Find iL(t) for t> 0 for the circuit of Figure P 9.6-3b. Assume steady-state conditions exist at t = 0.

Q: please show the solution and answers in each. Thank you

A:

Q: Whale and Kanmuro are two islands located in the Chimera archipelago. These two are separated by a…

A:

Q: 3. I don't have a driving licence. I can't drive you there.If I. driving licence, I could drive you…

A:

Q: Describe the job of the Board of Electrical Engineering in one sentence. Note: The Board of…

A: It is asked to describe the job of the Board of Electrical Engineering in one senctsen.

Q: Grateful help with Part B please.  Thanks

A: Characteristic impedance is a property of the material that determines whether or not it can…

Q: What is sub station

A: A power station is to provide electricity to a huge number of people. Different customer’s power…

Q: An electric train system (ETS) in Japan with a span of 10 miles long is connected to a two…

A:

Q: Can we replace the Fossil Fuels? How?

A: Can we replace the Fossil Fuels? How?

Q: Grateful a little help with this homework thanks.

A:

Q: Please read the following questions carefully and then elaborate on cach of 1-Describe wireless…

A: Some technical challenges that a wireless communication faces are  i)multipath propagation…

Q: Consider the circuit given below, where R= 12 Q. NOTE: This is a multi-part question. Once an answer…

A: Nortons Theorem states that “Any linear circuit containing several energy sources and resistances…

Q: A high voltage transmission line transmitting 10 MW of power operates at a voltage of 105 KV…

A:

Q: Can you help me with questions two and three please?

A: Present StateNext State (UP)Next State…

Q: What is a FET

A: The modern day devices have enabled us an easy life. The devices have various electronic components…

Q: Inverting Op-Amp R₁ R₁ Vo R2 R4 998.48m V R2 R3 9.9844 R1 R4 2.1244 out of phase A(gain) A(gain)…

A:

Q: What is the difference between passive and active buzzer?

A: A passive buzzer requires an ac signal to make a sound. A passive buzzer does not generate a tone by…

Q: Q21 Fill in the following blanks (Answer 5 only) 1.Switches in terms of number of contacts and…

A: Power system transfers power from the source end to the load end. Protection of the power system is…

Q: 5 - What should be done first when a person being electric shocked seen? A) Cut off the electricity…

A: If we seen person being electric shocked then we need to do take some necessary action

Q: Can I ask a simple basic problem solving on Voltage Multipliers

A: Yes, you can ask problem on voltage multipliers.

Q: question: Suppose that you want to sort blocks of different heights automatically. How can this task…

A:

Q: Write a paragraph about your hopes and ambitions. In about 100 words

A: Hope and ambitions are the most important part of any human which can include the happiness of…

Q: d) None of these. 5. Materials which easily allow the passage of electric current are known as: a)…

A: Answer 2- The power is defined as a rate of doing work.  So, option (c) is correct.   Answer 4- An…

Q: Is there a way to clean up this answer by using proper notation

A:

Q: A room measures 4mx5mx5m and the air in it has to be always kept 20 C0 lower than that of the…

A: Given Data : Volume of the room = 4mx5mx5m density of air = 1.27  kg/m3 specific heat of air  =…

Q: Which of the following is an example of analog data? a.The number of pens in your pencil case.…

A:

Q: Look at the photo and answer the questions

A:

Q: V1 Op-amp V; = 0 Rf R1 R1 Fig. 3.11 (a) Non-inverting amplifier (b) Equivalent circuit with virtual…

A:

Q: Show the following units in scientific notation. e.g ) Five Kilometre (km) = 5 x 103 m 1) One…

A: Consider solving the problem by using the second notation (which decides the exponential power of…

Q: Can you please further explain this section.

A:

Q: The circuit shown in Figure Q5.1 consists of a current source connected to a load via a cable. The…

A: Given circuit is - Value of current source is -

Q: A protective put can be used for risk management.   A. TRUE B. FALSE

A: ANSWER      TRUE          A protective put can be used for risk…

Q: Hi for case 3 is explain on which question ? either (a) positive or negative or for question (b) pls…

A:

Q: List at least 5 research topics that are connected to Electrical Engineering.

A: 1. PM machines with high power and high speed  PM machines or Permanent Magnetic machines have…

Q: In an electrical system, each of the service entrance conductors has an area of 750 kcmil. The size…

A: Given: In an electrical system, each of the service entrance conductors has an area of 750 kcmil.

Q: Still confused about how you calculated the current. Could you please elaborate a little? thank you

A:

Q: please tell me a similar app to solve engineering questions?

A: Bartleby is the best app Bartleby is the best app

Q: b) With sketch of diagram, show the number of resistor and switched would be required to implement…

A:

Q: Q3: What is a synchronous circuit?

A: I hope you asking synchronous circuit in terms of digital circuits, you have not stated it so I am…

Q: Which one of the following is the definition of slurry? a. Water only b. Animal waste (Dung) only c.…

A: definition of slurry

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.