For amplifier in Figure 1 ID=0₁3 mA, ^₁ =^₂=0.15 V-1 and CL = 94 pF.F T the gm₁ = 6ms, gm₂=1ms

Q: Consider the system as shown in the figure below, is you know that the damping factor is 0.5 R(s)…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: Law: From the given circuit below, Find I, I and Is by Kirchhoff's E₁ 12v. 32 13 32 In 50 ㅓ Ez &v.

A:

Q: A 240-V, 100 A armature full-load current, 1800 RPM, cumulatively-compounded DC motor is considered…

A:

Q: Below In the unit feedback system given the shape, G(s), is given as. When a unit ramp is applied to…

A:

Q: he moderate voltage limiting device used in ECG orcuatry is made of Oa Gas-decharge tube Ob 2…

A: Low voltage limiting device: Parallel silicon diodes  Moderate voltage limiting device: Back to back…

Q: Calculate the active power of a three phase 130V source operating at a leading power factor of 0.81…

A: Voltage source = Vs =130V current =Is = 10 amps power factor =cos ϕ= 0.81 leading

Q: A series RL - C circuit has R = 50 M, L = 100 µH and C = 1 µF. the lower half power frequency of the…

A:

Q: Assume the following blocks with labeled signals are already provided. Volts V Voffset e + T 3 Ym y…

A: Types of controller P controller  I controller D controller  PI Controller  PD Controller  PID…

Q: For PIC 16F84A, the 8 level Stack Ob Program counter. OC W register. O a holds the program return…

A: 1) For a PIC microcontroller, 8 level stack holds the program return address when a subroutine is…

Q: Given the circuit below and the associated set of voltages and currents, the reactive Power…

A:

Q: For the network given in the following figure, Re is equal to RT Μ 9Ω ΖΩ • 7Ω

A:

Q: A level-measuring transmitter has a linear I/O graph. The input range is 5.0 to 10.0 meters (m and…

A:

Q: 5. Draw Butterfly diagram for FFT & IFFT of eight points.

A: Butterfly  diagrams For FFTFAST FOURIER TRANSFORM AND IFFT INVERSE FAST FOURIER TRANSFORM.

Q: estion 2 ress is, i₁ and i2, in terms of vs, R1, R2, R3, and Rs. Given that vs=60V, R₁=60, R₂=20,…

A:

Q: Which of the following is the output voltage vo(t) when vi(t)=u(t) is applied to the input of the…

A:

Q: data in a decimal value of 5 is given. determine its 7-bit hamming code. assume odd parity

A:

Q: The one-line diagram of a simple four-bus power system is shown in the Figure. Each generator is…

A: Bolted three phase fault is occurred at bus 4.   Before fault, We assume the voltage at buses are =…

Q: draw truth table and circuit diagram using d flipflops of two bit counter that counts from 35 till…

A: D flip flops:

Q: 014: The time (in s) required for the current to get its one fifth initial value is: ontbele erit to…

A:

Q: The drawing shows two situations in which charges are placed on the x and y axes. They are all…

A: Given the two situation of charge configeration  distance between the charge and origin is 5.40 cm

Q: A short transmission line connects a step-up transformer on the source side with a series impedance…

A: A Short transmission line connected to (i) a step-up transformer on the source side with a series…

Q: Q-6 b, Consider a negative unity feedback system with forward path transfer function K G(s) = where…

A: Given- A negative unity feedback system with forward path transfer function. Gs=Ks+as-bs+c, To Find-…

Q: i₂√ ² R3 14 J3 V₁ G TIA V₂ TiB 3R₁ 2 Rz Given R₁ = 8.6 KSL R₂ = 2.2 k R3 = 12 k R4 - 47k VA = 10 V,…

A:

Q: Find the maximum power that can be delivered to the resistor R in the circuit shown.

A: In this question We need to determine the maximum power delivered to the resistance R.  We know For…

Q: If the turn ratio of a step-down transformer is 30:1 and the no-load primary current is 1.25 A, the…

A: Given:  Transformer primary turns, n1= 30 Transformer secondary turns, n2= 1 No load primary current…

Q: Drive an expression for maximum torque for synchronous motor. What happen when increasing the load…

A: In the case of the synchronous machine, windings are always connected in a star connection. The…

Q: Create a list of at least three analog-to-digital conversion methods. Explain the thinking behind…

A: Introduction Analog-to-digital (A/D) conversion Analog-to-digital (A/D) conversion is the process of…

Q: A 220kV, 50Hz, three-phase transmission line is 50km long. The resistance per phase is 0.150/km, the…

A:

Q: Let x(n) be the sequence x(n) = 28(n) + (n − 1) + 6(n-3) Find the sequence • y(n)= x(n) 5x(n) i.e. 5…

A: given that  x(n) be the sequence     x(n) =2δ(n) +δ(n-1)+δ(n-2)     To find the sequence:…

Q: Consider 2/3 rate convolutional encoder as shown in figure below with generators: [9₁] = [1 011].…

A: According to the question, for the given figure as shown below we need to describe the convolution…

Q: The interference by the power lines surrounding the measurement system as well as interference from…

A: As per guidelines given to us we can only provide the solution of first question in multiple type of…

Q: What is v3 in the following circuit 12 V της ν www 20 Ω 10 Ω 6V +) 40 Ω 309

A:

Q: Is this armature winding a progressive or a retro-progressive winding? 513- Ripost Select one: O a.…

A: Note: Let one conductor of a slot is connected to a then  For progressive winding, other one will…

Q: Find the average power absorbed by the resistor R R = 90 52 50/0° V (rms) O a. 1.5 W O b. 4 W OC. 1…

A: The equivalent resistance of R seen at primary side is:  R'= (1/2)2 R= 90/4= 22.5 ohms  Then voltage…

Q: G(s) R(S) K(s+b) s(s+a) G(s) C(s)

A: given that unit feed back system has forward path transfer function    G(s) =K(s+b)s(s+a)…

Q: Find the state-space representation of the network shown in Figure (b)if the output is VL(t)

A:

Q: A 480V, 60 Hz, 6-pole, three-phase, delta-connected induction motor has the following parameters:…

A: Introduction Thevenin's Theorem: It states that any linear electrical network can be reduced to an…

Q: Locate the closed-loop poles on the root loci such that the dominant closed-loop poles have a…

A:

Q: As a mobile node moves farther from a base station, what are two precautions the latter might take…

A: The fundamental characteristics of data transmission depends on Accuracy  Timeliness Delivery…

Q: R₁ W C₁ Ao - Vout The circuit shown above is used to amplify a sinusoidal input by a factor of 5. If…

A:

Q: a-Given W123 =W256, solve for x? b- A portion of music signal is sampled at 10M Khz and analyzed…

A:

Q: Suppose That X is a random Variable with a PDF given by (B) fx(x) =___ 2b Then The moment generating…

A:

Q: In the voltage limiting devices, for or 12 breakdown voltage we use Oa. Gas-discharge tube O b.…

A: For low breakdown voltage: Parallel silicon diode is used. For moderate breakdown voltage: Back to…

Q: Example 4.2: A communication source produce information in the form of encrypted data using three…

A: Given: Three symbols (L, M, N) and their probabilities, and conditional probabilities,  To find:…

Q: A level-measuring transmitter has a linear I/O graph. The input range is 2.0 to 32.0 meters (m and…

A:

Q: Compare the nested and the NPC topologies in terms of the blocking voltage for the switches employed…

A: We need to compare NPC and Nested topology.

Q: A balanced three-phase source is supplying 6KVA with 0.8 pf leading to 2 balanced Y-connected…

A:

Q: In the circuit shown below, Vs = 120245° V, ZA = 2215° £2, Zɛ = 10 − j5 £2, and Zc = 8 +j6 22. ZA ZB…

A: Given circuit ZA=2∠15ZB=10-j5 Zc=8+j6VS=120∠45

Q: 24 R(s) 7 (5+3) (5+4) D(s) 8 s(s+2) C(s)

A:

Q: A 3-phase transmission line has conductors 1.1 cm in diameter spaced 1 m apart in an equilateral…

A: The transmitted voltage is only half as powerful as the reflected voltage, which is equivalent to…

Latches and Flip Flop

Just like logic gates, the latches and flip-flops are the important elements of an electronic circuit. The logic gates form the important part of combinatorial circuits, while the latches and flip-flops form the essential part of a sequential circuit. Sequential circuits form the important concept of automata theory in electronics and electrical engineering, these circuits are a kind of logic circuit whose output depends on both present input and past inputs, that is, the input history.