For the dam shown, determine the factor of safety against sliding and overturning. Use unit weight of concrete = 24 kN/m3 and coefficient of friction = 0.80. Show a complete solution

Q: Determine if the infinite series is convergent or divergent. n+1 n =0 n+3

A:

Q: Two steel columns P (LengthL end yield strength = 250 MPa) and a (length 2L and yield strength = 500…

A: find the ration of buckling load of column P to that of column Q .

Q: EXAMPLE: 7. If block A of the pulley system is moving downward at 6 ft/s while block C is moving…

A: find the relative velocity of B with respect to C.

Q: 2. Liquid hydrocarbon fuel, C16H43 is burned with 25% excess air. Calculate the actual air fuel…

A:

Q: 2. Motor unit A is used to elevate the 300.kg , cylinder at a constant rate of 4 m/S. If the power…

A: Given data as per the question Mass of motor =300 kg Velocity =2 m/s Power input =2.2 kw

Q: For the air duct shown below, if the total pressure of air is 250 kPa and the static pressure is 50…

A: Given, Total pressure = P = 250 kPa Static pressure = Ps = 50 kPa Density of water = ρw = 1000 kg/m3…

Q: A man walks at 5 km/h in the direction of a 20-km/h wind. If raindrops fall vertically at 7 km/h in…

A: Man velocity= 5 km/h Wind velocity= 20 km/h Raindrops fall vertically at 7 km/h   To find: Direction…

Q: Prove that there is an increase in efficiency between a Simple Rankine Cycle and a Reheat Rankine…

A:

Q: 1. Solve for the of the location of the centroid with respect to the x and y axes of the given fig.…

A:

Q: Example 7 Draw the shear and bending-moment diagrams for the beam and loading shown 50 kN 40 kN 30…

A: Solution.jpg

Q: In a dual combustion cycle, the maximum temperature is 2000 deg. C and the pressure ratio is 1.6.…

A:

Q: A structural steel wide-flange section is reinforced with two steel plates attached to the web of…

A:

Q: 1. The light bar is used to support the m kg block in its vertical guides. If the coefficient of…

A: fig:FBD of block ∑Fv=0Fy=W=218*9.81=2138.6 N

Q: Use SMART problem-solving methodology and find the sum of the three harmonic motions x;(t) =…

A: Write the all three expressions of harmonic motion. x1t=10cosωt+2x2t=15sinωt+2x3t=15cosωt

Q: A steel bar AD has a cross-secțional area of 260 mm? and is loaded by forces P, = 12 kN, P, = 8 kN,…

A: Given data P1 = 12 kNP2 = 8 kNP3 = 6 kNa = 1.5 mb = 0.6 mc = 0.9 mE= 210 GPa

Q: Consider a PV Module that produces 60 V of potential under Standard Test Conditions and with a…

A: Given           Voltage, v = 60 V Total voltage, VT = 600 V          Coefficient = - 0.004 / C…

Q: (i) An ideal gas at a given state expands to a fixed final volume first at constant pressure and…

A:

Q: Construct a single dwell cam with roller follower with the following conditions: 0 degrees to 60…

A:

Q: 2. From the loading as shown, at what distance (x) from the left support will produce a rotational…

A: Uniform variable load is varying from 0 kN at point A to 18 kN at 6 m from point A.   To find:…

Q: The rod AB shown below moves horizontally as guided by two small wheels rolling on a frictionless…

A:

Q: A 37.3 kW [50 hp] gasoline tractor is used to operate a pull type sprayer. The tractor list price…

A:

Q: Calculate the discharge through a pipe of diameter 200 mm when the difference of pressure head…

A: When the difference in pressure head between the two ends of a pipe 500 m apart is 4 m of water, we…

Q: -C.G Idler (massless) pulley K2 KI Rigid Bar with mass (m,) Disk with mass (ma)

A:

Q: The piston displacement of a double acting compressor is 0.358 m3/sec, delivers gas from 101. 325…

A:

Q: Requir nation NOTE: This isa multi-part question. Once an answer is submitted, you will be unable to…

A:

Q: A channel is formed by having two vertical brick walls with a semi circular culvert at the bottom.…

A: As per the guideline, I can solve only first question. For second question, repost in a separate…

Q: Insulating a heat transport system can be one of minimisation of heat loss.however addition of…

A: INTRODUCTION : If the wire is sufficiently thin, wrapping insulation over it may increase rather…

Q: Metal working: What is happening to the microstructure during the temper process?

A:

Q: Problem 1 a Given: F Н Mass of canister: 4000 kg 30 30° Mass of beam BD: 50 kg BỊ Max allowable…

A:

Q: corresponding tension T transmitted to the brake cable. Assume

A: To find Tension T transmitted to brake cable

Q: 10.0 m 2.00 m 2. An old western town has a water tower to deliver water to the residents. Pictured…

A: as per guideline i have to solve only first question of yours

Q: The force P on the handle of the positioning lever produces a vertical compression of 56 lb in the…

A:

Q: Q1. Determine the distance x measured from the y axis to the centroid of the area of the triangle…

A:

Q: Consider a PV Module that produces 60 V of potential under Standard Test Conditions and with a…

A: Given           Voltage, v = 60 V Total voltage, VT = 600 V          Coefficient = - 0.004 / C…

Q: 4.9 A 1200-lb load is supported by a cable that runs over a small pulley at E and is anchored to a…

A: find the reactions at the supports and draw free body diagrams.

Q: Calculate the 2nd moment of area for a beam with a length of 200 mm, a width of 20 mm and a height…

A:

Q: Calculate the slope at C using ONE of these methods: double integration method, area-moment and…

A: given; load(P)=14KNweight density(w)=21KN/m

Q: The shaft of an axial flow rotary compressor is subjected to a maximum torque of 2000 N-m and a…

A:

Q: What do you think will happen if there are no control devices in most industrial processes? Is there…

A: given; What do you think will happen if there are no control devices in most industrial processes?…

Q: Q-3: Determine the length b of the triangular load and its position a on the beam such that the…

A:

Q: For the rotational system shown in Figure P2.19, find the transfer function, G(s) = 62(s)/T(s).…

A:

Q: From the the double slider-crank mechanism shown in Fig.A (a) Determine the number of Instantaneous…

A:

Q: y does a system need to be maintained?

A: we will discuss the need for maintenance

Q: If the analysis of the forces involved on an object produces a negative answer for a force: The…

A: If doing calculation and getting any force hwith negative that means, The negative sign indicates…

Q: 5. During a test run of a Pelton wheel turbine, the pressure at the nozzle was 2.4 MPa when water…

A: Given: The pressure, P1 = 2.4 MPa The diameter of nozzle, d = 60 cm = 0.6 m The flow rate, Q = 1.95…

Q: A supercooled water droplet turning into ice is called ____________.   a. c. deposition   b. e.…

A: Concept: 1) Water droplets generally in liquid state.  2) While supercooling, the temperature of…

Q: 136 kg/s steam with an inlet condition of 52 bar, 400 C enters a rankine turbine and expands to 36…

A: The solution is attached below:

Q: 3.11 Determine the resultant of the coplanar concurrent force sys- tem shown. Determine the…

A: GIVEN DATA- A SYSTEM OF FORCE GIVEN WE HAVE TO FIND RESULTANT OF IT AND DIRECTION

Q: It is observed that the skier leaves the ramp A at an angle 0= 25with the horizontal. If he strikes…

A:

Q: The force P on the handle of the positioning lever produces a vertical compression of 56lb in the…

A: the magnitude of the corresponding force exerted by the pin at O.