If the three inductors in Question 5 were connected in series, what would be the inductive reactance of the circuit? Assure the inductors are connected to a 60-Hz line. Question 5. Three inductors are connected in parallel. Inductor 1 has an inductance of 0.06 H; Inductor 2 has an inductance of 0.05 H; and Inductor 3 has an inductance of 0.1 H. What is the total inductance of this circuit?

A 100 µF capacitor is connected across a 240 V, 60 Hz source. Determine: the capacitive reactance, in ohms. the current, in amperes

3. What is the effect as more inductors are added in parallel to a circuit? A. Increased total inductance. B. Increased total inductive reactance. C. Increased total resistance. D. Increased total circuit current.

A capacitor that is connected parallel to the inductor is added to the circuit image below to correct the power factor to unity. What would be the rating of the capacitor (answer should be in VARs) Thank you !!

AC Circuits Sine-wave generator f- 25 kHz V₁ = 3.0 V VR 888 100 mH Figure 6-Test Circuit 3. Using a two-channel oscilloscope, measure the peak-to-peak voltage VR across the resistor and the peak-to-peak voltage VL across the inductor. Measure the voltage across the inductor using the difference technique described in a previous experiment. Record the voltage readings in Table 2. VL 10 k 1 XL Table 2- Measured and Calculated Values (f = 25 kHz) ZT

show the complete solution for this problem, thanks!

QUESTION 9 E-06, PC-02. Three inductors 5 mH, 15 mH and 25 mH are connected in series. What is the total inductance? 5 mH. 45mH. Without knowing the coupling factor the total inductance cannot be found. QUESTION 10 E-06, PC-05. An inductor is said to be saturated when? The current through it is zero. The current is at a maximum. It will no longer accept lines of flux.