For the circuit shown find: a. Power consumed in RL b. DC voltage of current source Ip dc. c. Q points of operation of the 2 transistors If it is not possible to calculate explain by laws. ID = 3 milliamperes. All semiconductors are silicon.

Q: The arrow in the symbol for n-channel JFET points __ the source-drain connections. Choose the…

A: The arrow in the symbol for n-channel JFET points __ the source-drain connections. Choose the…

Q: 17. Give the names of eight technical parameters of circuit breaker?? Select 3 most important…

A: We need to write about  eight technical parameters of a circuit breaker .

Q: 1. A type of electrical signal that has two states? 2. Write True or False about the following…

A: SCADA is  the software for controlling the industrial process. SCADA software is the central control…

Q: 12. What is the primary entity that needs to be consulted with in regards to the location of the…

A: According to the electric code, The meter and the service box should be placed outdoor which can be…

Q: Take a look at the wire supplying your house, another residential house, commercial and industrial…

A: Wires selection is an important decision while designing the electrical connections for the…

Q: List the minimum trade size Type EMT for each of the following applications. (Objective 12-1)…

A: As per Bartleby expert policy only first individual question is to be answered. So, answering only…

Q: 5.a. Which of the following tend to have the smallest splice loss? A. Connectors B. Mechanical…

A: From the given four options we need to choose the correct option regarding the given questions.

Q: Sketch and compare the TNS, TNCS, and TNC earthing regulations as p wiring used to safe guard the…

A: 3)TNCS:- i)T- denotes that the Consumer is Solidly Earthed independently of the Source Earthing…

Q: A feeder is installed to feed a sub panel. The feeder starts at a 400-amp breaker, utilizing (2)…

A: Equipment grounding conductor is  providing ground fault current path.

Q: (b) Explain the different types of diversity technique ** *'used communication system. in wireless

A: Given that  Explain diversity techniques in wireless communication system

Q: ___ or outlets allow us to plug in appliances to attach them to the electrical grid and provide…

A: Answer is Sockets or Electrical sockets Electrical sockets are the outlets allow us to connect…

Q: What is the estimated demand load for general lighting and general-use receptacles in a 24-room…

A: Given- A 24-room motel, where each unit has an area of 700 square feet   To find- The estimated…

Q: What components make up an ADT, exactly? Indicate your answer where indicated.

A: The ADT (Abstract data type)simply explains  which operations to conduct,  but not how. It doesn't…

Q: 1. a) Complete a DC Analysis of the following circuit (Ic, VCE, VC, Icsat) including Load Line: b)…

A: For the given amplifier circuit the DC parameters, AC parameters and output voltage need to be…

Q: AA Health and Safety Mr Ali Lilo, AL4510222L Time remaining: 53 Quick Select QuestiBintaseconds…

A: Option  d )2,3,1Explanation:The three items to be included in RIDOR form are1. Data and time of…

Q: TRUE OR FALSE? Prior period error are corrected current and prospectively.

A: Prior period error It is defined as The financial statements prepared from deletion as well as…

Q: What are the different Impedance matching devices?

A:

Q: Е. Using a constant 4.5 V source, three bulbs, wires, and a double throw switch design a circuit…

A:

Q: 11. Which of the following statements about the use of structural steel as an equipment grounding…

A: We are authorized to answer the first question since the exact one wasn’t specified. Please submit a…

Q: What type of terminal seal is shown here?

A: Given: What type of terminal seal is shown in figure?

Q: External effects causing short circuit include: Select one: a. overloading of equipment causing…

A: Overheating of equipment melts the is insulation layers and causes short circuit. Insulation failure…

Q: The amount of potential required to remove an electron from an atom is the _____ of the atom.

A: The amount of potential required to remove an electron from an atom is the ionization potential of…

Q: What is the lighting and receptacle demand load for an 1000 sq. m office space with one hundred ten,…

A:

Q: Fill the gap with the correct answer: In 25 pair color code twisted pair cable, the color code for…

A: The twisted pair cable is a cable that consists of two twisted copper wires that are separated by…

Q: Determine the standard deviation of the height of trees in meters with the data values 5, 4, 8, 9,…

A:

Q: 5. Which of the following descriptions of a ground ring is correct? A. A ground ring is a circular…

A: A ground ring is a bare copper conductor that will encircle an entire structure underground and…

Q: . one of the three terminals of a FET  analogous to the base of BJT IS _______

A:

Q: The nominal output voltage of a certain regulator is 8 V. The output changes 214 mV when the input…

A: It is given that: nominal output voltagevo=8 V,change in output voltage∆vo=214 mV,Vi=25 V to 16 V

Q: Question 12 kana  .Perform the calculation and record the answer with the correct…

A: Significant figures- are defined as figures present in a number that expresses l magnitude of…

Q: The __________ audio file format is limited toelectronic musical instruments and other electronic…

A: Electronic Musical Instrument:- An electrophone, often known as an electronic musical instrument, is…

Q: Is my answer current??

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: choose the correct answer In solar power plant, the cost of concentrating collector is more than…

A: Solar collector: It absorbs the incident solar rays or radiation and converts them to heat energy…

Q: 13. How can a duplex receptacle be converted to a split-wired receptacle? O A. By running separate…

A: Q-(13) Answer:— A split-wired receptacle allows separate control of the top and bottom outlets,…

Q: Just draw a directional relay circuit design (the design should be only hand written)

A: Protection devices are used in a circuit to protect the equipment and provide safety for humans from…

Q: In your own words and from your own understanding, avoid plagiarism or copying from the Course…

A: we need to explain the molded case circuit breaker

Q: 11. Time switches shall be of the enclosed type or mounted in suitable enclosures. 12. The minimum…

A:

Q: Calculate the voltage drop of a 120/240 volts, three wire underground residential service installed…

A: Given: UnderGround service=Three Wire Cable = 2 AWG Aluminum URD Cableload Current (IL) = 80 ampone…

Q: please don't provide other website answers 584. Explain the function of the electric vehicle fleet…

A: Step 1: The Electric Vehicle (EV) Fleet Driver Bioenergy System is a concept that integrates…

Coulomb’s Law

Coulomb's law states that the attraction or repulsion force between two charged things is proportional to the product of their charges and inversely proportional to the square of their distance. It has an effect along the line that connects the two-point charges.