Given the circuit, use Nodal Analysis to determine the Voltage V. 6ks W 4ka W 10V. 12 V. a. - 6 V. b. 8 V. c. -9 V. d. 3 V. O e. 2 V. :4кљ

Q: Given the characteristic equation of the denominator below, is the system: 25 G(s) = s² + 3s + 25 O…

A: Given: Gs=25s2+3s+25

Q: Consider a 25-kVA, 400/1600 V single-phase transformer supplying full-load current at 0.85 lagging…

A:

Q: For the source-follower of Fig. 5.22, IDSS = 16 mA, Vp = -4 V, RG = 1 MW, Rs = 2.2 kW, VDD = +9 V…

A: We need to find out the voltage gain for given circuit

Q: The region in junction diode that (V=Vzk) is called--- Your answer

A: Given  The region in junction diode that (V=Vzk) is called.......

Q: Exhibits no energy gap between the valence and conduction ? OInsulators O Conductors O…

A: We need to select correct option for given statement

Q: E 1 The = then for what value of B the R 2² E - ratio is satisfied. E 4 C R B

A: Given block diagram, ER=12 Forward path, G = 4 Feedback, H=β

Q: trasformer has a copper loss of 1.5% and reactance 3.5% when tested on load. Calculate its full load…

A:

Q: One types of diodes are typically used for power supply applications which always called

A: Diodes used in power supply applications:

Q: 17. X1, X2: A crystal is connected at these two pins. The frequency is internally divided by two…

A: The operating frequency is half of the crystal frequency because it is responsible for generation of…

Q: Example2: Determine Vc and V₁ for the network. C₁ 10 μF RR • 100 ΚΩ Rc 2 1.2 kΩ C₂ 10 μF B=45 VEE =…

A: BJT is the bipolar junction transistor this device have three terminal. It is a semiconductor…

Q: The resistance of a wire with length of 6.7 mile and diameter of 0.5 in and conductivity of 3.20 S/m…

A: For the given values of length, diameter and conductivity we need to compute resistance of the given…

Q: What is factor of a cable at 5 degrees celcius when calculating resistance

A: The solution is provided in the following section.

Q: Resistor Resistance Voltage Current 1 100 Ohm     2 47 Ohm     Total   10 V   Complete the table by…

A:

Q: What is heating effect of electric current and its introduction?

A: Electric current is moving electric charge carrier/ flow of electric charge is called as electric…

Q: In the circuit of Fig. 1, Vcc - 12 V, Rc- 150 K 1K, RB and Rs 25K. The transistor is characterized…

A: For the above given common emitter amplifier circuit we need to derive all the AC parameter such as…

Q: multivibrator.

A: A digital voltmeter is an electrical measuring tool that is used to determine the difference in…

Q: The conductor has a large energy gap? O True O False

A:

Q: Which of the following lamp that will produce a 53 lm/W l

A: Luminous efficiency is the quantity of measurement for light sources and is described by the ratio…

Q: The integral of the normal component of any vector field over a closed surface is equal to the…

A: Given  The integral of the normal component of any vector field over a closed surface is equal to…

Q: Q6: A PMMC meter with a coil resistance 100 2 and a full-scale deflection current of 100μA is to be…

A:

Q: Example: X1 X2 X3 1 Fine the transfer function for this system O O 1 O -2 O 1 10 EHH

A: Given State matrix representation is shown below. x1˙x2˙x3˙=010001-1-2-3x1x2x3+1000uy=100x1x2x3…

Q: Q.9 Find the transfer function given below: G₁ X(s)- H G₂ Y(s) X(s) Y(s) of the system -Y(s)

A:

Q: b. Choose the suitable choice for nine of the following sentences. 1. In order to tune a parallel…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: In stepper motor, the number of digital pulses required to obtain one complete revolution with a…

A:

Q: Zener diode is widely used as ...

A: A Zener diode is a special type of diode, zener diode allow current to flow backwards when a certain…

Q: A coil draws 1875 watts when connected to a

A: This question belongs to circuit theory . It is based on the concept of coil . Have a look at the…

Q: Find current I in the circuit in 12 Ω 50/0⁰ d 2Ω UN -j3 Ω b -4 Ω HH 8 Ω MAN C | 16 Ω 8 Ω

A: Given circuit :

Q: What is the difference between core i3, core i5 and core i

A: The difference between core i3, core i5 and core i7  processors are

Q: Find il and i

A: The current through the mesh can be calculated by using the mesh analysis. The mesh equation can be…

Q: The condition at which a FE

A:

Q: The function of zener diode is to provide a constant output voltage to a load. this process is…

A: Function of Zener Diode:

Q: The cross product of two non-identical vectors is always new vector parallel to both of them. O True…

A: We need to tell about whether the given statement is true or false.

Q: For the network of the figure, determine: a. Is. -0+18 V b. Ic. c. VE. 9.1 ΚΩ d. VCE. 510 ΚΩΤ lc 510…

A: We need to find out current and voltage for given circuit

Q: The drain current in a p-channel E-MOSFET with V GS(th) -3V at V=0 is GS Select one: a. maximum

A: Given a p-channel E-MOSFET with, VGSth=-3 V At, VGS=0 The drain current, ID=?

Q: Z₁= 1.2 + j2.4 , Z₂= 2.3 + j6.5 N, R=100 ₪, X=500 2 and Z₁=23 +j20 №.

A: Given: Z1= 1.2 +j 2.4 Ω Z2= 2.3+j6.5Ω R0= 100 Ω  X0= 500Ω ZL = 23+j20Ω

Q: A charge QA= -20 µc is located at A (-6, 4, 7), and a charge QB= 50 μc is located at B (5, 8, -2) in…

A:

Q: * Q2: Find the (Rth and Vth) by using thevenin's theorem in the circuit as shown below? R1 47002 A B…

A:

Q: The function of zener diode is to provide a constant output voltage to a load. this process is…

A: Given  The function of zener diode is to provide a constant output voltage to a load. this process…

Q: Design ADC using VTC (Voltage to Time Converter) with clock generator fe-32Hz and the slope of…

A: Given data, Slope K=0.025 Maximum Analog Input VA=20V Frequency fc=32Hz

Q: The magnetic field intensity outside the solenoid is ? OH = 0 OH = NI/d OH = NI/2 OHNI//2 p TIC

A: We need to find out magnetic field outside of solenoid

Q: A four-pole, DC generator with lap winding has 48 slots and 4 elements per slot. How many coils does…

A: Given data, The number of poles=4 The number of slots =48 The elements per slot =4

Q: ● A buck converter is supplied from a 50V battery source. Given L=400uH, C=100uF, R=20 Ohm, f-20KHz…

A: Types of Basic DC-DC Converter Buck Converter Boost converter Buck-Boost converter

Q: A sinusoidal voltage trace displayed by an oscilloscope is shown, if the 'time/div' switch is on 500…

A: In this question we have given voltage waveform, we have to find out frequency , amplitude , peak to…

Q: VDS is ΙΜΩ .2V + Ο τον Ο 4.75 VGS 0 16V 12 ΚΩ D -OS Ipss = 10 mA Vp =-8 V

A:

Q: The work done by an external source in moving a unit positive charge from one point to another in an…

A: Given  The work done by an external source in moving a unit positive charge from one point to…

Q: Example: X1 0 X2 0 X3 -1 Fine the transfer function for this system 1 O -2 O 10 H:H x₂ X₂ -3 X3 y=[1…

A: given here a state space equations and asked to find the transfer function.

Q: i. Obtain the parameters of the equivalent circuit, Find the full-load copper and iron losses. ii.…

A: The transformer is astatic device, which transfers the electric energy from one circuit to another…

Q: Practice Problem 1: Given that Vbn = 110/30°, find Van and Ven, assuming a positive (abc) sequence.

A: Given data, Vbn=110∠300

Q: The resistance of a wire with length of 6.7 mile and diameter of 0.5 in and conductivity of 3.20 S/m…

A:

Q: --- it used to protect against high voltage surges. Your answer

A: Given  .......is used to protect against high voltage surges

Nodal Analysis

In the analysis of any electric circuit, nodal analysis is the method of determining the potential difference or voltage between different nodes in an electric circuit. A node is a point where two or more branches connect each other. In the nodal analysis, the voltages are determined in the terms of branch currents. The nodal analysis is also known as the node voltage method or branch current method. The nodal analysis method is one of the several applications of Kirchhoff's Current Law (KCL).