Meena Chavan​ Corp.'s computer chip production process yields DRAM chips with an average life of 2,000 hours and σ ​= 120 hours. The tolerance upper and lower specification limits are 2,600 hours and 1,700 hours, respectively. Based on the given​ information, the process capability​ ratio, Cp ​=  (enter your response here) ​(round your response to two decimal​ places).

Design specifications require that a key dimension on a product measure 100 plusminus 10 units. A process being considered for producing this product has a standarddeviation of 5 units.(a) What can you say (quantitatively) regarding the process capability?(b) Suppose the process average shifts to 102. Calculate the new process capability.(c) What can you say about the process after the shift? Approximately whatpercentage of the items produced will be defective?

Lay's potato chip filling process has a lower specification limit of 9.5 oz. and an upper specification of 10.5 oz. The mean is 10 oz. What should be the value for standard deviation in this process to achieve a ppm of 5110? A. 0.1786 B. 0.2675 OC. 0.4453 OD. 0.3564

. For a process quality characteristic, the specification limits are 0.4037 +/- 0.0013 (that is from 0.4024 to 0.4050). The following data gives the data for 14 measurement data sets, each data set is a subgroup of 5 measurement. The value is recorded in the units of 0.0001 (that is, the specification limit will be considered 24 to 50) Based on the following data, compute Cp,Cpk,Pp and Ppk.(Use MINITAB is ok) and determine if the capability of the process. Subgroup# 1 2 3 4 5 Subgroup# 1 2 3 4 5 1 36 35 34 33 32 8 34 38 35 34 38 2 31 31 34 32 30 9 36 35 37 34 33 3 30 30 32 30 32 10 30 37 33 34 35 4 32 33 33 32 35 11 28 31 33 33 33 5 32 34 37 37 35 12 33 30 34 33 35 6 32 32 31 33 33 13 35 36 29 27 32 7 33 33 36 32 31 14 33 35 35 39 3