F14-9. If the motor winds in the cable with a constant speed of v = 3 m/s, determine the power supplied to the motor. The load weighs 100 N and the efficiency of the motor is ɛ = 0.8. Neglect the mass of the pulleys. D B. A v = 3 m/s %3D E M
Q: What W is necessary to start the system of blocks moving to the right? The coefficient of friction…
A:
Q: D. What is the minimum amount of work the motor has to do in order to raise the elevator this high?…
A:
Q: Turboprop engine with free power turbine has the following data: H = 6 km mila = 3 = 15 kg/s T₁ =…
A: ESHP- ESHP is known as equivalent shaft horsepower and it is calculated as, ESHP =…
Q: A single-cylinder reciprocating engine has a reciprocating mass of 6 kg. the crank rotates at 60 rpm…
A:
Q: As the time required to run up stairs increases, the power developed by that person a…
A: The question is asking about the relationship between the time required to run up stairs and the…
Q: What are the smallest positive values of the unknown phase constants 1 and o2 (in radians) such that…
A: Given The maximum displacement occurs at the origin (x = 0) at time t = 2.67 Find ϕ1 and ϕ2. Two…
Q: maximum
A: Point B has maximum kinetic energy At point B particle has maximum velocity so kinetic energy is…
Q: The 8-kg block is acted upon by a 100-N force as shown in Fig. 17-34. If the coefficient of sliding…
A: Given: The mass of the block is 8 kg. The applied force is 100 N at 20o horizontal. The coefficient…
Q: A person opens a door by applying a 13-N force perpendicular to it at a distance 0.90 m from the…
A:
Q: Before: mI = 25.0 g mT = 25.0 g vI = 12.0 m/s East vT = 0 m/s After: mI = 25.0 g vI ' = 5.26 m/s @…
A:
Q: 2. The yoke-and-rod connection is subjected to a tensile force of 5 kN. Determine the average normal…
A: Since you have posted multiple questions, we will provide the solution only to the first question as…
Q: 1. Find the force for each of the following potential energy functions: (a) V = cxyz + C (b) V = ax²…
A: The objective of the question is to find the force for given potential energy functions, determine…
Q: 2.- A winch that operates by means of electrical energy (see figure), drags a 2.0 kg box up a slope…
A: Mass of object is Speed is Coefficient of kinetic friction is Note:Find:Power applied by winch.
Q: Q2(Hw) In two Wattmeter method, iff W-120.6W W2%=220,5W, Calculate the load p.f.
A: The phase angle (lag) in two wattmeter method is given by : Putting values :
Q: 2- Which of the following could not be the power coefficient of a slow speed wind turbine? a.…
A: Concept used: Power coefficient is ratio of electric power produced by wind to total wind blowing to…
Q: mass of 500 kg. kg. It raises a load öf 300 kg vertically at a steady speed of 0.2 m/sec. Frictional…
A: Mass of the Hoist, m=500 Kg mass of the Load to be lifted, M=300 kg Total mass it has to…
Q: Questions 1. To increase his speed from 20 km/h to 30 km/h, the cyclist must produce an additional…
A: Power is defined as the energy transferred to system per unit time.
Q: Q6)A 2.4kg book is resting on a horizontal desk. The coefficients of static and kinetic friction…
A:
Q: A steel rod 250 mm long and 200 mm in diameter is being reduced to 190 mm in diameter all over its…
A: Given:- length of rod L=250mm initial diameter D0 =200mm final diameter Df = 190mm Davg=195mm…
Q: Find the mobility or degrees of freedom for the following mechanism. N=6, Lp=6, Hp=0, Mobility=3…
A: The number of links N is 5( one line contact and four surface contact). The number of lower pairs is…
Q: Part A The block has a weight of 84 lb and rests on the floor for which uk = 0.4. The motor draws in…
A: The resultant velocity of the block is given by v=62+62+2×6×6×cos60v=10.39 ft/s
Q: A yacht used a cylindrical winder to unwind a cable to release an anchor. Using energy methods, what…
A: Force applied on the winder F=9 N, mass of the winder m=50 kg and radius of the winder r=0.06 m.…
Q: Group Problem: You are planning to build a log cabin in Northern Minnesota on a remote hill with a…
A: Given,Weight of the log = 1000 lbsAngle with espect to horizontal = θ =20°The coefficient of kinetic…
Q: One watt-hour is equivalent to: A. 6.3 x 103 J B. 6.3 x 10-7 J C. 3.6 x 103 J D. 3.6 x 10-3 J
A: Watt is the unit of power, and hour is the unit of time. Since power is the ratio of energy and…
Q: (a) Which component of the horizontal axis wind turbine can be considered as the brain of the…
A: (a) The brain of a wind turbine is called the nacelle. A nacelle is a housing that contains all of…
Q: In the figure below, a 1400 kg block of granite is pulled up an incline at a constant speed of 1.70…
A:
Q: The power output (in W) needed from a motor to lift a mass of 1.5 x 104 Kg, 25 m in 6.0 s at…
A: The mass is The displacement of the mass is The lifting time is
Q: An escalator in a shopping center is designed to move 50 people, 75 kg each, at a constant speed of…
A:
Q: 3. A 10.0-kg box is pulled by a horizontal wire in a circle on a rough horizontal surface for which…
A: Coefficient of friction μ= 0.250 Mass (m) = 10 kg
Q: An oxygen cylinder of mass 16.0 kg is pulled up a mountain side at a constant speed of 2.2 m/s by a…
A: Given: Mass of cylinder m = 16.0 kg. Speed of cylinder in upward inclination direction = 2.2 m/s.…
Q: 1. Two blocks was pulled by a rope with a force of 50 N, the masses of blocks 1 and 2 are 2 kgs.,…
A: Since you have asked multiple questions, we will solve the first question for you. If you want any…
Q: An electric motor is used to drive the shaft of a small water pump. During a performance test, the…
A: The power is calculated using the equation P=πNT30T=torqueN=angular speed in RPM Given that T=8.23…
Q: A 50 kg block is pulled up by a tensile force a 175 N and pushed up by a force F-200 N both applied…
A:
Q: what is the output power for student D climbing stairs, in Watts? Use g = 10 m/s2.
A: Write the mass of the student. m=80 kg Write the vertical height of the stairs. h=20 m Write…
Q: 1. A 40 meter chain hangs vertically from a cylinder attached to a winch. Assume there is now…
A:
Q: NO LONG EXPLANATION NEEDED. UPVOTE WILL BE GIVEN! At which of the three points labeled in the…
A: If the graph between potential energy and distance is given then the magnitude of force is given by…
Q: Q36. Alamp consumes 1000 J of energy in 10 s, what is its power? O 100 W O 1000 W O 100000W 1kW
A: Given that:- Energy=1000joule Time=10sec
Q: Explain if it is possible for a system to have negative potential energy
A: Answer Potential energy is the energy stored in any system or object by virtue of its position.…
Q: Figure: Given Box dimension. B 5 m 4 m A F C 3 m E H. G.
A:
Step by step
Solved in 2 steps with 1 images