For the following data given for a horizontal pipeline, predict gas flow rate in cu ft/hr. through the pipeline. Solve the problem the Weymouth equation d = 12.09 in Tb = 60 °F L= 100 mi Pb = 14.65 psia e = 0.0006 in p2 = 150 psia %3D T= 70 ° F p1 = 500 psia Yg = 0.65 If the pipeline goes uphill with an inclination angle of 3°, at what rate can the pipeline deliver natural gas.

A hydraulic press must be used to press-fit two components together in an assembly process. The system must generate at least 975 lb of force to perform the press fit. The piston at the input cylinder is pushed with a force of 250 lb and has an area of 30 in.2. The output can use up to 15 cylinders that are each 30 in.2. How much mechanical advantage is required to gain the necessary force ?

When forming a solid object in SolidWorks, there are a number of key words and phases. select ONLY the ones related to SoildWorks. construction line inheritance D wiggle substitution relations save bend implode pointers reference point In Plane extrude sketch

A post is supported by a ball-and-socket joint at O and cables BC and BD. A triangular distributed load runs from O to A as shown and has a maximum intensity of w = 36 N/m Length OA is 1.6 m and length OBis 2.5 m Other dimensions are given: h = 1.48 m l1 = 0.89 m ha = 0.97 m lb = 0.65 m D C, hz h1 l, 0 12 A В y W

Diagram: Given the hook-up drawing, list all the equipment, tools and materials that are needed in installation. INST. PIPING 1- *1 INST. PIPING

Paula has worked for Brindle Corporation for 3 years.  During this time, she has worked as a machine operator/cell leader in various work cells.  Recently, the plant went to mandatory 12-hour shifts and plans to remain on this schedule for several months.   Paula’s present work cell is manufacturing 3-inch diameter exhaust tubes that are made from stainless steel.  These tubes get a hole punched in them, a flange welded on, and burrs ground off.  The pipe then gets placed into a gage to check that it was made correctly.  (The tubes weigh about six pounds.)   Paula has been performing the welding operation.  She leans into the machine and loads the part into a fixture then positions the flange.  Both pieces are clamped (using hand clamps) into position and the machine is cycled by depressing two palm buttons.   The gaging operation requires placing the finished part into the gage and clamping it (using hand clamps) into place. A pin is depressed to verify the position of the hole and a…

Paula has worked for Brindle Corporation for 3 years.  During this time, she has worked as a machine operator/cell leader in various work cells.  Recently, the plant went to mandatory 12-hour shifts and plans to remain on this schedule for several months.   Paula’s present work cell is manufacturing 3-inch diameter exhaust tubes that are made from stainless steel.  These tubes get a hole punched in them, a flange welded on, and burrs ground off.  The pipe then gets placed into a gage to check that it was made correctly.  (The tubes weigh about six pounds.)   Paula has been performing the welding operation.  She leans into the machine and loads the part into a fixture then positions the flange.  Both pieces are clamped (using hand clamps) into position and the machine is cycled by depressing two palm buttons.   The gaging operation requires placing the finished part into the gage and clamping it (using hand clamps) into place. A pin is depressed to verify the position of the hole and a…