In a certain portion of road to be constructed, the following data were taken.Station20.006.85+2.3Station6.0+2.0Base width for cut+1.5+1.21+1+6 m6.39+1.06.9+2.670Solve for the volume using End-Area method.

Given data: Station L C R 1+20.00 +2.36.85 +1.50 +1.06.39 1+70.00 +2.06.0 +1.20 +2.66.9…

In a certain portion of road to be constructed, the following data were taken. Station 1+ 6.85 +2.3 Station 6.0 +2.0 Base width for cut +1.5 +1.2 1+ 6 m 20.00 6.39 +1.0 6.9 +2.6 70 Solve for the volume using End-Area method.

In a certain portion of road to be constructed, the following data were taken. Station 1+ 6.85 +2.3 Station 6.0 +2.0 Base width for cut +1.5 +1.2 1+ 6 m 20.00 6.39 +1.0 6.9 +2.6 70 Solve for the volume using End-Area method.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: STATION CUT (m²) FILL (m²) 1+000 40 1+052 33 1+272 3.021

A: Introduction- Understanding the center line and excavation drawings, laying out the plan on the…

Q: Example 3: Calculate the area of the following offsets are measured in the field at equal intervals…

Q: A triangular lot ABC has all points on a circle with radius 25m. AC, which is along the horizontal,…

Q: The calculated reduced levels for a longitudinal section of the current smoothly curved land…

A: Tabulate the distance and the reduced levels.To find: Area below the formation level of .

Q: In a certain portion of road to be constructed, the following data were taken. Station 1+020 8m 8.5m…

A: To determine: a) Compute area of first station. b) Compute area of second station. c) The value of…

Q: In a proposed highway undergoing road earthworks, the given roadway cross-section notes are as…

A: Given: STA 20+100 3-8.5 1.50 16.5 STA 20+ 300 2.2-7.7 1.20 2.68.10 The inventory of…

Q: Figure Q5 shows a series of six cross-sections taken at 20 m intervals for the earthwork of a…

A: By using the "Section Method", we calculate the volume of cut or volume of fill. In this method the…

Q: This question may be completed using a Close program on a graphing calculator where necessary. Using…

A: Given that,the road secants C-F and B-G, road lengths G-F and G-H.

Q: 3. In the figure below, two circular arcs were established to connect two road segments A and B. It…

A: Data Given: Asked: Appropriate control point Coordinates of point P

Q: From the following cross-s end-area method, the roa slope for both cut and fill i 5.04

Q: Station 4 + 940 Base= 8m; Side slopes= 1.5:1 1.84 1.22 0.42 Station 5 + 005 Base= 9m; Side slopes=…

Q: Calculate the area between the sidewalk/proposed surface and the existing surface shown by the…

Q: You have been instructed to join two existing roads by an even grade from point X to Y. Point X is a…

A: Given data:

Q: The grading works of a portion of the proposed expressway shows the following notes. Limits of free…

A: Understanding the center line and excavation drawings, laying out the plan on the ground, excavating…

Q: 54 4- 2 56 58 55 58 59 59 60 61 5 *55 60 62 63 64 63 64 65 66 65 67 3 5 B. Shown to the left is a…

A: Find the Volume of excavation by (a) Unit volume method (b) Parallel section method

Q: Highway curve has R = 800 m, I = 20° 00', and Pl station 3+290.600 m. ▼ Part A Determine degree of…

Q: +3 13.5 a 5+-020 +4.5 17.25 of the road is 12 m and the slide slope is 2.5:1 te the volume using end…

Q: The cross-section notes shown below are for a ground excavation for a 9m wide roadway. STA 22+400…

Q: Calculate the quantity of earth work for the road with the following: stations Depth of cut (m)…

A: The process of moving the earth by cutting and filling simultaneously for the construction of the…

Q: (b) A rectangular slab, simply supported along all four edges, is isotropically reinforced to give a…

A: A rectangular slap is isotropically reinforced and supported along all four edgesThe magnitude of…

Q: Calculate the quantity of earth work for the road with the following: stations 0 Depth of cut (m) 1…

Q: Calculate Ve, Cp and Vp for the following notes. The base in fill is 20 ft and the base in cut is 30…

A: Data given Base width, cut = 30 ft Base width, fill = 20 ft Find: Ve, Cp, Vp

Q: SOLVE THE DISTANCE AND BEARING OF LINE FA AND COMPUTE THE AREA OF THE LOT USING DMD METHOD.

A: Answer Let us first determine the latitude and departures of line FA We know that for a closed…

Q: In a proposed highway undergoing road earthworks, the given roadway cross-section notes are as…

Q: The cross-section notes shown below are for a ground excavation for a 10m wide roadway. STA 15+900…

Q: In the intention to construct a motorbike road, some surveying work has been carried out at the…

A: The proposed level at point 5 = 258.294 mThe proposed level at point 1 = 258.294 +400×1100…

Q: The given data off a proposed La Union - Baguio Road is tabulated below. The free haul distance is…

Q: The table below contains the cross-sections Areas of road Calculate the volumes of the earth work…

A: To calculate the Volume (total) -

Q: The cross-section notes shown below are for a Station 32+300 6.25 + 2.25 + 2.20

Q: similar mark on the second road. You are required to supply the site engineer wi cut and fill at 10…

Q: STATIOΝ CUT (m²) FILL (m²) 1+000 40 1+052 33 1+272 3.021 1+300 Balancing point 1+322 3.845 1+502…

Q: Determine the enclosed area of Lot 5, shown in the figure below. Also, compute the length of the…

A: Coordinate: Distance, ft Bearing AB 200 N 45 E AD 100 S 45 E DC 100 S 45 W CB 141.42

Q: The cross section notes shown below are for a ground excavation for a 10 m wide roadway. What is the…

A: Coordinates of the points are: Left Point = 8.2, 2.15. Center Point = 0, 3.5. Right Point = 13.65,…

Concept explainers

Highway Drainage

Highway drainage is the process of extracting and regulating the excess surface water on the pavement by giving the desired slope. The construction of a highway drain helps to divert the water present on the surface, and sub-grade by the means of slope. Highway drainage systems are a necessary part of smooth functioning of traffic, since the highway drainage systems provide proper disposal of unwanted substances from the highways.

Question

In a certain portion of road to be constructed, the following data were taken.
Station
20.00
6.85
+2.3
Station
6.0
+2.0
Base width for cut
+1.5
+1.2
1+
1+
6 m
6.39
+1.0
6.9
+2.6
70
Solve for the volume using End-Area method.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1 Introduction

VIEW

Step 2 Calculation of area for each station

VIEW

Step 3 Calculation of volume using end area method

VIEW

Step by step

Solved in 3 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A series leveling had been down along the center line of the road .The road must be started with the same ground level at first point and ending with the same ground level at last point with a uniform slope. Calculate the slope of * .the Grad station B.S I.S F.S HI RL 1+30 1.52 32.52 31 30.17 29.38 29.49 29.30 1+60 2.35 1+90 2+20 2+50 2+80 1.36 3.14 30.74 31.47 1.98 1.25 2.17 2.75 1.40 32.82 30.07 3+1p 0.87 31.95 slope= ( 5.3*103) O slope=( 5.3*102) O slope= (- 5.3*10-³) slope= ( 5.3*10) O
Draw the figure to illustrate your understanding of all the problems. Show complete formulas and solutions. Round off to 3 decimal places. At STA. 51+33 of a proposed road, the center height of the cross- sectional area is 1.4m in fill while the center height of the cross- sectional area at STA 51+93 2.8m in cut. The width of the proposed road is 14m with a required side slope of 2H:1V for both cut and fill. Determine the volume of cut and the volume for fill using the END-AREA Method. (All sections are level sections)
Given the following data from a differential levelling survey conducted in a certain road site, determine the Elevation of point 1 to 9. Station B.S (m) I.S (m) F.S (m) H.I (m) Elevation (m) B.M 0.597 68.233 1 2.587 3.132 2 1.565 1.911 0.376 2.244 1.522 3.771 1.334 1.985 0.601 2.002 3 4 5 6 7 8 9
From the given cross-section of the proposed barangay road. determine: a) The volume between the two stations using Prismoidal Formula b) The volume between the two stations using end area applying Prismoidal correction
Q6/ Below the elevation of points on the center of road project. If the D.L is start at elevation (25m) with ascending slope (0.5%). Find the heights of Fill and depths of cut for each points. с E F H I 100 150 200 250 300 350 400 25.7 25,2 24.8 26.6 26.8 27.2 27 60 28.0 Points A Dist. 0.0 C 26 B 50
Given the following cross section notes of an earthwork on a rolling terrain. The width of the road is 10 m. Sta 6 + 340 7.3 9.8 +4.5 +3.9 +5 Sta 5 + 741 7.6 9.6 +4.5 +3.4 +5.1 Solve for the volume by Prismoidal Formula (in m^3). Round off to two decimal places.
Q1/ Calculate the area of the following offsets measured in the field at equal intervals of 10 Offset hl Length 10.76 19.83 (m) Calculate the area using: 1. Trapezoidal Method 2. Simpson's method h3 h4 h5 20.24 18.59 16.76 h8 h9 h10 h6 h7 17.68 17.68 17.37 16.76 17.68