For spaced conductors the ............ of each individual conductor are different. O a. Unsymmetrically, inductance O b. Symmetrically. frequency "Symmetrically, voltage O Symmetrically, inductance
Q: The maximum and minimum stresses in the dielectric of a single core cable are 40 KV/cm (rms) and 10…
A:
Q: Explain the L di/dt voltage problem in conductors undergoing commutation.
A:
Q: Select the best transmission line from the following: Select one: a. Conductors with very low ohmic…
A: In the above question they are clearly discussing the properties of transmission line Transmission…
Q: Two long parallel conductors of a dc transmission line separated by 2 m have charges of 5 µC/m of…
A: we can consider the the transmission line conductors as infinitely long line charges. Electric field…
Q: What do the conductors have in common? What do the insulators have in common?
A: A conductor means a kind of material that allows the flow of electric charge that is electrons in…
Q: The figure below shows a ring distributor with interconnector BD. The supply is given at point A.…
A:
Q: Q3. What will happen if the conductor in black wire and green-yellow wire touches each other? What…
A: We have to find if the conductor in black wire and green yellow wire touches each other
Q: please write introduction about AC Circuits – Series and Parallel connected Circuits
A: Given introduction about AC Circuits – Series and Parallel connected Circuits.
Q: Conductors with a -2 insulation designation have a (higher) (lower) ampacity in a wet location than…
A: Conductors are defined as materials that conduct electricity; there will not be any resistance for…
Q: "A 66 kV single core cable has a conductor diameter of 1.75 cm and a sheath of inside diameter 5 cm.…
A: As per the guidelines of Bartleby we supposed to answer first three subparts of the question for…
Q: Explain all components
A: The functioning and purpose of each of the components can be explained as: The bias for the base of…
Q: In electric transmission line, we can distinguish low voltages from high voltages through the…
A: For high voltage line the distance between them is also high compared to low voltage line for safety…
Q: A 230 kV, 60 Hz, three-phase completely transposed overhead line has one ACSR 874.5-kcmil conductor…
A: From the table, the GMR of the ACSR 874.5 kcmil conductor is 0.0386ft. The inductance of the…
Q: Mutual induction (will the induced current in the loop induce a current in the straight conductor?),…
A: Electrical machines can be either generator, transformer or motors. They can be either Ac machines…
Q: Derive the equation of Capacitance per phase for the 3-phase double circuit line with hexagonal…
A: Let us assume that the p is very far from the system of conductor and at point P potential is almost…
Q: Q2. What is the benefit of using stranded conductors in transmission systems?
A: The benefits of stranded conductors are listed below:
Q: A ferromagnetic core with a relative permeability of 1500 is shown in the Figure. The dimensions are…
A:
Q: Rigid metal conduit (RMC) is a threadable raceway of ____ designed for the physical protection and…
A: Rigid metal conduit (RMC) is a threadable raceway of circular cross section designed for the…
Q: 3. What are the classifications of Core Loss and Copper Loss?
A: Electrical machines can be either generator or motors and transformers. They can be either Ac…
Q: The figure shows a conductor with four strands. Compute the GMR in terms of the radius r. Round-off…
A:
Q: A-Define the sag of T.L and derive an expression for the total length of a Conductor and the tension…
A:
Q: A ferromagnetic core with a relative permeability of 1500 is shown in the given figure. The…
A: Marking the points A, B, C, D, E, F, G,H, I and J in the figure given,
Q: A single phase 2 conductor operates at 50Hz, the diameter of each condcutor is 60mm and spacing…
A: The inductance is expressed as the ratio of the flux linkage with the magnitude of the current. It…
Q: Derive the expression for the loop inductance in 1 phase, 2 conductor wire.
A:
Q: An overhead line has span of 260m. The tension in the line is 1200kg while the conductor weighs 650…
A: As we have given : L=260 mT=1200 kgw=650 kgh=13 m
Q: A three phase, 33 KV, underground cable system, consider a single core of conductor radius 0.8 cm…
A:
Q: The displacement is actual path of particle False True
A: The solution is given below
Q: Calculate the Inductance, in Henry per meter, of each conductor in a Three-Phase, Three-Wire System…
A: A good problem on power system. Look below for solution:-
Q: hat is the definition of Diamagnetic, Paramagnetic and Ferromagnetic give examples and their…
A:
Q: Q10. When we calculate the slot leakage inductance, if the magnetic reluctance of iron core is…
A: Calculation of slot leakage inductance is an important factor in design of electrical machine. The…
Q: Explain the different conductor types, sizes, materials, and configurations.
A: Electrical conductor: The electrical conductor is the kind of metal that permits the electrical…
Q: How can the superposition of stress components be determined?
A: Bueckner ' s superposition principle applied to residual stresses in a sectioned part: A = B + C.…
Q: -Derive and analyse relation of capacitance for 3- core cables [CLO-2,
A: Capacitance of 3 core cables: Let Cc be the capacitance between 2 cores and Ce between core and…
Q: Compare the effect of varying resistance, capacitance and inductance in parallel and series AC…
A: Note: circuit compenets are not specified. we assume following AC circuits RLC parallel circuit RLC…
Q: Each line of a 3-phase system given in figure is suspended by a string of 5 identical disks and the…
A:
Q: what is solid wire conductor and stranded wire conductor?
A: There are different types of conductor used for transferring electrical energy from source to load.…
Q: Hwl-5: Derive the self-inductance of ideal ac magnetic circuit in terms of the physical parameters…
A: Self Inductance:Generally represented as 'L' is the phenomena by which an induced emfis generated…
Q: The emf induced in a conductor when placed in magnetic field can be determined by the Lenz's law…
A: Choose the correct option "The emf induced in a conductor when placed in magnetic field can be…
Q: Magnetomotive force per unit length of magnetic circuit is known as mmf gradient True False
A: True .
Q: define the conductor with examples
A: An electrical conductor is defined as substances that permit energy to float via them without…
Q: What happen when a steady potential is connected across the end points of the conductor? Illustrate…
A: Whenever the steady state potential is connected across the end points of the conductor, the current…
Q: A ferromagnetic core with a relative permeability of 1500 is shown in the given figure. The…
A: Given,Relative permeability of the core=μr=1500Number of turns in the core=N=300Current in the…
Q: Eddy currents can be induced only in metals that are not ferromagnetic, for example, copper and…
A: In this question, We need to choose the given Statment is true or false? Eddy currents can be…
Q: What is the hysteresis loop for elastic materials? Explain the concept behind it briefly.
A: explain elastic hysteresis loop
Q: Find the inductance per unit length of a very long solenoid with a unit length of N windings. The…
A: According to the question, we have to find the inductance per unit length.
Q: For unsymmetrically spaced conductors, the distance between the conductors is equal. Select one: O…
A: For unsymmetrical space conductor , the distance between the conductor is
Q: Find the geometric mean radius of a conductor in terms of the radius r for the following 83
A:
Q: "An 11 kV single core cable has a conductor diameter of 0.75 cm and a sheath of inside diameter 3…
A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts…
Step by step
Solved in 2 steps
- Each of the conductor in a parallel-plate capacitor is calleda. dielectricb. insulatorc. platesd. terminalA. For the following figure, the diameter of each conductor is 2.5 cm. Find the inductance and capacitance per km per phase. 40 cm 40 cm 40 cm a a' b b' 10 m 10 m Phase A Phase B Phase CWhat are interpoles, and what is their purpose?
- What is the definition of Diamagnetic, Paramagnetic and Ferromagnetic give examples and their applicationsA ferromagnetic core in the shape of a doughnut has a cross-sectional area of 0.11 m2 and an average length of 1.4 m. The permeabil ity of the core is 1.206 × 10-3 Wb/A-t. m. Determine the reluctance of the magnetic circuit3. A coil consist area ot 0.8 mm? The mean 2.000 turns of copper wire haU ing length par copper is 0.02 MICD ohm -m. Find' the resistance absor bed by the coil when connected acoss lov de rupply. sectional a crass - turn is 0o cm and the rerictivity the coil and . power
- Q.4/ choose true or false: 1. The reluctance of any core is proportional directly with the length of it and inversely with both the permeability and the cross-section area of it. 2. The number of parallel paths in wave windings is equal to twice of the number of poles. 3. In dc machines with same values of Z, N, Ø, the emf for wave winding type is more than emf of lab winding type. 4. If we insert a current in such a conductor subjected to a constant magnetic field, a movement will achieved giving the principle of electric generator.A ferromagnetic core with a relative permeability of 1500 is shown in the given figure. The dimensions are as shown in the diagram, and the depth of the core is 5 cm. The air gaps on the left and right sides of the core are 0.050 and 0.070 cm, respectively. Because of fringing effects, the effective area of the air gaps is 5 percent larger than their physical size. If there are 300 turns in the coil wrapped around the center leg of the core and if the current in the coil is 1.0 A: (a) What are the flux values for the left, center and the right legs of the core? (b) What is the flux density in each air gap? 7 cm -30 cm- 7 em 30 ст 7 cm 30 cm -0.07 cm 300 turns 0.05 cm- 7 сm Core depth = 5 cmconstant. 15 cm core depth = 15 cm Problem 2 A ferromagnetic core with a relative permeability of 2000 is shown in Figure. The dimensions are as shown in the diagram, and the depth of the core is 7 cm. The air gaps on the left and right sides of the core are 0.050 and 0.070 cm, respectively. If there are 300 turns in the coil wrapped around the center leg of the core and if the current in the coil is 1.0 A, what is the flux in each of the left, center, and right legs of the core? What is the flux density in each air gap? |7 cm 30 cm 7 cm 7 cm 30 cm 7 cm 30 cm -0,05 cm 300 turns 0.07 cm 7 cm 1|Page
- A ferromagnetic core with a relative permeability of 1500 is shown in the given figure. The dimensions are as shown in the diagram, and the depth of the core is 5 cm. The air gaps on the left and right sides of the core are 0.050 and 0.070 cm, respectively. Because of fringing effects, the effective area of the air gaps is 5 percent larger than their physical size. If there are 300 turns in the coil wrapped around the center leg of the core and if the current in the coil is 1.0 A: (a) What are the flux values for the left, center and the right legs of the core? (b) What is the flux density in each air gap? 30 cm- 30 cm 7 cm 30 cm 0.07 cm 300 turns 0.05 cm cm Core depth - 5 cmA ferromagnetic core with a relative permeability of 1500 is shown in the given figure. The dimensions are as shown in the diagram, and the depth of the core is 5 cm. The air gaps on the left and right sides of the core are 0.050 and 0.070 cm, respectively. Because of fringing effects, the effective area of the air gaps is 5 percent larger than their physical size. If there are 300 turns in the coil wrapped around the center leg of the core and if the current in the coil is 1.0 A: (a) What are the flux values for the left, center and the right legs of the core? (b) What is the flux density in each air gap? 7 cm 30 cm 30cm- 7 cm 30 cm 0.07 cm 300 turns 0.05 cm 7 cm Activate Windows Go to Settings to activate Windows. Core depth - 5 cmA ferromagnetic core with a relative permeability of 1500 is shown in the Figure. The dimensions are shown in the diagram, and the depth of the core is 5cm. The air gaps on the left and right sides of the core are 0.050 and 0.070 cm, respectively. Because of the fringing effects, the effective area of the air gaps is 5 percent larger than their physical size. If there are 300 turns in the coil wrapped around the center leg of the core and if the current in the coil is 1.0 A, what are the flux values for the left, center, and right legs of the core? What is the magnetic field in each air gap? |7 cm 7 cm 7 cm to 30 cm 30 cm 7 cm 30 cm 0.07 cm 300 turns 0.05 cm 7 cm Core depth = 5 cm