find the equivalont capacitunce Call Capacitord are in uF). 69 26 a o 50 20 12 30 %23
Q: Cy = 35 MF Cs -50 MF %3D CI= 25 MF C3 :25HF C2 -35MF V= 80 v
A: we need to find voltage and charge of each capacitor
Q: Average dissipated power taken by the pure capacitor is O Minimum O Zero O Rate O Maximam
A: What is average power dissipation by the pure capacitor? Choose the correct option.
Q: Inductor offers zero inductive reactance to d.c. signal. Select one: O True O False
A: The explanation is as follows.
Q: Calculate the ripple of a capacitor filter for a peak rectified voltage of 40 V, a capacitor of 80…
A:
Q: 7ee A SI 36vE
A:
Q: c) For the case in b) determine the value of the capacitor C.
A: Solution b)For Max ripple Vrpp=Vop-Vomin So Vomin will at IZ=IZk=0.1×IZmax IZk=0.1×0.133=0.0133A
Q: In the circuit given below, what should be the minimum value of C1 capacitor so that this capacitor…
A: Given, f= 797 Hz fmax=12πReqC1min Req is total resistance seen from the C1 i.e.,…
Q: 5. What is the equivalent capacitance between the terminals ab. 10C 3C 20 12C
A: If two capacitors C1 and C2 are connected in parallel than equivalant parallel combination capacitor…
Q: the capacitive reactance value is and the When the frequency is inductive reactance value is a)…
A: In this question we need to choose a correct option
Q: -- late inductor and Goprcitor voltjn thae el He energy sturrd the in
A:
Q: AU Resispnceo =2n %3D Rz Find the exforeion $ cquivalend esitam thevalye op equiral 9. Ry reistauu
A: We are authorized to answer only one question at a time, since you have not mentioned which question…
Q: A 100- resistor, an uncharged 100-µF capacitor and a switch are connected in series across a 24-V…
A:
Q: capacito capaciti lect one: True False
A: Capacitive reactance given by Xc = 1/wC. As Capacitance increases Xc decreases
Q: Calculate the voltage across each capacitor in Figure 1. 50μ F 40μ F 10μ F +V1 - + V3 - + 90 V 20μ F…
A:
Q: A supply of 240V-50HZ feeds a highly inductive load of 502 througlH thyristor bridge that is…
A: The solution can be achieved as follows.
Q: A 20uF capacitor is fixed to a 500nC load. What is the capacitor voltage?
A:
Q: Perform a parallel connection Connect (C2) polarized capacitor in parallel to the existing capacitor…
A: First of all This circuit may consists unknown network which is in parallel with existing…
Q: Active power for pure capacitive load is calculated as a. 0.6 b. one c. 0.8 d. zero
A: For a pure capacitive load, the current leads the voltage by 90 degrees. So, the angle between…
Q: For the following circuit L=51 Determine the equivalent inductance L A c L L L B Lea Leq=?
A:
Q: Vs 10㎏Ω C1 5Vpk 100HZ 0° :0.22µF
A: During positive cycle of applied sin wave Capacitor C1 will charge through Resistor R1 and it will…
Q: Which of the following is true for pure capacitive circuit? O a. Current lags the voltage by 90…
A: Given IC (t) = Capacitor Current Vc(t) = Capacitor Voltage The relationship between…
Q: capacitor vo(t).
A:
Q: C1 10 Silicon R1 V1 Vout V2 50 20
A:
Q: (a) the voltage across each capacitor and (b) the energy stored in each capacitor. 60 µF 20рF 30 р.F…
A: Solution: Consider the given circuit:
Q: correct the power factor
A:
Q: Which of the following is the type of capacitor whose capacitance value can be adjusted? A)…
A: Given To find the type of capacitor whose capacitance value can be adjusted
Q: For the inductor in the figure, find the inductance L in henries. 1 = 100 mm Air core d = 5 mm 200…
A: This is a basic problem of electromagnetism. The solution is shown in the next step
Q: A 10-uF capacitor has an accumulated charge of 500 nC. Determine the voltage across the capacitor.
A: The capacitor is a charge storing electrical element. when the capacitor is connected across…
Q: A cholce Coil is conuected in seues with 20uf capacitor. weith the constant supply voltage of take…
A: In RLC circuit at resonance the inductive reactance is equal and capacitive reactance. Dynamic…
Q: + 48 V E C7 4 kN C27 0.04 µF 0.08 µF
A: V=48V C1=0.04μF; C2=0.08μF R1=2KΩ; R2=4KΩ; to determine charge on each capacitors
Q: The charging and discharging rate of a capacitor with same input voltage depends on the Power…
A: The time constant of a RC circuit is defined as the product of resistance(R) and capacitance (C).…
Q: 4. Refer to the graphic in the Appendix (B). Determine the total capacitance in the circuit 124 pF…
A: The solution is given below
Q: A plate capacitor is made up of 501 sheets of aluminum 25 cm x 30 cm with a dielectric of paraffin…
A: given capacitor
Q: Capacitance is measured in Ampere. O True O False
A:
Q: Use (C1) polarized capacitor. Provide one battery rated 9v, Connect one end of switch 1 to the…
A:
Q: changes its physical capacitiv ges in temperature t one:
A: Thermistor is useful for measuring temperature.
Q: 20 mH 100 mH 40 mH rell Lea 50 mH 40 mH 30 mH 20 mH
A:
Q: Find the equivalent capacitance for the following circuit. Round the final answer to the nearest…
A: If capacitance are in series, then the total capacitance is, 1Ceq=1C1+1C2+1C3+⋯+1Cn If the…
Q: Identify the type of capacitor which is used in high frequency application. O a. Electrolytic O b.…
A:
Q: r eut 20 Cm 1Ocm 1oum /111/ 下 A capacitur is mnde by sandwiching a sheet of two sheets of aluminum…
A: A capacitor is made by sandwiching a sheet of wax paper between two sheets of aluminium foil , as…
Q: The opposition of a capacitor to the flow of a. c. current is called: O a) reluctance. b) reactance.…
A: We need to select correct option.
Q: inductor? 5.00 V 20.00 mV
A:
Q: State the values of the capacitor using the following IEC code: a) b) c) d) e) 504M2 6R8F 103M 472J…
A: The IEC code is used for SMD capacitors and vendors for a standard code scheme to identify the…
Q: What is the effect of increasing voltage source frequency on the reactance of a capacitor? decreases…
A: Given that What is the effect of increasing voltage source frequency on the reactance of a…
Q: P2 Calculate capacitor voltage in transient. The switch is turned on at t=0. Assume: e(t)=100 V,…
A: Given: A circuit in which e=100VR1=20ΩR2=40ΩL=1HC=0.1F According to question: Before t=0 circuit was…
Q: Q6) The waveform of the voltage obtained after rectification is of a -----nature and therefore…
A: AC signal has both positive and negative half cycle where as dc has only positive voltages.…
Q: The capacitor in Figure 23.55(b) will filter highfrequency signals by shorting them to earth/ground.…
A: The capacitor can be used to block the DC component between the two cascaded circuit and it can also…
Q: 1. Determine total capacitance looking at the terminals 'a' and 'b' of Figure 1. 94 16 14 18 12 16…
A:
Q: a film type capacitor is marked 253 h what are the capacitence value and tolerence of this capacitor
A:
Step by step
Solved in 3 steps with 3 images
- C'uk Converter Design A C'uk converter has an input of 12 V and is to have an output of - 24 V supplying a 60 W load. Select the duty ratio, the switching frequency, the inductor sizes such that the change in inductor currents is no more than 12 percent of the average inductor current, the output ripple voltage is no more than 1.5 percent, and the ripple voltage across C1 is no more than 3 percent.What voltage is boosted at the output of a multiplier.Choices: average, rms, peak, or instantaneous Which assumption is not used in the analysis of multipliers?Choices: a capacitor will not discharge, start with the cycle of the source that will forward bias the nearest diode, the output will always be multiplied, or a single diode is forward biased at a time A voltage multiplierChoices: multiplies the output voltage, has very high voltage and low current ,can employ inductors, or may not have equal numbers of diodes and capacitors A voltage regulator maintains constant voltage at the load regardless of variations atChoices: the input and output, the load, source, or in the environment Between a lower percent regulation and a higher one, which is better?Choices: lower or higherFor a sinusoidal input of 40 V (p-p) to the given circuit, what is the minimum value of the output waveform? NOTE: use ideal * diode 0.7 30 20 -5 -40 K 16
- 5. Design a diode clipper circuit which produce the following output for a sinusoidal input Transient mmm 6 4 -4 -6 Om 1m 2m Time (s) 3m 4m 5mA clipper circuit based on diodes are simple way to modify waveform in mechatronics. Assume that the two diodes shown in the circuit below are ideal diodes. If the input voltage in the circuit is a 1 kHz sinusoid with peak amplitude of 8V, sketch the Vaue (t). 10 k. 8V 10 kN. D2 RL Vourlt) Vin= Vin(t) Ims D1 6V -8V 4V Page | 1A clipper circuit based on diodes are simple way to modify waveform in mechatronics. Assume that the two diodes shown in the circuit below are ideal diodes. If the input voltage in the circuit is a 1 kHz sinusoid with peak amplitude of 8V, sketch the Va.. (t) 10 kO 8V 10 kO Vin Vin(t) D2 Vout(t) RL Ims D1 6V -8V 4V Page | 1
- The voltage signal coming out of the capacitor is with small ripples compare to the voltage signal out of the diode. True Falsemaysons rule and reduction block diagramHalf-wave 50Hz sinusoidal uncontrolled rectifier circuit with a peak voltage value of 100V and a source inductance of 8mH is feeding a highly inductive load of 8A. The average value of the output voltage and power delivered are, respectively and what is the communication angle (u) Power Electronics
- A 10 V peak-to-peak sinusoidal voltage is applied across a silicon diode and series resistor. The positive peak voltage across the diode is а. 9.3 V b. 4.3 V c.0.7 V d. 10 VUsing a positive Clamper Circuit, with an AC voltage of Vi = 100v with a frequency of 30hz, a value of 1000u for the Capacitor, a silicon diode and a resistor with the value of 100 ohms. Find the voltage value on the resistor at a simulation of Oms. Vm 2Vm Vo -Vm Input Waveform Output Waveform Positive Clamper circuitwrite ALP to calkyate the ho. of ones and Zeros in an 8 but number 9808 h948th