Given a parallel RLC circuit comprised of the following element: 76.19-ohm resistor, ideal inductor with reactance of 72.41 ohms; and a capacitor with reactance of 16.55 ohms. Compute for true power in watts given an ac voltage source of 100 cis 0 volts.

Given a parallel RLC circuit comprised of the following element: 76.19-ohm resistor, ideal inductor with reactance of 72.41 ohms; and a capacitor with reactance of 16.55 ohms. Compute for true power in watts given an ac voltage source of 100 cis 0 volts.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.27P: An industrial load consisting of a bank of induction motors consumes 50 kW at a power factor of 0.8...

See similar textbooks

Related questions

Q: (b) Given that a total impedance of a series circuit is Z = 10 – j13 Q and the operating frequency…

A: In this question, Total impedance Z= 10-13j Operating frequency f= 60Hz. Sketch the series and…

Q: The resistance and inductance of a coil can be obtained by connecting the coil in series with a…

Q: Q4: For the network in Fig.below and the applied signal: a. Determine the sinusoidal expressions for…

A: Given : In the question they have mentioned an electrical circuit having voltage source and…

Q: Using the phase shift of 72º from the Experiment, determine the inductance value, L, of the inductor…

Q: Vcc 3k2 100k2 Frequency Response B www 20 k2 2k2 100k2 1 kas 2 UF Consider the following circuit…

A: Given the following circuit: Given the value of parameters: Cπ=2 nF , Cμ=0.5 nF , rπ=10 KΩ , β=100…

Q: An air line has characteristic impedance of 70 and phase constant of 3 rad/m at 100 MHz. Calculate…

A: Wave is function of space and time. The mode at which waveguide have lowest frequency is said to be…

Q: A manufacturer synthesis a high frequency laminated substrate with characteristics as Table below at…

A: a) At high frequencies 10mH2 from the given table "S3 and S2"can be used."S3 and S2"substrate are…

Q: Given the following delta-connected resistances: Rab = 10 Ω, Rbc = 9 Ω, and Rca = 4 Ω, calculate the…

Q: 1. Given the sinusoidal voltage v (t) = 50 cos (30t + 10°) Volts, find: (a) The amplitude Vm, (b)…

Q: A coaxial cable of 105 N impedance is used to connect a satellite receiving antenna to the decoder.…

A: Given, the impedance of the coaxial cable is 105Ω. capacitance (C)=75pF/m = 75*10-12 F/m diameter of…

Q: A coil consists of a resistance of 100 N and an inductance of 200 mH. If an alternating voltage, v,…

A: Given: Coil resistance = 100 Ω Coil inductance = 200 mH Alternating current, v=200 sin(500t) Sol, a)…

Q: . Consider a device connected to an ac power supply. The current leads the voltage by 90°, with the…

A: (a) Since the current leads the voltage by 90° the given device is capacitor. (b) The angular…

Q: QI/ Choose the letter of right choice only for the following: 1. Average value of a sinusoidal…

A: In this question, We need to choose the correct options We know V= IZ as per our company guidelines…

Q: 1. Given the sinusoidal voltage v (t) = 50 cos (30t + 10°) Volts, find: (a) The amplitude Vm, (b)…

Q: The characteristic impedance of a losseless transmission line is 60N. Find the inductance of the…

A: DISTORTION-LESS LINE: A line in which a wave propagates without any distortion is called a…

Q: The inductance and capacity values used in a transmission path are 20 mH and 60 nF, respectively.…

Q: 32. (a) A series connection is formed between a 1 2 resistor, a 1 F capacitor, and a 1 H inductor,…

Q: 24. In time domain represenatation of a signal, a signal with an expression of 220 cos (377t -90) is…

Q: Q2. A 50 2 carbon resistor has two lead wires with inductance of 10 nH each. If the stray…

A: Given, R=50 ΩL1=10 nHL2=10 nHL=L1+L2=20 nHC=0.5 pF

Q: Q2. A 50 Q carbon resistor has two lead wires with inductance of 10 nH each. If the stray…

A: Impedance of inductor given byXL= jwL Impedance bof capacitor given by Xc= -j/wC

Q: Figure 1 below illustrates a circuit represented in the frequency domain using phasors and…

A: For finding voltages we need to find the currents flowing the elements, so I have solved for current…

Q: 2. A delta-connected load with 500 resistance, 209mH inductance and 50µF capacitance in series per…

A: In this question we need to find a phase current of the given three phase circuit.

Q: Calculate the value of inductance that will resonate with a 82 pF capacitor at 22 MHz. Round the…

Q: POWER SİSTEMS high voltage technique it is possible to measure pulsed (AND ANSWER THE SAME QUESTION…

A: it is possible to measure pulsed (AND ANSWER THE SAME QUESTION FOR AC AND DC ) high voltages with…

Q: The Shunt Capacitance in the Transmission Line produces the Charging Current. Select one: True…

A: Choose the given Statment is true or false The Shunt Capacitance in the Transmission Line produces…

Q: Given that the steady-state AC circuit shown operates at a frequency of 400 rad/sec, find the…

A: To solve above problem, one should have a basic idea about the working of AC circuits. The above…

Q: 2. At the EPC company that you are currently employed, the Engineering Manager has purchased a new…

Q: Note: (please write only words in detail Without plagiarism from the Internet) 5. Explain the phase…

Q: A coaxial cable of 105 Q impedance is used to connect a satellite receiving antenna to the decoder.…

A: Given, The impedance of the coaxial cable is 105Ω. Capacitance (C)=75 pF/m = 75×10-12 F/m Diameter…

Q: Electrical Engineering A four-element array of isotropic sources is placed along the z-axis. The…

Q: A chopper is operated at 50HZ with the input voltage , Vin=100V and supplies a 25V at load. Given L=…

A: Given f=50 Hz Vin =100 V Vout =25 V L=200 mH C=70 μF R=20 Ω

Q: Remaining Time: 59 minutes, 17 seconds. 75% Question Completion Status: A series RLC circuit is…

A: The expression for the given voltage ratio is,…

Q: 15. A solenoid coil with a resistance of 50 ohms and an inductance of 250mH is connected to a…

Q: An Underground cable of length 40 Km has a conductor of diameter of 1.5 cm and a sheath of inner…

A: Given a underground cable of length 40 km The conductor diameter d=1.5 cm The inner diameter of the…

Q: Compute the expected power factor of the circuit given the different capacitance.

Q: Calculate the velocity factor of a coaxial cable used as a transmission line with the characteristic…

Q: The inductive reactance, X,, of a coil is given by X, = 27nfL, where f is the frequency and L is the…

A: As per the guidelines, we supposed to answer one question at a time. so please ask other separately…

Q: A 100 Ω resistor in parallel with a 5 pF capacitor terminates a 100 Ω transmission line. Calculate…

A: Solution is attached with this notes. Thank you .

Q: Consider the circuit diagram where Vs = 230020 Vrms Z, Z, Z, Find: 1. The apparent power delivered…

Q: 5. If vi = 30 sin(314t + 45°),and v2 = 60 sin(314t + 60°), find the (vị + v2) in time domain.

A: According to guidelines we need to solve only the first question. According to the question we have…

Q: The resistance and inductance of a coil can be obtained by connecting the coil in series with a…

A: using supply voltage , voltage across resistor and voltage across coil calculate angle between…

Q: 1. Convert the following to the corresponding to rectangular, phasor, and sinusoidal equivalents to…

A: (a) Hence phasor and time domain form is given by

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A chopper circuit has an inductive load of 2ohm resistance and 10mH inductance. If the source voltage is 20 V and the frequency of the chopper is set to 100Hz and the on-time to 5 ms. Determine the average voltage and current, maximum and minimum load currents.
Which of the following is true about all series ac circuits?(a) The voltage across any circuit element is a maximumwhen the current is a maximum in that circuit element.(b) The current at any point in the circuit is always thesame as the current at any other point in the circuit.(c) The current in the circuit is a maximum when thesource ac voltage is a maximum.(d) Resistors, capacitors, and inductors can all change thephase of the current.
An inductor of 150hms and resistance of 10 Ohms are connected in series to a 230V, 50 Hz ac supply. Determine the active and reactive power and power factor in the circuit.
A resistor & a capacitor are connected in series across 230V, ac supply. The current taken by the circuit is 4 A for 50 Hz frequency. The current is reduced to 2 A, when the frequency of supply is decreased to 40 Hz. Determine the value of resistor & the capacitor.
Draw the sinusoidal waveform of the AC voltage and current for the given loads below. Describe the characteristics of the waveform for each load. A. Pure resistor B. Pure inductor C. Pure capacitor
A DC-DC Chopper Circuit with an RL Load has an output current waveform shown below with a duty cycle of 50% and 1ms period. If it has a resistance of 1ohm and an inductance of 10mH, find the source voltage. 5A 2A ton toff output _current
a) The voltage across a 20uF capacitance is v. = 50 sin( at - 80) volts and Frequency equal to 100 Hz. Determine the current through the capacitor i and sketch its waveform. b) Define phasor
What impedance vector (0- j15) Ohms represents:A. A pure resistance. C. A pure capacitance.B. A pure inductance. D. An inductance combined with a capacitance.
What is the peak current in a AC circuit with a 50 ohm resistor, 3.3 mH inductor, and a480 nF capacitor in series. If the AC source has a peak emf of 5.0V, then what is the peakcurrent at 3000 Hz?At what frequency do you get the largest potential difference across the resistor? And what isthis potential difference?
a) We assume that the switch is on. Calculate the reactance values and find the charging current in the circuit below. Is the circuit capacitive or inductive? Show that the voltage across the capacitance can be slightly larger than the source voltage U. (This is called the Ferranti effect and means that we can get a voltage rise beyond overhead lines with small loads. This is mostly relevant at the highest voltage levels. The frequency f is 50Hz, and assume voltage U= √2⋅24kV
1. Enumerate five formulas for series-parallel capacitances across Vt source and draw the circuit. 2. Enumerate five formulas for parallel-series capacitances across Vt source and draw the circuit.
A 120 V, 60 Hz power source is connected across an 800 ohm resistance in series with an unknown capacitor. The voltage drop across the resistor is 102 V. Find the, a.) current of the circuit b.) impedance of the circuit c.) Capacitive reactance d.) capacitance value.