Answered: If a 40-Ω R is in series with a 30-Ω Xc…

If a 40-Ω R is in series with a 30-Ω Xc across a 100 V sine wave ac source, calculate: a) impedance, b) total current, c) the voltage across R and C, d) phase angle of the circuit.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.7P: Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor,...

See similar textbooks

Related questions

Q: A load of 40 -j 30 is connected to a source of 100 V with a phase angle of 300, through a…

A: Reactive power- Reactive power is the part of complex power that corresponds to storage and…

Q: 13. A 40 Q resistor and a 10 mH coil are in parallel across an 80 V, 500 Hz ac line. Find the (a)…

Q: The line-to-line voltage of a 4 wire three phase star connected system is 32KV. The magnitude of the…

A: The solution can be achieved as follows.

Q: The following information are given in the circuit shown: R = 250 ohms, L = 1.2mH, C = 1.80µF and V,…

Q: In an alternator delivering lagging pf load, the excitation emf leads terminal voltage by the power…

Q: Given a star connected system with power factor of 80 percent, true power of 2,500 kW and phase…

Q: 2n jsn v joa

A: Given, We have a circuit with energy storage elements . We have to find V2 by using nodal analysis.…

Q: In a circuit, the equation for resistance voltage and current are given byv = 141.4 sin (wt – 4) and…

Q: Three Impedances each of (8 – j22)N are connected in mesh across a three-phase 400V ac supply.…

Q: II. Problem Solving A 400 resistor is connected in parallel to a coil having a resistance of 102 and…

A: We need to find out current for given circuit

Q: Q27/ (b) Three Impedances each of (10 – j18)Ω are connected in mesh across a three-phase 425V ac…

A: Given Supply line voltage Vline=425 V Z1=10-j18 ΩZ2=10-j18 ΩZ3=10-j18 Ω The phase voltage is,…

Q: Three Impedances each of (12- j16)N are connected in mesh across a three-phase 410V ac supply.…

A: we need to determine phase current line current real power reactive power

Q: 34. A 200- ohm resistor, 130 millihenry inductor, and a 66 microfarad are placed in a parallel…

Q: The power was taken by a C–R series circuit, when connected to a 105V, 2.5 kHz supply, is 0.9kW and…

A: Electric power Elecric power in DC circuits can be defined as voltage multiply by current. This…

Q: 18. A network has a total impedance of Zr = 24.0 kn/-30° at a frequency of 2 kHz. If the network…

Q: For the circuit shown in figure 1, calculate the equivalent impedance of the network, assuming a…

Q: 13. A 40 Q resistor and a 10 mH coil are in parallel across an 80 V, 500 Hz ac line. Find the (a)…

Q: For the admittance locus diagram shown below: find the value of each element in the circuit if w=377…

Q: Three Impedances each of (12 -j18)N are connected in mesh across a three-phase 420V ac supply.…

A: According to the given question, it is required to determine the below given parameters for the…

Q: 2. Explain why Phasor and impedance diagrams have the same angles. 2 II/L of Phacon shift if D 2000…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: decimal places and box thefinal answer. The instantaneous voltage and current for an ac circuit are…

A: We need to find out impedance and power for given current and voltage

Q: In a Y-connected ac generator, each phase voltage has a magnitude of 135 VRMS, then the magnitude of…

A: Given: A Y-connected ac generator has, Phase voltage, Vph=135 V.

Q: The instantaneous values ofthe voltage across a two element series circum and the current flowing…

Q: PROBLEMS : A 130- v OLT 50-CYCLE S OURCE CONNECTED TO SERIES CKT. CONSISTING OF A 402 RESISTOR AND…

Q: Circuit Impedance Z = (Ω) Phase Angle =arc cos R/Z= Calculate Es = (V) Calculate Ec=(V) Calculate Er…

Q: a) Find the total impedance? b) What is the r.m.s value of the voltage source? c) What is the phase…

Q: 4Ω ww- ell Determine the load impedance that z, maximizes the average power drawn from the circuit.…

A: For dc source the maximum power transfer states that maximum power is abstract by load resistance if…

Q: 12 2 V V 310

Q: Reactance of a circuit is always expressed as real number and comprised the imaginary part of the…

A: In the question, Choose the correct option. Impedance Z= R+jX Where R resistance X Reactance

Q: Three identical coils, each of resistance 20 Ohm and inductance 191 mH are connected in start a…

A: consider the given question;

Q: A 400 N resistor is connected in parallel to a coil having a resistance of 10 N and an inductance of…

A: Given: vt=35sin50t V a) Calculate instantaneous and phasor current across the 400 ohms:…

Q: 10Ω 5 mF 20 mH Vs= 100sin(200t+30°) volt Calculate the impedance, current, VR, VLand VC. Draw the…

A: In this question, RLC are in series, Find the impedance, current and voltage across each element.…

Q: An AC circuit with R, Land C in parallel, has the following branch currents. Resistive branch - 12 A…

A: The solution can be achieved as follows.

Q: 5: A 220 Kv 50 Hz three phase transmission line consists of 1.4 cm radius nductors spaced 2 m apart…

A: Given, 3 phase transmission line, VL = 220 kVf =50Hzr=1.4 cm d=200cm…

Q: RA 27 Q Ris in series with 54 2 of X and 27 2 of Xc. The applied voltage Vis 50 mV. Calculate total…

A: To solve above problem, one should have basic idea about working of AC circuits. Above given circuit…

Q: . The relation between impedance and admittance locus is Opposite Mirrored Inversely Reciprocally

A: Impedance is reciprocal to admittance

Q: II. Problem Solving A 400 resistor is connected in parallel to a coil having a resistance of 10 and…

Q: Figure below shows a simple single-phase AC power system with three loads. The voltage source is V =…

A: Kirchoff's voltage law is an important method to solve big and complex circuits. According to KCL,…

Q: 5. Three impedances of (1+j5)N, (1+j12)N and (2+j3)N are connected in star to a 3-0 system with line…

Q: 1. A series AC circuit consisting of R = 200 2 and L = 320 mH are connected across V = 20 VL0°, 100…

A: 1) For a series AC circuit consisting of R and L Determine the following : Inductive reactance,…

Q: Circuit Impedance Z = (ohms) Phase Angle = arc cos R/Z = (°) Calculated Is = (A) Calculated lc = (A)…

Q: For the AC network shown in Figure 3, the source voltage is 120V (RMS). 492 -j6 Q 120/10° V ZT ΖΩ…

Q: Problem 6 (AC Power Analysis) Find the complex power (S), apparent power (S), real power (P),…

A: In this question, In this circuit, find the complex power, apparent power S, real power P and…

Q: • An overhead 3-phase transmission line, which has phase voltage 30 kV, is hanging from a three…

Q: QUESTION 2: For each of the following, determine the impedance of the circuit element. (Hint: By…

A: The impedance of the circuit can be determined by ohm's law imedance(z)=VI ohmImedance(z) = R+jX…

Q: Problem: For the cct shown draw the phaser diagram. 60 Q VR VL 14 V = 220 Sin 314 t

A: We need to draw phasor for given circuit

Q: Given a mesh connected system with reactive factor of 60 percent, true power of 2,500 kW and phase…

A: A network in which devices or nodes are linked together, branching off other devices or nodes known…

Q: For the series Ac circuit if e(t) = 6 sin(314t + 60°) : 1) Determine ZT 2) Draw the impedance…

A: Disclaimer: Since you have asked multipart questions, we will solve the first three subpart for…

Q: An AC series circuit has R= 300N, L = 0.90H, and C = 2.0µF with a generator of 50V and w = 1000…

Q: A three phase motor draws 30 kVA at 0.80 power factor lagging from a 480 V three phase generator. It…

A: In this question we need to find a capacitor bank rating use to increase the power factor from 0.8…

Question

If a 40-Ω R is in series with a 30-Ω Xc across a 100 V sine wave ac source, calculate: a) impedance, b) total current, c) the voltage across R and C, d) phase angle of the circuit.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

When a resistor is connected across the terminals of an ac generator (117 V) that has a fixed frequency, there is a current of 0.332 A in the resistor. When an inductor is connected across the terminals of the same generator, there is a current of 0.365 A in the inductor. When both the resistor and the inductor are connected in series between the terminals of this generator, what is (a) the impedance of the series combination and (b) the phase angle between the current and the voltage of the generator? Note: The ac current and voltage are rms values and power is an average value unless indicated otherwise. (a) Number (b) Number Buda i Vrms R Irms.R Circuit 1 Units Units Vrms. Irms, L Circuit 2 > L Vrms R www Circuit 3
an ac circuit has a frequency of 400 hz. a 16- ohms resistor, a 0.0119-h inductor, and a 16.6- uf capacitor are connected in series. If the voltage connected to the circuit is 440v. How many degrees are the voltage and current out of phase with each other?
A 220 Ω resistor is in series with an 80 mH inductor. The AC source is 48 at 1 kHz. The power factor is ________. Hint: Draw the circuit and get Vs and Is
A circuit consists of an AC voltage source, a 10-ohm resistor, and a capacitor, all connected in series. The magnitude of the impedance of the capacitor is also 10 ohms. Which of the following is true about the phase angle difference between the source voltage and the current through the circuit? a. Insufficient information is given. b. The phase angle difference will be zero degrees. c. The phase angle difference will be 45 degrees. d. The phase angle difference will be 90 degrees.
1) Two identical voltage waveforms of difference phase angles are shown in Figure B. Write down the expression of waveforms A and B clearly. HUS Voltage (V) 8 0 K/N B 7: ST ot
Impedance of AC circuit and Admittance of AC circuitSHOW THE CIRCUIT USING ANY SOFTWARE OR YOU CAN DRAW IT MANUAALYY thNAKSS
supply 3. Three circuits A, B and C are connected in series across 350 V supply. The voltage across circuit A is 80 V lagging the voltage by 330 and the voltage across circuit C is 140 V leading the supply voltage by 48°. Determine the voltage circuit B and its phase displacement from the supply voltage using wave and vector solution. across 4. Draw the phasor and wave diagram of the following sinusoidal current:
Two impedances consist of resistance of (15 ohms and series connectedinductance of 0.04 henry) and (resistance of 10 ohms, inductance of 0.1 henryand a capacitance of 100 microfarad, all in series) are connected in series andare connected to 230 volts, 50 – Hz AC source. Find: (a) current drawn, (b) voltageacross each impedance, (c) individual and total power factor. Draw the phasordiagram.
4) AC circuit analysis is performed as it was in DC except A) one must use phasors for the voltages and currents and use complex numbers for Impedance. B) one must use phasors for the impedance. C) complex numbers for the V/I ratio are used to represent the power. D) None of the above
1. A load of 50 ohms resistance and 0.4 H inductance are connected in series to 100 volts, 60 hz a-c source. What must be the value of the capacitance to be connected in parallel to the circuit to raise the power factor to 0.96 lagging. Draw the circuit diagram.
A Star 3Phase source with phase voltage of 400V at 50HZ is connected to a delta connected 3Phase AC Motor. The transmisson line resistance from source to load terminal is 1 Ohm. The internal resistance of each winding of motor is 9 Ohm and the inductance of each coil is 38.2 mH. What is the true power delivered to load? O A) 15999 B) 14999 C) 13999 O D) None
Two impedance coils A and B are connected in series to a 111-volt ac source. Coil A has a resistance of 12 ohms and an inductive resistance of 16 ohms. Coil B has a resistance of 24 ohms and an inductive reactance of 10 ohms. Calculate the voltage drop across each coil. Only in rectangular form