each sample is encoded into 4 bits…
A: Pulse code modulation (PCM) :- It used to represent sampled analog signals in binary sequence, so it…
Q: 1. Suppose you have multiple sinusoidal signal sources with four different frequencies where f₁-4,…
A: Matlab code for the message signal: clc;clear all;close all;t=0:…
Step by step
Solved in 2 steps
- A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
- Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.For circuit given in figure 5, find total capacitance and total charge. C1 = 20pF C2 = 30pF 5V C3 = 30pF C5 10pF C4 = 30pF Figure 5I am having trouble with this problem it might be the dot notation for the inductors but I am not entierly sure that is the only issue I am having
- Determine the equivalent inductance and equivalent current of the inductive circuit in Figure Q4. If L5 is replaced with a capacitor of 0.5 mF, how would it affect the branch current? The alternating Voltage source has an amplitude of 20 Vm. Vm Sine 50 Hz L1 5 mH L2 3 mH cele rele Figure Q4 rele celer L3 6.6 mH L4 2.8 mH reler L5 7 mHA 22-k resistor and a 0.02-F capacitor are connected in series to a 5-V source. How long will it take the capacitor to charge to 3.4 V Select one: a. 0.501 ms b. 0.66 ms c. 0.44 ms d. 0.70 msThe attached image shows a circuit with an AC voltage source, a resistor, inductor, and capacitor connected in series. The circuit has the following characteristics: Resistor resistance: 10 ohm Capacitor capacitance: 0.05 F Inductor inductance: 13 H Current Amplitude: 4 A Voltage amplitude across the source: 60 V Frequency at the source: 0.3 Hz Voltage amplitude across the resistor: 35 V Voltage amplitude across the capacitor: 37 V Voltage amplitude across the inductor: 80 V (a) Calculate the RMS voltages from the amplitudes above. From the RMS voltages across the capacitor, inductor and resistor, calculate the RMS voltage of the AC source. Hint: Vrms = V0/sqrt(2) Vrms = sqrt( (Vrms,R)2 + (Vrms, L - Vrms, C)2 ) (b) Calculate the RMS value of the current (c) Using the resistance, capacitance, inductance, and the frequency of the AC voltage, calculate the impedance Z. From this, and the previously measured value of Vrms, find the RMS value of the current in the circuit.
- An inductor of 230 milli Henry, a capacitor of 15 micro farad and a 200 ohm resistor are in series across a 36 V and 60 Hz voltage source. Find the total current a. 150 mA b. 0.164 A c. 0.2 A d. 170 mAQUESTION 9 E-06, PC-02. Three inductors 5 mH, 15 mH and 25 mH are connected in series. What is the total inductance? 5 mH. 45mH. Without knowing the coupling factor the total inductance cannot be found. QUESTION 10 E-06, PC-05. An inductor is said to be saturated when? The current through it is zero. The current is at a maximum. It will no longer accept lines of flux.1. A purely resistive circuit the current is leading by 90° with respect to voltage. 2. A purely inductive circuit the current is lag behind the voltage by 90°. 3. A purely capacitive circuit the current is lead by 90° with respect to the voltage. 4. A capacitor element stored magnetic energy. 5. An inductor element stored electrical energy. 6. Resistor elements consume power. 7. Angle between current and voltage is called power. 8. The power factor angle for a purely resistive is zero. 9. The power factor angle for a purely inductive load is -90°. 10. The power factor of a purely capacitive is leading.