How do I calculate this circuits values?

Q: For the circuit shown, calculate root main square voltage where a=50°. P S 220 ww w W 100

A: The circuit diagram,The peak value of line voltage, The firing angle,

Q: A load is connected to a 210 V, 50 Hz supply. If it has resistance of 30 02 and a capacitor of 0.25…

A: Supply voltage V = 210 V.Frequency f = 50 Hz.Resistance Capacitance

Q: 11. Find the voltage V, for the network in Fig. 18.117. E₁ 100) 10V 20 K₂ 20 FIG. 18.117 Problem 11…

A: Given that,                                                  voltage Vs =? by super position theorem

Q: Determine the energy stored in capacitors and inductors under DC conditions:  WL1, WL2, WC1, WC2

A: The given circuit isWe need to find the energy stored in capacitors and inductors under DC…

Q: Consider the circuit below, where the capacitor is uncharged, and the switch is open. The different…

A: The circuit diagram,

Q: Consider the Circuit shown. is = 7 sin (100+ +30) (1 TR Find a a The Ik + YL 34H 1 Find the total…

A:

Q: 5 Find the steady-state expression for v, in the circuit = = 200 cos 5000t mA. of Fig. P9.26 if i g…

A: Using current division rule, find the current through the 240 ohms resistor. By ohms law , voltage…

Q: Find I, in the network below using linearity and the assumption that I = 1 mA. 2 ΚΩ 2 ΚΩ www 12 mA 2…

A: Given Data:Consider the circuit with branch currents and node voltages as,To Find:The value of  by…

Q: What is the ladder logic equivalent of the following gate logic?

A: For the given logic diagram the equivalent ladder logic diagram needs to be identified.

Q: Question 8. 12V I₁: A R₁ R₂ 5 V C R₂ Consider the circuit below, where the capacitor is uncharged,…

A: The circuit diagram,The resistors,

Q: A message to be transmitted using AM is given by m(t) = 2cos(2πt) + 4sin(6nt) where the unit of time…

A: Given:a message signal, we need to find:a) message bandwidth and sketch the magnitude spectrum. b)…

Q: Q4/ Why the performance of multimode graded index is better than multimode step index? Q5/ Design…

A: According to guidelines solving only one question at a time4) To discussWhy the performance of…

Q: You are given the following distribution of two point charges Q₁ and Q₂. Y [m] 7 6 5 Сл 4 3 2 1 Q₁:…

A:

Q: 2. The element in an electric oven is designed to produce 3200 W of heat when connected to a 120 V…

A: Power is given as, P = 3200 W.Voltage is given as,  V = 120 V.

Q: In the circuit given below, R=20 Q. Find 1, 12, and 13 using mesh analysis. 12 V (+1 i₁ 1 + www 292…

A: In this question, we need to determine the currents i1 , i2  and i3 as shown in the circuit. We…

Q: The Boolean equation of Y is A B C Select one: a. O b. O C. O d. e. E (B+D)(C+E) + A + F + G None of…

A: Given circuitAsked to find the Boolean expression.

Q: 1. What value of R will make VAB = 10V? 100 Q www O 10 A www R A B

A:

Q: B. Find the Laplace transform of the function g(t) given in the plot (remember that the definition…

A: Given:a signal, we need to find:The laplace transform of the above signal.

Q: Calculate the K value that makes the steady state error "0.2" when the R input is a unit step. R…

A: We need to find out Value of K for given steady error for given system .

Q: Determine the current flowing through resistor R given: Ę₁ = 16 V, R₁ = 15 Q, R₂ = 8 N, R₂ = 28 ,…

A:

Q: Find the Fourier transform of the following signals: a) x(t)= e^-3ltl sin(2t) b) x(t)=[ te^-2t…

A:

Q: V Calculate R1 and R2 (a) = 0.05 (b) R = 40k eq (a) vo/vs = 0.05 (b) Req = 40kN R₁ ww Vs Req R₂ + Vo…

A: Given circuit,Asked to find the values of

Q: Determine the voltage dropped across R₂, given: E₁ = 228 V, R₁ = 29, R₂ = 22 02, R₂ = 45 02, and R₁…

A: In this question, we need to determine the voltage across the terminal of resistance R3 .We solve…

Q: What is the range of K for which the system is stable?

A:

Q: 1. The equivalent circuit if a 200/400-V step- up transformer has the following parameters referred…

A: Given data,

Q: H.W2 The single-phase full wave controlled rectifier has a R-L load with R= 0.52 and L= 6.5mH. The…

A: vs=Vm=220VR=0.5ΩL=6.5mHα=600ω=2πf=2π×50=100πAsked to find the followingThe average thyristor…

Q: 1. 2. 3. 4. 5. In Rn Eth Rth VL(Min) VL(Max) IL(Min) IL(Max) RL max pwr

A:

Q: An amplifier has a spectrally pure sine-wave input of 50 mV. It has a voltage gain of 60. A spectrum…

A: We are given Amplifier has a spectrally pure sine-wave input of 50 mV and voltage gain is 60. A…

Q: Determine the current flowing through resistor R₁, given: E₁ = 36 V, R₁ = 1702, R₂ = 2002, R₂ = 122,…

A: The circuit diagram,The resistors,The battery voltage,

Q: Determine the power consumed by R, given: 1 4 Ę₁ = 156 V, R₁ = 24 №, R₂ = 38 №, R₂ = 23 , and R₁ =…

A: The given circuit is shown below.We need to determine the power consumed by R4.

Q: H.W3 The single-phase full wave controlled rectifier has a R-L load with R= 0.52 and L= 6.5mH. The…

A: Since you have posted multiple subparts so we will solve the  first 3 parts for you,The resistor,…

Q: From the circuit down below, find average power where a=30°, ß= 60°, and frequency equal to 60Hz.…

A: The total power generated or used during a certain amount of time divided by that amount of time is…

Q: 2-) 100A {R₁=212 R₂=42 } R 3= 6-2 F₁ I3 114 F₁ =? 12 = ? I ₂ = ? 14=?

A:

Q: For the circuit shown in below figure, find v and the power absorbed by the resistor? 15 mA O V O a.…

A: Circuit diagram is given as,

Q: Signal x(t) = 2cos⁡(πt+π/4) is sampled at 10 Hz sampling rate. Represent output in discrete time…

A: The signal, The sampling rate,

Q: configuration. Given the following function, F (a, b, c, d) -Em (0,1,2,5,6,7), find the alternate…

A: The given problem is with digital circuits The problem can be solved by using k-map. The detailed…

Q: Find G(jw) = Vo/V1 for the circuit shown below. C1 100 nF V1 sine www R1 10 ΚΩ + in R2 100 ΚΩ OA1 Vo

A: In this question, we need to determine the voltage gain of the given circuit. We solve this problem…

Q: 1. Obtain the inverse Laplace transform of X, (s) = 1 s(s+1)³

A:

Q: The correct name for the the symbol below is A Thyristor फै Select the correct definition for the…

A: Given: options for thyristor definition.we need to select:correct options for thyristor definition.

Q: A coil used for control applications is being supplied by a 24-V DC supply. When the coil is…

A: When the switch is closed, the current in the coil increases exponentially. When the switch is…

Q: An analog voltage in the range 0 to 10.8 V is divided in 16 equal intervals for conversion to 4-bit…

A: Range of voltage is given as,0 to 10.8 V.Maximum voltage is given as, Number of interval given as, n…

Q: All the work looks great, but can you plot the graph?

A: Given a series RLC with input E,asked to plot the steady-state current

Q: D 136V (+) +=0 ак M 24K determine VIZμE Capacitor initial Vo at position I and 2.

A:

Q: how did they kow new force in z direction?

A: From the provided solution we need to tell how the new force has been taken in z direction.

Q: Determine the voltage dropped on R3, given: E₁= 321 V, R₁ = 18 №, R₂ = 85 N, and R₂ = 1142 (Round…

A: The circuit diagram,The resistors,The battery voltage,

Q: What is the value of the small-signal diode resistance rd of a diode operating at a dc current of…

A: We need to find out the small signal resistance for diode.

Q: Consider the y(t) = 20 sin wt f = 5KHZ. 06 Circuit shown. V V (+) + Find vect) and and i(t) 0.47м F…

A: The circuit diagram,The supply voltage,

Q: For an amplitude modulated wave, the maximum amplitude is found to be 10 V while the minimum…

A: The maximum amplitude and minimum amplitude of the amplitude-modulated wave are given and its…

Q: switch in 25 V as been open for R2 200 Q ww R1 50 Ω (a) Find io(0), iz(0-), and UL (0). (b) Find…

A: Given Data:An RL transient circuit with,DC voltage To Find:The currents through the switch,…

Q: Obtain the equivalent impedance of the given circuit, where R = 11 02.

A: The total impedance of the given circuit needs to be calculated and the same can be calculated by…

Current Division Method

The generalized current divider formula is given by the following relation below,