Field current(A) 1 2 3 4 7 8 O.C.C. Volts(V) 52.5 | 107.5 | 155 So tor the same tield current the oc c oññ en mi toll | 196.5 231 256.5 275 287.5 Fiela curreunI 3 4 6. 7 8 O.C.C. Volts(V) 42 86 124 157.2 184.8 205 220 230

Q: Two single-stage capacitively coupled amplifiers like the one in the figure below are connected as a…

A: The circuit is as shown below,

Q: Q3: For the system of Figure 1, given G(s) = s+8 and C(z) s+5 0.35z %3D %3D z-1 Find the closed-loop…

A: Given data :    G(s)=s+8s+5    C(Z)=0.35ZZ-1

Q: In the circuit of Fig. 13.98, find the value of the coupling coefficient k that will make the 10-2…

A: The coupling coefficient can be calculated by using the basic laws after converting the inductor…

Q: 2) It is required to use a capacitor with Vms = 12V. Select a suitable voltage rating capacitor from…

A: Capacitance can charge upto the Vmax of the input supply during charging stage Capacitance selection…

Q: Calculate the voltage at the terminals of a coil of resistance 10 ohms and inductance 15H at the…

A: In this solution the concept related to the practical inductor is discussed

Q: 5. For the circuit below, calculate (i) the current from the battery. (ii) the terminal po…

A: In this question, we will find current from the battery , terminal potential of battery and power…

Q: sap please with proper explanation

A:

Q: 4. a) Define the function of opamp circuit given below. b) If the voltage gain is 50 for the circuit…

A:

Q: E8.21 Find V, in Fig. ES.21 using mesh analysis. 24/0 V j4n j20 60 4 2 VA V,-j20 2 VA Figure E8.21

A: given here a circuit and asked to find the value of Vo in the circuit.

Q: 3) A 120-V, 50-Hz single phase induction motor (split -phase) has the following constants for the…

A: Single phase induction motor is not self starting motor The Resultant starting torque is zero To…

Q: A 6 pole, 3-phase, 60 Hz wound rotor induction motors delivers 25 hp at 1150 rpm. If the rotational…

A: In this question,   We need to determine the rotor input power in KW? If rotor speed N= 1150rpm

Q: PROBLEM: Determine the validity of a second-order approximation for each of these two transfer…

A:

Q: 4. Complete the timing diagram for the gated SR latch based on the Table 4. Assume that the input…

A:

Q: 4. A balanced Y-connected 400V voltage source is applied to two balanced loa where Z, = 20-j40 and…

A:

Q: QUESTION S: 1. what would the voliage be at the tapped middie point? R,= 132 2. what is Vo (peak) if…

A: It is given that: Vppri=100 V

Q: Calculate the total offset voltage for the circuit shown below for op-amp specification values of…

A:

Q: 2-A 33 kVA, 2200/220V, 50HZ single phase transformer has the following parameters. Primary winding…

A:

Q: Using an AC voltmeter, the potential difference in the electrical line in a house is read to be 234…

A: Given an AC voltmeter with, Potential difference, Vrms=234 V Hence, peak voltage, Vm=2Vrms=331 V…

Q: _7. Determine the magnitude of a point charge which experiences an electric field of 200 V/m at a…

A:

Q: 1. Ifa field excitation of 10 A in a certain alternator gives a current of 150 A on short-circuit…

A: NOTE:  As per our company guidelines we are supposed to answer only one question.kindly repost other…

Q: Question Implement the Function 'Y = ACB + BC + E' using a 4-Input, 2-Address Bit Multiplexer. What…

A:

Q: I cannot understand it

A:

Q: 10. Find V, for the circuit given below. 50 k2 ww 50 k2 ww ovo n ww 20 k2 20 k2 V1 = 2 V, v12 = 4 V,…

A: We need to find out output voltage for given circuit

Q: What is the minimum Sum-of-Products equation for the Function 'Y = BAC + F + BC'?

A:

Q: Given: V1 = Vpeak sin wt V Vpeak = 5 V With the ideal foward voltage = 0.7V, draw the waveforms of…

A:

Q: RL 2. Vin is a 1kHz - 100 volt (peak- amplitude; 1 kHz) sine wave. The Triac X2 has the following…

A: In this circuit the operation & concepts of the given TRIAC circuit is discussed along with the…

Q: If Rx=80 KQ, find the value of Vo. How large Rx be to avoid saturation if the maximum output is 10…

A:

Q: H.W.(9): Find the bandwidth and center frequency of the bandstop filter of Fig. 4 F 42 (Answer: B =…

A: The circuit diagram is shown below,

Q: Calculate the power supplied to the 10 2 resistor in the ideal transformer circiuit of Fig. 2. 20 2…

A: The basic transformer problem can be solved by using mesh analysis.

Q: • Draw the single line diagram of a substation having the following equipments: i) Incoming lines:…

A: Solution -

Q: A Hertzian dipole of length dl0.5 m is radiating into free space. If the dipole current is 4 A and…

A: Given data: The length of the dipole is:dl=0.5 m   The dipole current is: Io=4 A The frequency is:…

Q: 4. A balanced Y-connected 400V voltage source is where Z, = 20-j40 and Z2 = 3+ j45 Ohms a connected.…

A: In this question we will find source current in per unit....

Q: Find the X(t) gonometric Fourier eries of the periodic signal in figure 5. 3 2 4 -4 -2 -3 Fig- 5

A:

Q: A mobile phone base-station is on a 11 m high mast which stands on top of a hill of height 32 m…

A: Given data:  The mobile phone  base-station=11m  The hill of height=32m The sea-level…

Q: Thermal question. A system has two thermal layers. The first layer has a Rth 0.5 K/W, and Cth 0.8…

A: Thermal: Thermal refers to something that is caused or affected by heat or temperature. In science,…

Q: +Vcc Vin V, Vo Vref Vy -Vcc Ry Rxl Fig. A2c: Inverting Schmitt-trigger circuit.

A:

Q: If V, is 9V, find the following values Vp, Vn, Vo- 50 ka 20 ka 10 kn 40 kQ.

A:

Q: Given the potential field, V=2xy-20z, and a point P(5, -10, 2), find the value volume charge density…

A: This is the basic question related to the volume charge density where the potential field  is given…

Q: IS 15. The electrolysis of water produces A. gaseous water B. H2 and O2 gases C. electrically…

A: Electricity is used for electrolysis Electricity is passed through the water Then water is…

Q: _10. Determine the magnitude of the electric field intensity of an infinitely long, straight line…

A: Electric field due to a uniform line charge is determined by gauss law. It is inversely proportional…

Q: Two lamps are placed 100 m apart. Lamp A and lamp B have luminous intensity of 150 and 450 candelas…

A:

Q: device that selects one of many inputs and links it to a single output. a Display of seven segments…

A: This is the question regarding digital circuits thete are basically two types of digital circuits…

Q: Vse ä de lta modulatin To Convert the following Signd Sin (2TT=2000¢)

A: The block diagram/schematic for converting the given analog signal into a digital signal using delta…

Q: wo wattmeters are used to measure powe running on full-load at an efficiency of 8 nd 80 kW…

A:

Q: 1- Define voltage regulator ? what is its main job? 2- How can we specify the quality of voltage…

A: As per the honor code I will attempt first three questions. Kindly repost the other questions again.…

Q: H-ws A Soleneid loie emindinmeter&75.0 0on long is made Bvom Copper wire of diameter o-looem with…

A: Given that; Solenoid diameter D=10.0cmSolenoid long L=75.0cmMagnetic field=8.00 mTcopper wire…

Q: lo A V1 12 = 0 AC

A:

Q: Example: A do MVA, 3-phase, Y-connected, two-pole, Go HZ, 13.8 KV, Line - to-Line turbogenerator has…

A: Given  rating  v= 13.8kv                  P=10 MVA…

Q: A 20 ohm resistance R and a 0.001 farad capacitance Care in series. A direct current voltage E of…

A: In this question we need to find a resulting current i(t) at 10.01 sec for the given series RC…

Q: The resistance of a wire with length of 2.3 mile and diameter of 0.7 in and ? conductivity of 8.20…

A:

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.