How does an energy storage device which provides instantaneous power supply work? Explain with a out the characteristics and neat sketch. application of this device.

Q: What isolated switching mode power supply should be used and what would ripple voltage and ripple cu...

A: SMPS-Switch mode power supply. It is a device which is used to switch at high frequency and works as...

Q: Figure below shows a negative feedback system. The open loop gains of amplifiers are given as follow...

A:

Q: If we can hear sounds whose amplitude goes from 1 to 1 million in steps of one. With how many bits c...

A: As per our guidelines we are supposed to answer only first question. Kindly repost the other questio...

Q: 1. For the network of Fig, 1, determine: a) Vg=. b) IDa c) VgSq d) Vpsq e) Vp =- ) Vs = 2. For the n...

A:

Q: Two resistors with resistances of 10 Q and 23 Q are connected in parallel. The parallel combination ...

A:

Q: Maximum overshoot (Mp) multiplies by 100 as the percentage of [...] O steady-state response and maxi...

A: Answer: steady-state response and maximum overshoot   a. It is a valid option. Peak overshoot is rep...

Q: Basic: Write the currents on the following ammeters. 2. 3. A) 0 30A A)045A A)o 15A

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you ar...

Q: byDesign Calculate the total resistance and current as well as the voltage drop across each resistor...

A: As per our guidelines we are supposed to answer only first question. Kindly repost the other questio...

Q: The potential difference of an energy source that provides 50 mJ of energy for microcoulomb of charg...

A: Given, Energy, W = 50 mJ Charge, Q = micro-coulomb = 1×10-6 C

Q: Figure Q1(c) shows a 4-bit digital-to-analogue converter of type R-2R ladder. Given the converter ha...

A:

Q: Let J-10y zax – 2x?yay+2x'zaz a) The total current crossing the surface z-3, 1 sxs2 1 sys2 b) The ma...

A: It is given that: J=10y2z ax-2x2y ay+2x2z az

Q: Convert 100 Hp into its equivalent Watts.

A: 1 hp is equal to 745.7 watt. Therefore, 100 hp will be equal to, 100 hp = 100×745.7=7.457×104 W

Q: A 60 Hz voltage of 230v effective value is impressed on an inductive of 0.265H. a.) Write the time e...

A: In this question, We need to 1. Write the time equation for the voltage and the resulting current.  ...

Q: Label the terminals of the transformers in Figure 3 according to their proper polarity markings.  ...

A:

Q: Electrical

A: Answer Analysis of Electrical Failures: Failure analysis is the process of collecting and analyzing ...

Q: 1. у(п — 1) + у(п) —D и(п). 2. У(п — 2) — у(п - 1) + y(n) — 8(n — 1). 3. у(п + 1) — 3у(п) — 0. where...

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub parts for y...

Q: With suitable illustrations explain the principle of operation and working of Moving Iron instrument...

A: Moving iron instruments In moving iron instruments, deflecting torque is proportional to the square ...

Q: Exercises 1. - 2. -

A: The given data represent the connection between the line bulb and the switch as a refer data for the...

Q: an electronic warning system has a switch labelled A and two side panels labelled B and C. the outpu...

A:

Q: What is the height of a communications antenna required to cover a distance of 100km if it operates ...

A: Antenna- Antenna is used to transmit or and receive signal which are propagating wirelessly.  

Q: an FM broadcast transmitter, the carrier signal is being deviated between 103.505MHz and 103.495MHz,...

A: We need to analyse the given frequency modulation signal .

Q: Direct current (DC): Alternating current is that varies sinusoidally with time It is a current that ...

A: alternating current is current which is always varies with time  where as direct current is the curr...

Q: customer has four feeder circuits of 220 V, three-phase. The circuits have maximum demand as follows...

A:

Q: Wheatstone Bridge Experiment: A galvanometer is used as a: a) current source b) voltage source c) nu...

A: Given is an Wheatstone bridge  We need to find the use of galvanometer

Q: An inductance of 0.106 Henry is connected to a 120-volt 60-cycle source. Calculate (d) the maximum p...

A:

Q: 8- Find Thevenin equivalent across ab then Calculate RL if the variable R is adjusted to give maximu...

A: For finding Thevenin's resistance, open circuit the current source. Circuit becomes after removing l...

Q: Good,answer. I know this equation used for calculate to electric field in x-component, so there is a...

A:

Q: w Coils, one with 3500 turns and anothes with us00 tuons, ane Coected in Sach a way -that 60 % of he...

A: Mutual Inductance The interaction of one coil's magnetic field on another coil as it induces a volta...

Q: 1.) a)Determine the type of DC Machine that can be utilized in a crane on the basis of the character...

A: DC machine: This is a machine that produces DC quantity. This may be a generator or a motor.

Q: If the thickness of the insulating material in the problem with code COFFEE is increased by 30%, wha...

A: Insulation of wire is required to insulate the wire when it is in operating condition. It is essenti...

Q: Farad with supply frequency of 50 Hz. What is the capacitive reactance

A:

Q: A circuit draws a current of (4 + j 3) A from a (150 - j 5) V source. What is the real power of the ...

A:

Q: Design a combinational circuit with three inputs, x , y , and z , and three outputs, A, B , and C . ...

A: Given, Inputs are x,y and z. Outputs are A,B and C. When the binary input is 0, 1, 2, or 3, the bina...

Q: 4. Given the system as shown below, find the following: a). The closed-loop transfer function b). Th...

A: The solution is given below

Q: DETERMINE THE OUTRUT VOLJAGE (VO) OF A DIFFERENTIAL AMPUFIER FOR THE INPUT VOLTAGES f 300 miorovolt ...

A:

Q: 5. A closed loop system has transfer function 200(s + 0.5) (s + 11.9)(s + 0.505)(s² + .5925s + 16.64...

A: The solution for the above problem is shown in below steps:

Q: Let v,(t) = 9cos(2t)V, R1 = 3N, R2 = 82, C1 = 600mF and C2 = 900m F. %3D %3D %3D %3D | + C2 Vs 2i, R...

A:

Q: Question # 1: The equivalent circuit impedances of a 20 kVA, 8000/240 V, 60 Hz transformer are to be...

A: In this question we need to find a equivalent circuit impedance of the given transformer.

Q: Define Power Factor in five ways with respect to each of the following: >angle between the voltage a...

A: The cosine of angle between voltage (V) & current (I) is termed as power factor.

Q: Det ermire

A:

Q: À signal g(t) band-limited to B Hz is sampled by a periodic pulse train Pr, (t) made up of a rectang...

A:

Q: 2. For the circuit in Figure 7-41, determine the following: (a) the power dissipated in the transist...

A:

Q: By inspection, which parallel element in Fig. 6.5 has the least con- ductance? Determine the total c...

A:

Q: At Input wavefront →t -5 Voltage across the capacitor

A:

Q: Compute the Inverse Laplace transform of the given equations: (s² + 3s + 8) T(s) = (s + 1)(s² + 5s +...

A: We will use partial fraction method to find inverse Laplace transform given as: s2+3s+8(s+1)(s2+5s+5...

Q: R3 A F E 1 E R1 В R2 E2. D Otheexpertta.com

A:

Q: The voltage v = 106 sin(100t+50°) V is connected acroos a 212-µF capacitor. Determine the current at...

A: Given, V=106sin(100t+50°) C=212microF To find magnitude of current @t=0.001s

Q: Calculate the phase deficiency of the following open-loop transfer function evaluated at s = -3.9 +/...

A:

Q: Convert 1000 W into its equivalent mechanical horsepower

A: We need to convert given watt power to horse power .

Q: Identify the corresponding transfer function of the state-space equation below. 1 0 u (t) 1 -18 -21 ...

A:

Maximum power transfer theorem

A resistive load will consume maximum power from a network when the load resistance is equal to the resistance of the network as viewed from the open-circuit terminals, with all energy sources removed leaving only the internal resistances. Physicist Moritz von Jacobi introduced the maximum power transfer theorem in 1940. Therefore, this theorem is also known as Jacobi's law.