For an exhaust valve, the mass flow rate through the valve is 1.26 kg/s. The flow coefficient is 0.65 and the cylinder pressure and temperature are 625 kPa and 820 K. Assume exhaust system pressure is 103 kPa, the specific heat ratio is 1.4 and R =287 J/ kg.K. The effective area of the valve is (SI unit): Select one: O a. 3.45*10-2 O b. 0.85*10-2 O c. 2.2*10-3

For an exhaust valve, the mass flow rate through the valve is 1.26 kg/s. The flow coefficient is 0.65 and the cylinder pressure and temperature are 625 kPa and 820 K. Assume exhaust system pressure is 103 kPa, the specific heat ratio is 1.4 and R =287 J/ kg.K. The effective area of the valve is (SI unit): Select one: O a. 3.4510-2 O b. 0.8510-2 O c. 2.2*10-3

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter7: Forced Convection Inside Tubes And Ducts

Section: Chapter Questions

Problem 7.33P

See similar textbooks

Similar questions

For an inlet valve, the mass flow rate through the valve is 0.44 kg/s. The flow coefficient is 0.62 and the cylinder pressure is 105 kPa. Assume intake system pressure and temperature are 180 kPa and 527 K, the specific heat ratio is 1.3 and R =287 J / kg.K. The area of the valve is (SI unit): Select one: a. 2.30*10-3 O b. 3.45*10-2 O c. 1.43*10-3 O d. 1.75*10-3 O e. 0.85*10-2
Assuming the clearance is negligible for a single stage compressor with the following data.Atmospheric pressure: 90 kPaAtmospheric temperature: 17 ˚CDelivery pressure: 7 barFree air delivery flow rate: 0.2 m3/minTake “n” as 1.3, cp = 1.005 kJ/kg K, cv = 0.718 kJ/kg K 1.What is the power input to the compressor in kW to 2 decimal places if the compression is polytropic compression process with n=1.25?
Assuming the clearance is negligible for a single stage compressor with the following data.Atmospheric pressure: 90 kPaAtmospheric temperature: 17 ˚CDelivery pressure: 7 barFree air delivery flow rate: 0.2 m3/minTake “n” as 1.3, cp = 1.005 kJ/kg K, cv = 0.718 kJ/kg K 1.What is the power input to the compressor in kW to 3 decimal places if the compression reversible isothermal?
What is the engine bore (in mm) required for good volumetric efficiency for an engine with two inlet and two exhaust valves, stroke of 90 mm, inlet air temperature of 332 K, exhaust temperature of 900 K, engine speed of 8200 rpm and exhaust valve diameter Assume specific heat ratio =1.3, R = 287 J/kg.K, and an average inlet flow coefficient 0.4 and an average exhaust flow coefficient 0.5. mm (each). Select one: O a. 96.57 O b. 70.23 O c. 105.2 O d. 91.05 O e. 82.71
Assuming the clearance is negligible for a single stage compressor with the followingdata.Atmospheric pressure: 90 kPaAtmospheric temperature: 17 ˚CDelivery pressure: 7 barFree air delivery flow rate: 0.2 m3/minTake “n” as 1.3, cp = 1.005 kJ/kg K, cv = 0.718 kJ/kg K Calculatate the following 1 )Evaluate the mass flow rate of air inside the compressor operating isentropically in kg/min to 3 decimal places. 2 ) What is the power input to the compressor in kW to 3 decimal places if the compression reversible isothermal? 3 ) What is the power input to the compressor in kW to 2 decimal places if the compression is polytropic compression process with n=1.25?
y aer. A Pitot tube is used to measure the air flow rate in a eircular duct 8.5 m I.D. The "riowing air temperature is 65.5°C. The Pitot tube is placed at the center of the duct and the reading R on the manometer is 1.2 cm of water. A static pressure measurement obtained at the Pitot tube position is 2.0 cm of water above atmospheric. Take Cp 0.98,9ter ase press u = 2.03 x 10 Pa.s, if U- Ux ( 1-0.17). Calculate The velocity at the center and the average velocity. The volumetric flow rate of the flowing air in the duct
Air at a tempenature of 27°C floves into a centrifugal compressor at 20000 pm. The following data are given: Slip factor 080 Power input factor 1 Isentroric efficiency 80% Outer diameter of blade tin 0.5 m Assuming the abslute velocities of air entering and leaving the compressor are same, find i) static temperature nise of air passing thnough the compesson, and 'ii) the static pressure ratio. p c of air is 1005 F/ kgk
If the compression ratio is 17:1, the piston displacement volume for 10 cm³ piston clearance volume is. Ans. 160 cm³
For an exhaust valve of 1.43 * 10-3 m? effective area, calculate the mass flow rate through the valve (SI unit). The flow coefficient is 0.65 and the cylinder pressure and temperature are 625 kPa and 820 K. Assume exhaust system pressure is 103 kPa, the specific heat ratio is 1.4 and R =287 J/ kg.K.
A single acting, twin cylinder, Ammonia compressor with bore equal to stroke is driven by an engine at 250 rpm. The machine is installed in a chilling plant to produce 700 kW of refrigeration at -18°C evaporating temperature. At this temperature the cooling effect per kg mass is 1160 kJ. The specific volume of vapor entering the compressor is 0.592 m³ per kilogram. Assume 85% volumetric efficiency, determine the bore in mm. A. 400 mm С. 450 mm В. 300 mm D. 500 mm
Werm Water flows through an adiabatic pumping system at a steady low rato (m) of 3 ke/u The conditions at the iniet are pi00 kPa, T=15 "C, and 0 m, and the conditions at the wxt are 500 kPa. T 18 "C, and ay= 200 um v Correct Waler Part 8 200 m Use the SL model to evaluate the punping power (W) Neglect any change in kinetic energy Express your answer in kilowatts to four significant figures. V AE ? vec Wat kW Submit ReduestAnswer - Part C What-if Scenario What would the pumping power be if the exit temperature were 19"C? Express your answer in kilowatts to four significant figures. AE 1 vec ?. Wout= kW Submit Beauest Answer
In the diesel engine experiment, if: engine speed= 1302 Torque (N.m) = 9.9 Power(W)= 1344 Air mass flow rate (Kg/sec) = 0.002178 fuel mass flow rate (Kg/sec) = 0.000140 Tamb (C)= 20.1 Texh (C)= 292 Pamb (mbar)= 929 Air box Pressure (Pa)= -82 The Volumetric efficiency will be: Select one: a. 84.89% O b. 78.33% O c. 65.27% O d. 71.86%