Get the positive and negative half cycle of both questions please,

Q: Question 1 Consider the circuit below, what is the current flowing at 16 kohms? Si Ge U19 O 0.58 mA ...

A:

Q: A uniform plane wave of frequency 5MHZ is propagating along the positive direction of the z-axis. Th...

A:

Q: The value of damping ratio (E) for the following transfer function of a * :second order system is eq...

A: Given transfer function of the second order system, T.F.=100s2+15s+100

Q: Harmonic Frequency 50 Hz 250 Hz 350 Hz 450 Hz Current Amplitude 5A 2.1 A 1.5 A 0.8 A The current har...

A: Given,  

Q: Circuit diagram of HWR (without Capacitor): MA

A:

Q: Q3/ A 250-MW, 60-Hz turbine generator set has a speed regulation of 5 percent based on its own ratin...

A:

Q: 2. Consider the causal system defined in Eq. (1) 1 y[n] – 5yln – 1] + uln – 2] = r[n] + r[n – 2] + x...

A: As per our guidelines we are supposed to be answer the first three questions.  Kindly repost the oth...

Q: a balance delta load of 3+j4 ohms per phase is connected to a balance 110V find the line current

A:

Q: Energy gap is overlapped between Valence band and Conduction band in O a. Insulators O b. Supercondu...

A: The distance between the conduction band and the valence band of electrons is known as a band gap. T...

Q: find the total voltage (VT) in the network *

A:

Q: Two capacitors in series are charged across a 24V source. If C1 is 12 picofarads, and the voltage ac...

A: The solution is given below

Q: Table 4.6. R2 100 ohms 12V R1 R4 1k ohm 470 ohms 330 ohms Figure 4.7 Table 4.2 Analyze the experimen...

A:

Q: 3. Use the resistor color code chart to determine the value and tolerance of the resistor below. II

A: 1 COLOUR DIGIT MULTIPLIER TOLERANCE Black 0 1   Brown 1 10 ± 1% Red 2 100 ± 2% Orange 3 1...

Q: Pzm is 220 2 +. Vz= 20 V IZM G0 mA 60 W 12 W 1.2 mw 1200 W What ise the volt

A: This question belongs to analog electronics . It is based on the concept of maximum power rating for...

Q: c. Test-signal widely used in studying 1- Sinusoidal input. 2- Parabolic i d. The integral controlle...

A: C.answer is '3' step input. In transient analysis we use step signal to know the behaviour of the en...

Q: 1. Refer to Figure 1. A Y-connected source supplies 3 balanced 3-phase loads. The source has voltage...

A: As per the guidelines given to us, we can provide the solution of three parts in multipart questions...

Q: EX :-A resistive load of (R =30 ) feeding from a half controlled full wave rectifier, calculate Vo(r...

A: In this question,  If resistance R= 30ohm Half wave controlled rectifier is given Find the output rm...

Q: 3. Using Kirchhoff's Laws, find the current supplied by the battery shown in Figure 3. 4 kn 3 kn 6 k...

A:

Q: Write the three ideal characteristics of an operational amplifier.

A:

Q: 3. If all initial conditions of the networks of Figure P1.3 are zero, find v(t),t>0 CONTINUOUS-TIME ...

A:

Q: A 110 V DC motor draws an armature current of 16 A. If the armature resistance is 0.25 Q, compute fo...

A:

Q: Q/ Graph the input and output wave of the following circuit R1 1kQ ADI V1 6.5 Vrms 50 Hz RL 10㎏Ω V2 ...

A:

Q: Using thevenin theorem, determine the charge and discharge equivalent

A:

Q: A sinusoidal voltage with maximum value (336 V), and a Frequency its value (50 Hz), w applied on a s...

A: As per company guidelines we can solve only first three sub parts kindly post another parts separate...

Q: * 3. F the network of Fig. 8.66: a) Calculate In. lo and r (b) Determine Z, and Z.. (c) Calculate A,...

A: As per company guidelines we can solve only first three sub parts kindly post another parts separate...

Q: Part 1: Calculation From the knowledge of Project deliverable 1 and according to circuit in figure 1...

A: We need to find out capacitor value and time period for given circuit.

Q: or the circuit given below, assume VCC=15 VBB=6.82V, RB = 1.2 KN, RC = 1 KN, B=50, find the value of...

A:

Q: find the total voltage (VT) in the network * VI 12 V3 lov 5V 5V VT

A:

Q: Solve and please show an eligible solution: 1. Refer to Figure 1. A Y-connected source supplies 3 ba...

A: As per the guidelines gives to us, we can only provide the answer of first three subpart in multipar...

Q: Theoretical calculations: 1. How can you draw the spectrum of EM? 2. What is the minimum band width ...

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost other par...

Q: Which statements are correct APU can supply to both AC buses if needed During normal startup of the ...

A: APU- The Auxiliary Power Unit (APU) provides both electrical power and air to the airplane. It is us...

Q: A long shunt compound motor takes a current of 42 A. from a 230 V source. The generator parameters a...

A: The solution is given below 

Q: Find a. If 'and b. VR, VL ; Va C. PR, PL , Pa

A:

Q: (a) Construct the root-locus diagram for the unity feedback control system for which the G (s)H(s) h...

A: "According to the Company's policy we will solve the first three subparts of the question". We need ...

Q: 1. a) Find R1, R2, R3 for multi-range voltmeter with ranges specified in the figure b) Derive the me...

A: Answer - To find  R1, R2, R3 & M1,M2,M3 i.e. Measurement error

Q: Refer to Figure 1. A Y-connected source supplies 3 balanced 3-phase loads. The source has voltage Va...

A:

Q: A low-frequency radio wave has a frequency of 250,000HZ. What is the wavelength of this radio wave?

A:

Q: Question 7 10s? + 4 252 +1 The transfer function of a system is given by H(s) = Find the steady stat...

A: Given: Transfer function, Hs=10s2+42s2+1 Unit step input, Rs=1s  

Q: has synchronous impedance of 0+j20/phase. When it is delivering its rated QI/ A 3-phase, 55KW, 440V,...

A:

Q: *The load voltage and diode power of the following circuit are RTH 2 k2 2-D APPROXIMATION RL 1 k2 VT...

A: In this question,  We need to choose the correct options What is load voltage and diode power?  Powe...

Q: When the fault current is 2000 A for a relay setting of 50% with CT ratio 500/5, the plug setting mu...

A: The power system has to transmit power from the generation side to the load side. For this purpose, ...

Q: For pnp transistor in the active

A:

Q: A two-pole alternator is running at 1,500 rpm. Its angular velocity will be

A: Given: A two pole alternator is running at, Synchronous speed, Ns=1500 rpm

Q: For the circuit given below, assume Vcc= 15V, Rc= 18 KΩ, RE= 8.6 KΩ, RB1= 160 KΩ, RB2= 100 KΩ, β=100...

A:

Q: Energy gap is overlapped between Valence band and Conduction band in O a. Insulators O b. Supercondu...

A:

Q: Quistion.4. a) A sinusoidal voltage is applied to the resistive circuit in figure.Q.4. a. Determine ...

A:

Q: Question 3: Determine the output expression from the simplify using Boolean Laws. a) z = ACD + ĀBCD ...

A:

Q: How many serial ports (UARTS) pins are there on the MEGA 2560 board? O 10 04 0 8 O 12

A: Brief description: Generally microcontrollers are used in digital circuits. Microcontroller have an ...

Q: 5. A 50 Hz, turbo generator supplying 40% of its maximum power capability to 0.8 pu load. The operat...

A: Given, 50 Hz, turbo generator supplying 40% if its maximum power capability to 0.8 pu load.  

Q: How many GPS Satellites are present?

A: The GPS is the abbreviation for global position system it is used to determine the location of some ...

Analog to Digital Converters

The analog-to-digital converter (ADC) allows circuits controlled by microprocessors, Arduinos, Raspberry Pi, and various reasonable digital circuits to be connected to the real world. In the real world, analog signals have a continuous stream of information from a variety of sources and sensors capable of measuring sound, light, temperature, or movement, in addition to the many digital systems that interact with their environment by measuring analog signals from those transducers.