QUESTION 9 E-06, PC-02. Three inductors 5 mH, 15 mH and 25 mH are connected in series. What is the total inductance? 5 mH. 45mH. Without knowing the coupling factor the total inductance cannot be found.

QUESTION 9 E-06, PC-02. Three inductors 5 mH, 15 mH and 25 mH are connected in series. What is the total inductance? 5 mH. 45mH. Without knowing the coupling factor the total inductance cannot be found.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Related questions

Q: 2. If three equal capacitors are connected in series to an 18 V(rms) AC source, each capacitor drops…

A: given data:

Q: Determine the value of the capacitor to be connected in parallel with ZL (load) in order to correct…

A: In this question, We need to determine the value of the capacitor to be connected in parallel with…

Q: -- late inductor and Goprcitor voltjn thae el He energy sturrd the in

Q: must be in POLAR FORM. 1. What is the fourth root of unity?

Q: What is the equivalent inductance between nodes a and b? 6 mH 3 mH 6 mH 6 mH ll O 2.6 mH O 5.0 mH O…

Q: Five inductors, each 10 mH, are connected in series across a sine wave ac source. Determine the…

A: Given data, Five inductors each of 10 mH are connected in series.

Q: Four electrolytic capacitors are connected as shown in the figure. 12.0 V 0.00 A

Q: reactance? 22. A circuit consists of a 4 N resistor and 300 µF capacitor in series. It is connected…

Q: QUESTION 13 Three capacitors, a 10 micro-F, a 15 micro-F and a 32 micro-F, are connected in…

A: (13) if capacitor are connected in parallel theequivalent capacitance Cth = C1+C2+C3 Cth=10+15+32 uF…

Q: Enumerate five formulas for five series connected inductances across Vt source and draw the circuit.…

Q: the shunt capacitance is a capacitor O a. Between a phase and the ground O b. between phases and a…

A: In this question, We need to choose the correct options What is shunt capacitance is a capacitor?…

Q: below including the a(n) = (금)"sin(- )"sin(-n 3 4

A: In this question we have to find z transform of given signal..

Q: Capacitance is ___ proportional with A and ___ proportional with d.

Q: 2. Determine the inductance at terminals A-B in the network in the follow diagram: ' 1mH 1mH 2mH…

A: In this question we need to find a equivalent inductance between the two terminal of the given…

Q: QUESTION 19 E-06, PC-02. Three inductors 15 mH, 15 mH and 15 mH are connected in series. What is the…

Q: Problem [13] Determine the equivalent inductance at terminals a and b. 10 mH 60 mH 25 mH 20 mH a o…

Q: A capacitor consists of two parallel plates in air with a distance of 0.8cm between them. The area…

Q: What is the capacitance of five capacitors connected in series with values of 0.01 uF? 0.05 uF 0.02…

Q: Calculate the total capacitance in the series circuit

A: In this question series circuit of capacitances is given....We have to find out total…

Q: Three circuit elements in parallel have admittance of 6.3 angle-40 mS at a frequency of 2 kHz. If…

Q: wo element R=5 ohm and c=100 uF are connected in series at t=0. Initial capacitor voltage is 2 V.…

A: Fig: RC circuit without source. Given data R= 5 ohm C= 100 micro farad V0 =2V

Q: The following 3 capacitors are connected in series what will the total reactance be? 12uf, 20uf,…

A: The following 3 capacitors are connected in series 1/C= 1/C1+1/C2+1/C3 what will the total reactance…

Q: the shunt capacitance is a capacitor O a. Between a phase and the ground O b. between phases and a…

Q: The switch will be open at t=0msec for the RL circuit shown in Figure 1. Find out the expression of…

A: We need to find out the current and voltage for given resistor and inductor circuit .

Q: What will be magnitude of the total circuit impedance of a series LR circuit excited by a 100 Hz ac…

A: If a circuit consists of series combination of a resistor of resistance R and an inductor of…

Q: QUESTION 16 E-06, PC-02. Three inductors 15 mH, 15 mH and 15 mH are connected in parallel. What is…

Q: Two capacitor 6uf and 3uf are connected in series in an emf supply 400v. Calculate The potential…

Q: Determine he urvent (I(4)in the inducor , suppere tat the circut is in penmanent state at + = 0)…

A: The temperature within the system does not vary over time while it is in a steady-state. Under…

Q: If three inductors connected in series 0.06 H,0.05H,0.1H.What would be the inductive reactance of…

A: Given:- Inductors are connected in series, L1 = 0.06H , L2 = 0.05H , L3 = 0.1H frequency, f = 60…

Q: Determine the voltage across the capacitor when t= 2 ms. (You must provide an answer before moving…

A: It is given that: R1=5.128 ohm

Q: A 47-ohms load resistor is connected in series with a 10-uF capacitor. At what frequency will the…

Q: changes its physical capacitiv ges in temperature t one:

A: Thermistor is useful for measuring temperature.

Q: An inductance of 15mH has a current drawing I = 15sin(650t - 300) A. Determine the equation of…

Q: A resistor of R = 10 ohms and an inductor of L = 0.005h are in parallel. The current in the…

Q: A 16 Voltage is applied to the circuit with a 47 ohms resistor connected in series with a 10uF…

A: Value of load resistance Value of capacitance Frequency is given as f = 500 Hz Voltage applied to…

Q: 1)Four capacitors are arranged as shown in the diagram. What is the equivalent Capacitance between…

A: NOTE: As per the guidelines will be solving only the first question. Please repost for other…

Q: 9. Find voltage across 12H inductor. 10H 12H 2H B 44V а) 2V b) 10V c) 12V d) 20V

A: we need to find out voltage across 12 H.

Q: What is the capacitive reactance of 0.001-F capacitor at 60Hz? answer should be in rectangular form

A: In this question, We need to capacitive reactance of 0.001-F capacitor at 60Hz?

Q: A sinewave voltage with amplitude 2 V and frequency 1 kHz is applied capacitor. The capacitance is…

A: Given parameters are,

Q: 7. Find voltage across 2H inductor. 10H 12H 2H 20H A B 44V а) 2V b) 10V c) 12V d) 20V

A: we need to find out voltage across 2 H inductor.

Q: What will be the voltage drop across a 5 mH inductor when 4.5 sin (20t) A current flows through

Q: What is the inductor current if VL is 500 sin(50t + 20°)? 5 sin(50t - 70°) 5 sin(50t + 20°) 5…

Q: 6. What is the total capacitance of a circult containing a .01 farad, a .015 farad, and a .001 farad…

Q: 1. The total inductance for this circuit is mh. 4 h 2h 3h L

A: The given circuit is: Let the total voltage of the circuit is v(t), and the current flows through…

Q: For the series-parallel inductor circuit shown in figure B19, answer the following questions. 2mH…

A: Fig: Given circuit

Q: 1. The total inductance for this circuit is mh. 4 h 2 h 3h 1h

Q: Find the total capacitance Cr for the circuit in Figure で 76 µF 4µF 6µF

A: Given circuit:

Q: The Total Voltage in an RC Series Circuit splits or gets distributed across the Resistance and…

A: In series RC circuit the current flowing through the circuit is I , The voltage across the…

Concept explainers

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
List the five capacitor replacement rules.
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?
What is the minimum AC voltage rating of each capacitor in Question 11?
Two capacitors having values of 80 F and 60 F are connected in series. What is the total capacitance?
By convention, the sign of reactive power to an inductance is and the sign of reactive power to a capacitance is
A elearning.adpoly.ac.ae * Question Completion Status: QUESTION 16 E-06, PC-02. Three inductors 15 mH, 15 mH and 15 mH are connected in parallel. What is the total inductance? O Without knowing the coupling factor the total inductance cannot be found. O 45mH. O5 mH. QUESTION 17 E-06, PC-04. The time constant in an inductive circuit is the time required for the current to reach? O 70.7% of maximum value. O 63,7% of maximum value. O 63,2% of maximum value. QUESTION 18 E-06, PC-01. When more than two inductors of different inductance are connected in parallel in a circuit, the total inductance is? O Less than the inductance of the lowest rated inductor. O Equal to the sum of the individual inductance. O Equal to the inductance of the highest rated inductor. QUESTION 19 E-06, PC-02, Three inductors 15 mH, 15 mH and 15 mH are connected in series, What is the total inductance? Click Saue and Submit to save and submit. Click Save All Answers to save all answers.
The attached image shows a circuit with an AC voltage source, a resistor, inductor, and capacitor connected in series. The circuit has the following characteristics: Resistor resistance: 10 ohm Capacitor capacitance: 0.05 F Inductor inductance: 13 H Current Amplitude: 4 A Voltage amplitude across the source: 60 V Frequency at the source: 0.3 Hz Voltage amplitude across the resistor: 35 V Voltage amplitude across the capacitor: 37 V Voltage amplitude across the inductor: 80 V (a) Calculate the RMS voltages from the amplitudes above. From the RMS voltages across the capacitor, inductor and resistor, calculate the RMS voltage of the AC source. Hint: Vrms = V0/sqrt(2) Vrms = sqrt( (Vrms,R)2 + (Vrms, L - Vrms, C)2 ) (b) Calculate the RMS value of the current (c) Using the resistance, capacitance, inductance, and the frequency of the AC voltage, calculate the impedance Z. From this, and the previously measured value of Vrms, find the RMS value of the current in the circuit.
a capacitor and a resistor are connected in parellel to a 120 v 60 hz line the resistor has a resistance of 40 ohms and the capacitor has a capacitance of 132.6 uf what is the total current flow through the circuit. what is the impedence and the power factor and how many degrees out of phase are the current and voltage out phase with eachother.
Determine the equivalent inductance and equivalent current of the inductive circuit in Figure Q4. If L5 is replaced with a capacitor of 0.5 mF, how would it affect the branch current? The alternating Voltage source has an amplitude of 20 Vm. Vm Sine 50 Hz L1 5 mH L2 3 mH cele rele Figure Q4 rele celer L3 6.6 mH L4 2.8 mH reler L5 7 mH