give five (16 bits) numbers that doesn't represent instructions in the basic computer.

Q: Question 5 R-type 24% Consider the following instruction mix: Load 25% I-type (non-lw) Store 10% 28%…

A: Consider the following instruction mix:RetypeI-type(non-lw)  Load          Store          Branch…

Q: Assume that [SP]= 01FF. Then Consider the following program: PSH X PHSY PSHA PULA i) ii) Show the…

A: Contents of Stack:- after PSH X: X will be in the Stack after PSH Y: Y,X will be in stack after PSH…

Q: An electric field of 0.151 N/C passes through a vector area of 3.1 cm?. Calculate the electric flux.

A: We have given the following problem

Q: How many bits are needed to represent decimal values ranging from 0 to 10000?

A: The number system is used to represent information in digital electronics. Different bases exist in…

Q: 1- A digital computer has a memory unit with 64 bits per word and 256G memory. The instruction set…

A: Since there are multiple sub-parts uploaded within the same question, thus solving the first three…

Q: 3. describes data shifted manually,. describes data shifted automatically for 8 bit .**. shift…

A: The shift register is used to shift the data either to left or to right.

Q: LDS DX, [BX] – this instruction copies - successive words from memory pointed by BX register. a. Two…

A: The instruction given is LDS. The syntax is LDS destination, source. Given LDS DX, [BX]

Q: snip

A: (a) There are nine tasks A1, A2, A3, B1, C1, C2, D1, D2, and E1, the precedence diagram is shown as

Q: What is the biggest binary number (decimal value) you can write with 6 bits? What is the biggest…

A:

Q: Suppose that initially the contents of the registers are A:07 B:A9 SP:004F X:34BF and that memory…

A: As given in the question the registers are A:-07 B:-A9 SP:-004F X:-34BF

Q: What is the total range of decimal values that can be represented in 9 bits?

A:

Q: R1 40 Vs + 100V R2. 75 R3 120 R4, 150

A:

Q: Suppose that initially the contents of the registers are A:A7 B:69 SP:004E Y:B804and that memory…

A: Given data, Initially, the memory location 0048 – 004F are set to zero. Step-1 The most…

Q: What does a RETURN instruction (RETURN, RETLW, RETGIE) do? O PC --> TOS (top of stack) O Goes back…

A:

Q: Results of arithmetic and logic instructions can be stored in one of two places. These are Program…

A:

Q: Which of these registers are not used to store the EA in the Register indirect addressing a. BX b.…

A: The correct option is SP(STACK POINTER).

Q: A multiplexer is a device that selects one among N analog or digital inputs and forwards the…

A:

Q: A microprocessor using a 3 MHz clock has three T' states in each machine cycle. If an instruction…

A: Given: f=3 MHz Number of T states in each machine cycle is 3. Number of Machine cycle in an…

Q: sll t2, t0, 6 or t2, t2, t1

A: The answer to the above problem is given below:-

Q: 1. 2. 3. Q1/ Fill blanks is the heart of any computer. is a group of 20-bit (A0-A19). These lines…

A: We are authorized to answer three subparts at a time since you have not mentioned which part you are…

Q: What is the effect of connecting a bigger capacitor in the circuit? Comment from the result obtained…

A: The objective is to determine the effect of adding larger capacitor in the circuit.

Q: The benefits of writing program in assembly: It is essay to write and modify Machine code program…

A: The explanation of advantages of assembly language are as follows.

Q: What is the device address used by the instruction OUT A4, AL

A: OUT is a mnemonic that stands for OUTput Accumulator contents to an output port whose 8-bit address…

Q: Consider the sequential circuit in the following figure with four 4-bit registers (made of rising…

A: In this question, we need to determine values of register B after 4 raising edges.

Q: We want to setup a delay time of about 2ms, we have the instruction cycle time equals to 5…

A:

Q: circuit diagram.

A: This question is from digital electronics which contains the conversion mechanism of gray to binary…

Q: What is the value at out if: a-1001 b-0100 Cin-0 $150-01 A) 1001 B) 0100 C) 1101 D) 0000. What is…

A: According to the question, we need find the output

Q: The REPET-UNTIL high level language statement executed in assembly in the following segment program:…

A: Count value stored in register CL in step 1 And the loop will executed until it becomes zero. Hence…

Q: Report: Answer the following 1- What is meant by Registers? Do they have names?

A: According to our guidelines, we can answer only one question at a time. Kindly, repost the remaining…

Q: The data select inputs of 1 to 512 De-Multiplexer is Logic gates from logic family are suitable for…

A: Given :    In the given question there are asking number of select input which are required in the…

Q: Q2 / Find the size of (short integer number, character, double number, and floating number).

A: To Find the size of short int, character, double number, floating number

Q: Difference between task and function in Verilog. What is Logic in system verilog.

A: Verilog is Hardware Description language . The memory and array declaration in Verilog is static…

Analog to Digital Converters

The analog-to-digital converter (ADC) allows circuits controlled by microprocessors, Arduinos, Raspberry Pi, and various reasonable digital circuits to be connected to the real world. In the real world, analog signals have a continuous stream of information from a variety of sources and sensors capable of measuring sound, light, temperature, or movement, in addition to the many digital systems that interact with their environment by measuring analog signals from those transducers.