Q1/ Calculate the area of the following offsets measured in the field at equal intervals of 10OffsethlLength 10.76 19.83(m)Calculate the area using:1. Trapezoidal Method2. Simpson's methodh3h4h520.24 18.59 16.76h8h9 h10h6h717.68 17.68 17.37 16.76 17.68

Answered: Image /qna-images/answer/fda940fa-1068-4708-9584-a9aa62a3cd53.jpg

Q1/ Calculate the area of the following offsets measured in the field at equal intervals of 10 Offset hl h2 h3 Length 10.76 19.83 20.24 (m) Calculate the area using: 1. Trapezoidal Method 2. Simpson's method h4 18.59 h5 h6 h7 h8 h9 h10 16.76 17.68 17.68 17.37 16.76 17.68

Q1/ Calculate the area of the following offsets measured in the field at equal intervals of 10 Offset hl h2 h3 Length 10.76 19.83 20.24 (m) Calculate the area using: 1. Trapezoidal Method 2. Simpson's method h4 18.59 h5 h6 h7 h8 h9 h10 16.76 17.68 17.68 17.37 16.76 17.68

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: From the values of the magnetic quarter circular directions, find the value of the following…

A: From the given date it is required to find the angles given. DAE, EAB, BAD, CAE

Q: a) top most, lef tmost FIND: b) botton-most, right-most 3cm 0.5 r= 1.25 y 125 } 05 Vb cm 1.5 3 I 1.5…

Q: A. TACHEOMETRY 1. A transit is set up at a distance back of the zero end of a level base line 240 m.…

Q: A traverse is run to set out a line MQ-1900 m at right angles to given line MN. The lengths and…

A: ####Calculation of length and bearing of line PQ of closed traverse MOPQMUsing lat. and dep. Of…

Q: bearings and draw the traverse. Station Line Observed Bearing Difference Correction Remarks…

Q: In 1860 the magnetic bearing of a line was N 69 deg 27 min W with a magnetic declination of 5 deg 12…

Q: Direction: Show all pertinent solution and box your final answer. 1. Measurement of three horizontal…

Q: The distance between points is exactly 100 ft. This measurement is read correctly on steel surveyors…

A: To determine the actual distance for the measured distance. Given, Measured distance, say L =…

Q: The unrolled lateral area of a right circular cone is similar to a ___. a. Sector of a circle where…

A: The development surface of the right circular cone of lateral height l and base perimeter s is the…

Q: Question: 1.What is the adjusted bearing angle of Line DE, CD, EF, FG 2.What is the total length…

A: Solution line Length Bearing Difference Forward Backward Forward Backward in bearing reading…

Q: Q4- 16 Solve the following system of ODE dx dt = y + 1 Eaux"> dy dt =x+1

A: Given: dxdt=y+1dydt=x+1

Q: 1. Find the orthogonal trajectory of the following: a. x² + 4y² = C Ans. y = Cx4 Ans. y² + 2lncosx +…

Q: 1/7 For the velocity profile=A. calculate the shape factor H. %3D

Q: Determine the correct length of a line, 256.32 m long, measured using a 50 m steel tape at 38…

Q: Refer to the beam shown, 75 60 kN/m kN/m 2m 4m 3m 90 kN.m A B C For the beam shown, which of the…

A: Option can be chosen even without calculation as Point C will move in downward direction hence…

Q: Determine the magnitude of resultant and its direction measured from y axis if F8 = Go0 and O =20?…

A: Given, FA=700 NFB=600 Nθ=20°

Q: If the elevation of A (benchmark) is 45.074 m, formulate A, B, L and X matrices to adjust the…

A: Given:- The elevation of point A = 45.074 m The following leveling data is also given From To…

Q: X Compute the area bounded by the polygon A, B, C, D, E, F and the circular segment area bounded by…

A: Pointx, fty, ftA500500B1000600C15001100D13002000E7001800F3001000Angle theta =47o

Q: If d is the distance between equidistant odd ordinates, the Simpson's rule for the areas, is d/2[h1…

A: Given : d distance between ordinate To determine Simpson's rule formula for area calculation

Q: Ifr=h(4h3 – 5), find the percentage error inr ath=1, if the error in h %3D is 0.04.

A: Equation, r = h( 4h5 - 5 ) h = 1 error in h = dh = .04

Q: In tilted aerial photography, the relief .15 :displacement is computed from اخترأحد الخيارات a. The…

A: Relief displacement is the lateral displacement or drift in the photographic position of an image of…

Q: In 1860 the magnetic bearing of a line was N 69 deg 27 min W with a magnetic declination of 5 deg 12…

A: Given data in question Manetic bearing in 1980 = N 69°27` Declination in 1980 and present = 5°12`…

Q: To mitigate the closing error, sum of latitudes and departures mu equal to zero. O a. True O b.…

Q: Please enlighten me on how did they get those values that I encircled. Thank you very much! I'll…

A: The encircled value of 91.8 kN has come from the concentrated load 34 kN at point B.

Q: If d is the distance between equidistant odd ordinates, the Simpson's rule for the areas, * is…

A: Given: The d is the distance between the equidistant odd ordinates. In Simpon's rule for the area,…

Q: QIA) The following are the bearings observed in traversing. Calculate the interior angles of the…

Q: Determine the magnitude of resultant and its direction measured from y axis if FB= Goo and O =20.?…

Q: Problem #1: Leveling in a loop Leveling is performed to determine elevations on the ground and…

A: Given: Station BS HI FS Elevation J A 319.83 315.76 TP1 5.18 322.87 2.14 B TP2 2.91…

Q: Using Moment Area Method, determine the deflection at the point of application of the couple. 1200 N…

A: Given data:

Q: If d is the distance between equidistant odd ordinates, the Simpson's rule for the areas, is d/2[h1…

A: To determine the formula of Simpson's rule.

Q: The observed lengths of the sides (in feet) of a five-sided closed polygon traverse are as follows:…

Q: What is the fiction angle of slice 3 in the figure bleow ? a. 25o b. 26o c. 27o

A: Given data:

Q: If d is the distance between equidistant odd ordinates, the Simpson's rule for the areas, is d/2[h1…

Q: 1. Compute for the value of the resultant and the angle. 360 N 50° 95 N 20° 220 N

A: Compute for the value of the resultant and the angle.

Q: Given the figure below, assume that the E-200 GPa and I = 60x10 mm. Determine the following. A B FL…

A: Given:Required:Deviation of C with respect to tangent drawn from ASlope at ADeflection at CNote: As…

Q: LENGTH (m) OBSERVED BEARINGS (QBS) LINE FORWARD BACKWARD FORWARD ВАCKWARD D D AB 560.00 560.10 N 45…

A: Local attraction has no effect on the included angles. So first find included angles

Q: Problem 2. Calculate the area of the closed traverse or field in square meters (using coordinate…

Q: Assume that wo = 64 N/m, L = 6 m, and El is constant for the beam. Find the slope at the midpoint x…

Q: Problem 2. Calculate the area of the closed traverse or field in square meters (using coordinate…

Q: 4.A base line was measured by tape suspended in catenary under a pull of 145N, the mean temperature…

A: The pull at the time of observation is P=145 N. The temperature at the time of observation is…

Q: In chain and compass traversing, the magnetic bearings of the survey lines are measured by a ___?

A: During chain traversal, measurements can only be made along linear paths.So either chain or tape…

Concept explainers

Surveys of public lands

A survey is a method used to determine the relative positions of various objects on the land by measuring the horizontal distances between them. Briefly, a survey is a process of accumulation of data of various details related to land. The main objective of surveying land is to prepare maps to a suitable scale. Various types of maps such as topographical maps, cadastral maps, engineering maps, military maps, contour maps, geological maps, archaeological maps, and so on can be prepared by surveying.

Question

100%

Q1/ Calculate the area of the following offsets measured in the field at equal intervals of 10
Offset
hl
Length 10.76 19.83
(m)
Calculate the area using:
1. Trapezoidal Method
2. Simpson's method
h3
h4
h5
20.24 18.59 16.76
h8
h9 h10
h6
h7
17.68 17.68 17.37 16.76 17.68

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Using the deflection angles shown, calculate North azimuths and Bearings of the lines. Show your complete solution. LINE BEARING AZIMUTH, A -B Nor th 113 40 Right B-C AZ = 150 6T Right C-D D-E E-F South 113 40' Left 46 30 Left
Q2) a.) Find the intersection coordinates of lines passing from AC and BD. b.) Find the area defined by the corner points A, B, C, and D. The Lengths in the below given figure are in meters. Use Gauss Method only. 17.42 B e----165.05 37.15 55.98 Yp Хр 39.47 22.75L D ol4.90 i 13.90 A 0.00 ty
H.W13/ The following offsets were taken from a chain line to a hedge: Distance (m)0 10 20 30 40 80 120 160 200 210 220 Offsets (m) 21 15 16 22 Compute the area between the chain line and the end offsets by: (a) Trapezoidal Rule. (b) Simpson's Rule.
Azimuth Azimuth Fraction) Length Degrees Minutes Seconds Line 10047 86.99 100 28 AB 44 186.18 186 10 BC 259 89 0.00 CD 100.11 125.32 115 12 44 115.21 DE 323 10 323.17 EA 284.548 SUM 856.858 7. Determine the FGCC dassification of the angle measurements in the problem shown here. Interior Angles Degrees Minutes Seconds 80 28 86 10 44 100 01 215 12 4. 58 3. 18 SUM 69
Determine the slope and displacement at the internal hinge C using virtual work method. EI is assumed constant. Please do it in text form . dont upload images
An engineer's level with stadia constant of 0.30-m was set up on the line between A and B, the following crosshair readings were observed. If the stadia interval factor of the level is 100, determine the length of line AB.
A horizontal angle is measured five times, and the results are as follows: 156 45 34, 156 45 38, 156 46 30, 156 45 29, 156 45 32 The standard error of the measurement is most nearly A. 8" В. 3" C. 14" D. 4" B.
B1
10 - 12 please give the correct answer
Surveying
PROBLEM: A straight railroad AL intersects the curve highway route BC as shown in the figure. Distances on the route are measured along the arc using the data specified. Find the stationing at the point of intersection "P" of the railroad and the highway curve. (USING STA C) Figue R= G00m T-180 Given: Sta V= 10 +019. 20 T= 104° %3D IT R= GOO M I 104 120 m
The accompanying schematic arrangement of line portray a differential level route. Th values indicated represent back-sight and foresight readings taken at different points as labelled. Prepare the complete differential level notes for the information shown and the customary arithmetic check. STA. BS HI FS ELEV. BM1 2.35 356.65 TP1 1.37 3.28 TP2 3.08 2.04 ТРЗ 1.54 3.61 ТР4 0.85 3.69 BM2 3.07 Arithmetic Check: Elevation BM1+(SUMMATION OF BS) -(SUMMATION OF FS) =BM2 A. Height of the instrument at TP4. B. Elevation of TP4. C. Difference in elevation of TP1 and TP4.