If the irrigation efficiency is 80%, conveyance losses are 20% and the actual depth of the watering is 16 cm, the depth of water required at the canal outlet is

Q: 400 Kgim B -6 m 10 m 45"

A:

Q: Imagine that you are an architect. As an architect, you were tasked by your client to make a cost…

A: In which readings are taken between two points of both directions to reduce the error. if two-point…

Q: Explain the term Cunningham correction factor.

A: Cunningham Correction Factor (C): In dynamics of fluid, the Cunningham slip correction factor is…

Q: What is Groundwater? What is its importance, elaborate and explain.

A: In simple term groundwater is the water which gets infiltrate into the soil through the pores…

Q: Define Thomas (1968) method of calculation of consolidationsettlements ?

A: Thomas (1968) calculate the consolidation settlement using  same expression as that of DeBeer and…

Q: 3.05 0.2 6.5 3.1 Figure 2.5.5 - Question 5 (Revised) Inside perimeter Outside perimeter Centreline…

A: Outside perimeter = 6.5+6.5+3.1+6.5-1.35+2.75+6.5+3.1+2.75+1.35 Outside perimeter = 37.7 Inside…

Q: Distinguish between free float and total float?

A:

Q: 32 3" fo=3000 ps fy= NWC = Mn=?, Tied bars. 28 = 60 ksi 多#9 14

A:

Q: Construct the PERT Net work for the datE shown below and determine the expected finish date R…

A:

Q: In what order are dimensions entered onto the takeoff?

A: Dimensions are usually set down in order of horizontal length, horizontal width or breadth, and…

Q: What is Dimension D? Setback = 0.252, Bend Allowance = 0.345

A: The given values are as follows,The set back =0.252The Bend allowance=0.345To determine The…

Q: Q.No.01. Define the four phases of project life cycle.

A: These are the Four Phases of project life cycle- (1) Initiation (2) Planning (3) Execution or…

Q: Define the assumptions of Boussinesq Equtions?

A: This equation is to predict the amount of stress over the material. It predicted the stresses in an…

Q: the excavation works include Select one: a. filling works b. cutting works c. disposal d. all the…

A: Excavation work includes

Q: FACILITIES The Department of Foreign Affairs Government Service Insurance System. Return Service…

A:

Q: Define the term Drainage.

A: Drainage is defined as an artificial process of removing excess water from surface and sub-surface…

Q: Draw Arrow Diagram (Activity-on-Arrow, AOA). Activity Depends on Activity Depends on В, С, Е F, G A…

A:

Q: Explain - Explain why groundwater is more difficult to clean than surface water.

A: Groundwater and surface water are two primary sources of fresh water on our planet. However, they…

Q: What is the partial utilization?

A: Partial utilization is usage of a significantly completed part of the work by owner for the purpose…

Q: Describe the two methods of computing retainage?

A: Retainage or Retention is the withholding of a portion of each progress payment which is earned by…

Q: Differentiate land preparation from tillage for farming?

A:

Q: Determine height of 2nd floor of proposed residential apartment building from figure 1 below, as…

A:

Q: Define Earth surcharge loads

A: Surcharge can simply be defined as additional or in extra.

Q: Define Settlement loads

A: A settlement is the ground's downward movement whenever a load applied to it.

Q: Define the term Well Points.

A: A wellpoint is a well of small diameter used for dewatering.

Q: What types of conduit are in general use?

A: Types of conduit that are generally used are Rigid Metal Conduit—RMC and IMC. Electrical Metallic…

Q: What value is normally taken for Retention?

A: In US retention id generally known as Retainage.

Q: How MANY UNKNOWNS RESTROWTS MF thErE

A:

Q: Explain about the Land Drainage method.

A: Drainage is a process in which the excess water from the field by means from the field. It is very…

Q: Define river deposits.

A: Deposition is the processes through which material is deposited being transported by a river.

Q: What is the PreProposal meeting?

A: Pre-proposal meetins:

Q: State the functions of docks. Compare floating dock and dry dock.

A: Answer:- Docks;-- Docks are enclosed areas for berthing ships, to keep them afloat at a uniform…

Q: Two level sections of 35-m stations have center heights of 1.39 and 1.56 m in cut, base width 15 m,…

A:

Q: 2. ) Compute area of the parcel below. <-5.0 -19,7 0,0 -15,0 0,0 15.0 -4.6 17,0 --3,2 18,4

A: The given figure is shown below:

Q: abel an earth dam

A: The successive layers of earth when piled together to form core and the upstream and downstream…

Q: Station Cut End Area (ft2) 10+00 240 11+00 362 12+00 443 13+00 406 14+00 261 15+00 101 For the…

A: Given data - Length (L) = 100 ft Find out - Calculate the volume of excavation between stations…

Q: What equipments are commonly used in construction (excavation, etc.)? Please indicate for what…

A:

Q: what is possible grade of service value ?  a.  -1 b.  3  c. 0.1  d. 1.1

A: Brief concept- Grade of Service (GOS) - It is the category of service and comfort that is provided…

Q: Compute the volume of excavation betw

A:

Q: The parents want to subdivide their inner lot into two equal area for their two sons such that the…

A: Surveying is the major measuring branch of civil and for designing the proper planning and leveling…

Q: What is the principle on which well-point dewatering is based?

A: Introduction:- In this method wells are drilled around the excavation area with submersible pumps…