Find the voltage and current using KVL and KCL.

Q: 100 V | + 6Ω ww 9Ω ww 20 Ω www 4A 30 Ω www 25 V

A:

Q: (a) Given a discrete-time signal x[n] as: = (-/-)” u[n+ 1]-(3)"u[-n-1] Determine the z-transform of…

A:

Q: Considering the resistor network below a) b) 15V = Calculate i R4 iR4 R1 Ω 100 R2 mA R3 What the…

A: The circuit diagram,

Q: 29-2: Using two 74163s, implement the following counting sequence: 0 1 2 3 4 → 121 122 123 254 2550…

A: According to the question, Using two 74163s, implement the following counting sequence:0→1→2→ 3→4→…

Q: A surface search radar has the following characteristics: i. Frequency = 5 GHz (C-Band - vertical…

A: For the given information about a surface search radar we need to plot the SNR (in dB, y-axis)…

Q: a) Determine the condition of (k), so that the following system is completely controllable. = ° +] u

A:

Q: The dc backup generator that supports the local servers in the centre directly supplying a dc…

A: Given Data:A DC generator has,Armature resistance Shunt resistance Series resistance Brush drop The…

Q: In the following circuit, the amplitude of the square signal is, R1 ww 4.7k2 2 R2 ww 10k VCC 12V…

A: According to the question, for the given OP-AMP circuit as shown belowWe need to find the amplitude…

Q: Q1/B: For the circuit shown below, find i, (t) and v₂ (t), given that v₁ (t) = 10 cos wt and i₂ (t)…

A:

Q: consider an array of two indentical infinitesimal dipole oriented as shown find The nulls of the…

A:

Q: 1. Give an example of how the traditional current-mode DAC will have limited output swing. 2. Show…

A: "Since you have posted a question with multiple questions, we will provide the solution only to the…

Q: Make a list of all electrical appliances at home Do a research on each appliances and record the…

A: Most used electrical appliances:Ceiling FanLEDair conditionerIron BoxGeyserRefrigeratorTelevision

Q: 3. Discrete time system process, the difference equation is yn+2 +Ya+1+y=n²+n+1 find the output of…

A: The given difference equation is Find the output of system using method of undertermined…

Q: Find Gain K and Ts settling time and dominant poles s=-2.91+j5.77 with 20.5% OS,

A: The given block diagram is shown below.Percentage overshoot is.The dominant poles.We need to…

Q: Q5// a) Draw the simplified hazard-free circuit of F(A,B,C,D,E)=(4,6,20,22,28,29)

A:

Q: Use source transformations to find the Norton equivalent circuit with respect to the terminals a, b…

A:

Q: A- Sketch the single-sided and double-sided spectra for phase and amplitude of x(t)= 5 cos(30mt +…

A:

Q: 4. Determine E, I and power dissipated in resistor R=2 ohm

A: Given circuit is shown below:

Q: Rab=? 803 80 Ba 120 www 40 www 40 www 60 80 www 40 100 wow 50 10 www 801 www 911 www 60 120 100 18…

A: Find the value of Req of the given circuit

Q: W 1-8 A voltage source given by v(t) is connected to a series RC load. Obtain an express c(t), the…

A: In this question, we need to determine the voltage across the capacitor C in time domain. Capacitive…

Q: Shown in the figure below is an electrical circuit containing three resistors and two batteries. Į₁…

A: Given Data:           A DC resistive circuit with,Voltage sources, To Find:The Kirchhoff…

Q: 3. Find the value of V1, V2. and v3 of the following circuit by the node voltage method. 4Ω Μ 28 V +…

A:

Q: The following figures show the diagram of the stator and the rotor of a two-pole DC machine at two…

A: For the given DC machine diagrams, we need to determinethe number of parallel paths in the armature…

Q: please replicate this schematic diagram in TinkerCad. please do leave some notes to better…

A: The given circuit is shown below.We need to build this schematic diagram in TinkerCad.

Q: For the circuit shown below, using the values given, calculate the power dissipated by the load…

A: Given:A circuit, with, To find:Power dissipated by the load resistance RL.

Q: Perform the following computation on 8-bit numbers (the encoding is irrelevant here). Write down: i)…

A: In the given questions we need to add the 8 bit binary number.

Q: 2. Compute the values of battery current I for the following circuit when a. Switch S1 is open b.…

A: The circuit diagram,

Q: Use Logic.ly to implement the shown (picture provided) 4-bits adder. Verify the logic behavior of…

A: According to the question, we need to explain the working of 4-bit parallel adder circuit.

Q: What is an ideal diode? The ideal diode acts as an open circuit for forward currents (with voltage…

A:

Q: Eut arm A 017 (1-D) 02 EA 1. arm 03 (1-0) 04 D 2 For a 4 Quadrant DC to DC converter (figure above):…

A:

Q: The switch in the circuit below has been open for a long time. At t=0 the switch closes…

A:

Q: 1. For the following circuit where Vs= 2 V, calculate v(t) for t> 0. Using the method of general…

A: Vs=2VWe assume initial condition ZERO as No data given:I_L(0)=0A and V_c(0)=0V \)"…

Q: A part of a 50 Hz power transmission and distribution system is represented by Figure Q3a. The…

A:

Q: E7.2 Use the differential equation approach to find v(t) for t> 0 in Fig. E7.2. Plot the response. 6…

A: At , the switch is closed. Since the switch had been closed for a long period, thus Capacitor…

Q: A single phase, 50kVA, 1000V/100V two winding transformer is connected as an autotransformer as…

A: In this question, we need to determine the rating of auto transformer. we know rating of auto…

Q: P3 for a dipole antennd of 3m long Jo=gA determine Power radiation, radiation resistance directivity…

A:

Q: Calculate the PMOS device width to achieve symmetric propagation delays in an inverter (tPLH=tPHL).…

A: Calculate the PMOS device width to achieve symmetric propagation delays in an inverter…

Q: 3. (Matlab) Generate 1000 realizations of a sine-signal in additive noise. Calculate the autocor-…

A: It is asked to generate 1000 realizations of a sine-signal in additive noise and calculate the…

Q: Explain the fundamental differences between open-loop and closed-loop control systems. Provide…

A: Open-Loop Control System:An open-loop control system is a type of control system where the control…

Q: What is the I total

A: For the given series RLC circuit the value of total current needs to be calculated and the same can…

Q: Problem set 1 Compute the line voltages and currents of the load. 208/-240° V rms 0.1 Ω α 0.1Ω ww be…

A: From the given data,Here, line currents,To find:Find the line voltages

Q: Find the a parameters for the circuit in (Figure 1). Suppose that R₁ = 1 kn, and R₂ = 39.9 kn. »…

A: The two port network isWe need to find a-parameters of the circuit and then need to write a11.

Q: The switch in the circuit has been closed for a very long time and is opened at t = 0. Find i(t)…

A: The given switch in the circuit has been closed for a very long time and is opened at Find  through…

Q: 120/0° V rms 30+j12 (2 309 rele 1000 turns 200 turns 20-140

A: For this ideal transform circuit we need to calculate the average power delivered to load Circuit:-

Q: what is op-amp and its characteristics?

A: An Operational Amplifier, often abbreviated as op-amp, is an electronic component widely used in…

Q: Q.14 Consider the following Assembly Language program. MVI A, 30 H ACI 30 H XRA A POP H After…

A: An assembly Language program is given below,An assembly Language program is given below,MVI A, 30…

Q: • Design a combinational circuit with four inputs and one output. The output is equal to logic 1…

A: For the given conditions the logic circuit needs to be designed and the same can be calculated using…

Q: (c) For the IEEE standard (1985) for double-precision (64-bit) arith- metic, find the smallest,…

A: According to the question,(c) For the IEEE standard (1985) for double-precision (64-bit) arith-…

Q: A source vs =10V is fed to a voltage divider implemented with Ra= 120 kilo ohms and Rb= 30 kilo ohms…

A: According to the question, we need to design a circuit for the given data.source voltage vs =10V;…

Q: What is the inverse Laplace transform (¹) of the following function? 8-6s = 2 s² + 11s-6 F(S)

A:

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.