Given a parallel RLC circuit comprised of the following element: 58.48-ohm resistor, ideal inductor with reactance of 74.07 ohms; and a capacitor with reactance of 19.78 ohms. Compute for true power in watts given an ac voltage source of 100 cis 0 volts. Compute to the nearest 4 decimal places. No Scientific notation. Do not round off in the middle of calculation. Use stored values

Given a parallel RLC circuit comprised of the following element: 58.48-ohm resistor, ideal inductor with reactance of 74.07 ohms; and a capacitor with reactance of 19.78 ohms. Compute for true power in watts given an ac voltage source of 100 cis 0 volts. Compute to the nearest 4 decimal places. No Scientific notation. Do not round off in the middle of calculation. Use stored values

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Similar questions

A resistor & a capacitor are connected in series across 230V, ac supply. The current taken by the circuit is 4 A for 50 Hz frequency. The current is reduced to 2 A, when the frequency of supply is decreased to 40 Hz. Determine the value of resistor & the capacitor.
1. Describe the difference between the currents that exist in the wires leading to a capacitor when theses wires are connected to (a) a DC source and (b) an AC source.
Determine the voltage across capacitor #3 (C3)? Select one: a. 7.2 volts b. 6.36 volts c. 5.65 volts d. 4.8 volts
An inductor of 150hms and resistance of 10 Ohms are connected in series to a 230V, 50 Hz ac supply. Determine the active and reactive power and power factor in the circuit.
a) We assume that the switch is on. Calculate the reactance values and find the charging current in the circuit below. Is the circuit capacitive or inductive? Show that the voltage across the capacitance can be slightly larger than the source voltage U. (This is called the Ferranti effect and means that we can get a voltage rise beyond overhead lines with small loads. This is mostly relevant at the highest voltage levels. The frequency f is 50Hz, and assume voltage U= √2⋅24kV
We want to investigate how the field strength will be with air as dielectric and with steatite. A plate capacitor is placed in a 24 kV network between phase and ground. The relative permittivity of air is &=1 and for steatite &-6. The plate capacitor has area = 1m². The distance between the electrodes is 2 mm. Ep = 8.854-10-12 F/m A=1m² d=2mm a) Calculate the maximum field strength in the plate capacitor. (Answer: 9.8kV/mm) b) What is the capacitance of the capacitor if we use steatite? (Answer: C = 26.6nF)
8. Liquids with solid impurities a) Have higher dielectrie strength b) Of large size have higher dielectric strength c) Have lower dielectric strength as compared to pure liquids d) None of the above 9. Peak to peak ripple is defined as a) the difference between average de voltage and peak value b) the difference between maximum and minimum de voltage c) the difference between maximum ac and average dc voltages d) the difference between ac (rms) and average de voltages 10. In a Cockroft-Walton circuit, input voltage 100 kV load current 25 mA, supply frequency 100 Hz, each capacitor 10 nF. The optimum no. of stages for maximum output voltage is a) 1 b) 2 c) 10 d) 35
Which of the following is true about all series ac circuits?(a) The voltage across any circuit element is a maximumwhen the current is a maximum in that circuit element.(b) The current at any point in the circuit is always thesame as the current at any other point in the circuit.(c) The current in the circuit is a maximum when thesource ac voltage is a maximum.(d) Resistors, capacitors, and inductors can all change thephase of the current.
1. Enumerate five formulas for series-parallel capacitances across Vt source and draw the circuit. 2. Enumerate five formulas for parallel-series capacitances across Vt source and draw the circuit.
A series circuit consisting of 10 ohm resistance and 60 mH inductance is connected to a 220-volt, 50-hertz source. Determine the voltage drop across the inductance.
A 5uF capacitor is connected across an emf of 50 Volts maximum value and frequency of 1000 cycles. What is the equation of the current?
The Subject is Basic Electrical Engineering Chapter 15. Conductance, Susceptance and Admittance of AC Circuit.