Homework 1 3 k Determine the reactions at the supports. EI is constant. Fixed A 10 ft Cy = 1.875 k %3D Az = 3.00k Ay = 3.125 k 10 ft MA = 6.25 k· ft %3D Roller

Q: Given the following, determine the reactions for the beams. Please show step by step solutions so I…

A: Step 1: Step 2: Step 3: Step 4:

Q: The couple M = 23 kN-m is applied to a beam of the cross sec angle with the vertical. Determine the…

A: Given : M = 23 KNm  and  β =150                           Find :  stress at A, B ,D = ?    Let the…

Q: Two solid cylindrical rods (1) and (2) are joined together at flange B and loaded, as shown. If the…

A:

Q: Determine principal stress

A: Given  Normal stress X = -10MPa Normal Stress Y = -3 MPa Shear stress = -2MPa   To find Principal…

Q: The figure above is a skycam which is supported by 2 wires (assume that no wires holding at the top…

A: This question related to the Strength of material. In this question we calculate the tensile…

Q: 10 kN 20 mm 10 kN 10 KN 400 mm 400 mm 20 mm 15 KN D 15 KN 400 mm 20 kN 20 mm 10 [40 Section a-a 40…

A:

Q: An M pair of forces is applied to the beam of which cross-section is shown in a plane that makes an…

A:

Q: 3. The rigid bar ABCD of negligible weight is initially horizontal, and the steel rods attached at A…

A:

Q: A = 2000 mm² A = 900 mm² B 503 mm 257 mm 355 mm The steel rod is stress-free before the axial loads…

A:

Q: Set P = 49 kN, P₂ = 37 kN. (Figure 1) Figure P₁ N 2 m 1.5 m ▾ Part A Determine the force in member…

A:

Q: Problem 6 Determine the state of stress acting at point D. Take P₁ = 50 kN and P₂ = 10 kN. Part A OD…

A:

Q: The 3 bars are made of steel and form a pin-connected truss. Each bar has a cross sectional area of…

A:

Q: Compute the moment about x-axis of thin plate with constant density 8(x, y) = 5, bounded below by…

A: mx = 3.93

Q: Determine the center of mass in y axis (y) of the homogeneous solid block. L = 0.45m 5L 4L 3L 2L 3L…

A: This question related to the Strength of Material.

Q: The 1.16-in. diameter rod in (Figure 1) is subjected to the loads shown. Determine the state of…

A:

Q: 1. Determine the force in each member of the truss and state if the members are in tension or…

A:

Q: A shaft composed of segments AC, CD, and DB is fastened to rigid supports and loaded as shown in the…

A:

Q: Determine the strain energy of the tapered rod AB, where Amin is the cross-sectional area at end B.…

A:

Q: The two bars are used to support load P. When unloaded, joint B has coordinates (0, 0). After load P…

A:

Q: Two forces are applied to the construction bracket a shown. Determine the angle which makes the…

A: GivenR=RyRx=0

Q: Consider a square bar 30 mm on side and 2.5 m long, having a material yıeld point 254 (IH MPa). An…

A:

Q: Determine the forces in members BC and CG. The forces are positive if in tension, negative if in…

A:

Q: Incorrect The two bars are used to support load P. When unloaded, joint B has coordinates (0, 0).…

A:

Q: A leaf spring is made of plates 50 mm wide and 8 mm thick. The spring has a span of 700 mm.…

A:

Q: The 39 kg drum is suspended from the hook mounted on the wooden frame. Determine the state of normal…

A:

Q: The homogeneous 5z.x-kg bar ABC is held in position by a horizontal rope attached to end C.…

A: The mass of the bar is m=5zx or m=20 kg. Here, x=1, y=7, z=4. Calculate the weight of the bar.…

Q: The 34-kg crate is stationary when the force P is applied. Determine the resulting acceleration of…

A:

Q: A shaft composed of segments AC, CD, and DB is fastened to rigid supports and loaded as shown in the…

A: Given:- A composite shaft fastened to rigid supports having Modulus of Rigidity as…

Q: Figure 60° 4 m 4 m- 4 m 60° D Determine the force in member BE of the truss. Express your answer to…

A:

Q: B Answers: CH- i AH- i CD= i D H BC=CD=DE=EF KN K 3 KN a

A:

Q: to m B 3 m S 5m Find: Force e, RA, RB

A:

Q: The beam with cross-section shown carries a uniformly distributed load of intensity w over its…

A: Here we find  1. Support reaction by the help of three equilibrium equation. 2. Draw shear force…

Q: The beam below supports 3-point loads. The beam is supported by a pin at A and a roller at D. a)…

A:

Q: / The assembly consists of two 10-mm diameter steel rods AB and BC, and a rigid bar B. After…

A:

Q: An aluminum tube of outer diameter R, = 50 mm is heated such that it is mounted over a steel shaft…

A:

Q: Determine the force in each member of the truss and state if the members are in tension or…

A: MemberForceNatureAB1.768 kNCompressionBC1.546 kNCompressionBE0.250 kNCompressionBF0.344…

Q: Find the value of EI · 8 at the center of the last span of the beam.

A: Firstly, the support moments can be found using MDM,as the given beam is indeterminate one.

Q: Q1/ The assembly consists of two 10-mm diameter steel rods AB and BC, and a rigid bar B. After…

A:

Q: The center post B of the assembly has an original length of 124.7 mm, whereas posts A and C have a…

A:

Q: Q2/ Calculate the strain of rod BC. A = 300 mm² and E= 200 GPa. Als B 30° 4300 P=20 KN L=3m L=2m St

A: The figure is shown in the above figure. Point load P = 20 kN A = 300 mm2 E= 200 GPa = 200 x 103 MPa…

Q: The wood column is pinned at its base and top. Determine the maximum eccentric force P the column…

A: Given Data: The modulus of elasticity of the wood column is E=10 GPa. The yield stress of the wood…

Mechanics of Solids

It is the study of the behavior of solid materials, their characteristics under various circumstances such as variation in external forces, temperature, and other internal factors. It is one of most important study in the field of engineering science, especially chemistry and mechanical engineering. In rigid body, the idealization of the solid body in which deformation is neglected. Deformation is known as the force acting on the solid state system which exerts change in its shape of the body but it continues to be at rest or in a uniform motion but it cannot accelerate. But those solid systems do have elasticity, compressibility and can be bent. This field is very vast since there are wide range of materials around us.