I1 j42 I4 220°A I2 I3 j22 DA,0979 all

Q: 3. What is the rms value of a square wave with an amplitude of 10 A and a frequency of 1 Hz? A sinus...

A: The solution is given below 

Q: 6- Find z transform of the signal x(n) which x[n] =(%)" sin(¾n)u[n]

A:

Q: Draw a schematic (circuit) diagram of four resistors connected to a source (EMF), where should have ...

A:

Q: 5. Indicate how a NAND gate can be used to implement: (a) Inverter or NOT Gate

A:

Q: 10.5: For the circuit shown: 1. Find the Z-Parameters? 2. Find the Y-Parameters? (Ans.: Z11=200, Z12...

A:

Q: Q1) By using Thevenin theorem find IL ? 40 11 12 IL 12 v

A:

Q: 3) Using superposi hon principle to find v and the power dissipated by the 32 resistar 12 V (오 (^)6A

A:

Q: 120 2 12 2 50 V +. 80 2 C The time constant for the RC circuit is S.

A:

Q: Draw the logic diagram for the following functions, then map it using NAND only technology and NOR o...

A: as per our company guidelines we are supposed to answer ?️only first 3️⃣ sub-parts. Kindly repost ot...

Q: An iron ring has a length of 60 cm and cross section of 4 cm^2. If the field strength is 1.5 T, find...

A:

Q: INSTRUCTION:USE 5 DECIMAL PLACES A parallel RLC consists of , RL = 150, XL = 30, RC = 100, XC = ?, E...

A:

Q: ..What is open loop power what underlying assumption is it based? 2.What is closed loop power contro...

A:

Q: Explain any one type of DC generator with neat diagram.

A: DC GENERATOR: 1. 1. A DC generator or the direct current generator is indeed a revolving equipment t...

Q: Instead of rectangular plates, you were tasked to create parallel capacitor plates of circular shape...

A: Given,  Circular plate capacitor having  Capacitance  (C)  = 3.77 uF Distance between the plates (d)...

Q: Figure 2-18 shows a one-line diagram of a small 480-V industrial distribution system. The power syst...

A: WYE connection: If we connect together one side terminals of the poly-phase winding, a WYE connectio...

Q: 16. Find the value of impedance which absorbs a complex power of 2300 VA with a 30 degrees angle at ...

A:

Q: Determine the range of Vi from the given figure. (MINIMUM VALUE) 2. Determine the range of Vi from...

A:

Q: Plot the forward and reversed zener current and zener voltage based on the measured values from Tabl...

A: According to the question, we need to plot the graph based on the following data as shown below

Q: 4. If the Z-matrix of a two-port network is Z = 1 then find Y12 and Y22 7 2 3

A: Given Z-matrix Z=4123

Q: A 4 pole, 500V shunt motor has 720 wave connected conductors on its armature. The full load armature...

A: The solution is given below 

Q: Determine Vo and ID for the network. * Va Si 10 mA 2.2 ΚΩ 2.2 kl O 8.13V, 5.32 mA O 10V, 2.2mA O 7.5...

A:

Q: 2. Reduce the following block diagrams to canonical form and determine the transfer function C/R. Ex...

A: Given block diagram can be solved using Mason's gain formula or graph theory.

Q: [9] Write the Boolean expression for the circuit that corresponds to the followin input/output table...

A:

Q: Answer the question briefly. 1. What is Inductance and inductor? 2. What is Capacitance and capacito...

A:

Q: Answer number 18.write your solution pls

A:

Q: Determine the power supplied by the leftmost element in the circuit

A: Given circuit,

Q: What must the voltage at the inverting input of the op- amp be? What is the voltage drop across Rin?...

A:

Q: In the equation Vm = V - ZI, V = 100 volts, Z = 10 ohms and I = 8 A. Express Vm in polar form. 50.5/...

A: Please refer the attached images for the complete answer..

Q: 5.0 × 10¯° kg In Fig. 23.15 a dust particle with mass m = 5.0 µg and charge qo a straight line from ...

A:

Q: Solve the Eth and Rth using Thevenin's Theorem

A:

Q: ) use nodal anulysis to find the cuirent i, 5 A (T 152 个 www

A: Mark the node voltages and write the nodal equations and solve them to get values of node voltages

Q: 1. An AM signal consists of a 10-MHz carrier modulated by a 5-kHz sine wave. It has a maximum positi...

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you ar...

Q: 6. A two-element series circuit with R = 150, L = 20 mH has an impedance of 30 ohms and an unknown a...

A:

Q: . A battery charger meant for a series connection of ten nickel-cadmium batteries (total emf of 12.5...

A: (a) Consider the relation between the turns and the voltage of the transformer is, V1V2=N1N2

Q: < Notes Done How many GPS Satellites are present?

A: GPS satellie is used to circulate the earth it circulates the earth two times in a single day a uini...

Q: 1. What is the equivalent of the decimal number 0.45 to binary (up to 6 bits precision)? Just type i...

A:

Q: Gven : ine system snown 400 customers at 500 KWh/month LOAD 1 600 customers at 300 KWh /month Power ...

A:

Q: VDD = 16V, RG = 1M-ohm, RD = 1500 ohm, RS = 750 ohm, IDSS = 10mA, VP=-4V a)Determine the drain curr...

A: Given  VDD=16 V,RG=1 MΩ, RD=1500 Ω ,RS=750 Ω,IDSS=10 mA,VP=-4 v

Q: Using re model, compute for the AC characteristic of below circuit. (Zo) 15 V 10 ΚΩ 45 k2 21 k2 10 μ...

A: We need to find out output impedance for given circuit

Q: 4) In the circuit given, find a) Theuenin equivalent to the right of line cd b) Thevenin equivalent ...

A:

Q: A 29.5 cm long straight wire carries 118 A and lies perpendicular to a uniform field of 5,900 lines ...

A: We need to find Power for given current and magnetic field

Q: Given a periodic signal in the picture below: determine: 1. the fundamental period of the signal T...

A: As per the guidelines of bartleyby I need to answer first three subparts only.So kindly repost other...

Q: The time constant for the RC circuit

A:

Q: What do you mean by over modulation?

A:

Q: Calculate the current taken by a 100microfarad capacitor when connected to a 200V, 100Hz supply. A. ...

A: The solution is given below 

Q: 7. Fourier Series is used to solve for a. Harmonic Forcing input b. Perioic excitation C. Transient ...

A: Note: As per the policy we can solve only one question, please re-upload the remaining question as a...

Q: Q2. Refer to the circuit as shown in Figure Q2 and assume that the circuit has reached a steady-stat...

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you ar...

Q: An induction motor OF 30 HP, 220 V, 450% of the rated current with the rated voltage and delivers du...

A: During starting of induction motor we have following formula: TstTf=IscIf2sf1.3TfTf=4.5IfIf2sfsf=1.3...

Q: Which of the following PAL schematics has the correct connection points included (i.e., the X's) to ...

A: X is indicating the particular connection that is taken as input for the particular logic gate. Ther...

Q: a) Calculate the output voltage vout using (i) Simple Circuit techniques for the circuit shown. (b) ...

A:

Nodal Analysis

In the analysis of any electric circuit, nodal analysis is the method of determining the potential difference or voltage between different nodes in an electric circuit. A node is a point where two or more branches connect each other. In the nodal analysis, the voltages are determined in the terms of branch currents. The nodal analysis is also known as the node voltage method or branch current method. The nodal analysis method is one of the several applications of Kirchhoff's Current Law (KCL).