F CAL Ca. C. Isothermal, constant Temperature and constant Volume (CSTR) F = F, = F A → B -TA = 20CA V = 100L, F, = 10 Cals = 20M min Required: a. Component A and B balance b. Cas, Cas c. Deviation variables if ACA = 0 (perfectly mixed)

Q: 7-4. Temperature-Dependent Viscosity Suppose that the liquid film in Fig. 7-4 has temperature variat...

A:

Q: Benzene is held at 425 K. Find the fugacity and fugacity coefficient at: a.) Psat b.) 1 bar c.) 2 ba...

A: Since you have asked multiple question, we will solve the first question for you. If you want any sp...

Q: The internal energy of water at its liquid phase under the temperature of 453.15 K and pressure of 1...

A:

Q: The velocity of a particle traveling along a straight line is v = (8t² - 9t) ft/min, where t is in m...

A: Given, The straight line equation, V=(8t^2-9t) ft/ min i.e V=(ds/dt)=(8t^2-9t) ft/ min Also given s=...

Q: Air is contained within a vertical piston-cylinder assembly as shown below. On its top, the 10-kg pi...

A:

Q: Differentiate complete combustion from incomplete combustion.

A:

Q: Fish are processed into fish meal and used as a supplementary protein food. In the processing, the o...

A: Given that, The weight fraction of water in the wet fish cake feed xw,wf = 0.8 The weight fraction o...

Q: A gas-vapor mixture consisting of benzene and N2 at a total pressure of 800 mm Hg and 45°C has a % s...

A: The vapor condenses when the partial pressure of benzene will be equal to saturation vapor pressure ...

Q: Suppose the initial energy of a system (internal, kinetic, potential) is E the final energy is E ,an...

A: Given that E1 = Initial energy of a system E2  = final energy Q = amount of energy transferred to sy...

Q: Natural Gas with an analysis as follows: CO2 = 0.4 %, , CH, = 97.3 % , N2 = 2.3 % is burned in a fur...

A:

Q: Calculate the theoretical flame temperature, in Kelvin, when ethylene at 25C is burned with 48 % exc...

A: Write the reaction for the combustion of ethylene as follows: C2H4 + 3O2 → 2CO2 + 2H2O   1 mole of C...

Q: 9. Gasoline is a complex mixture, assume gasoline is a mixture of 2,2,4-trimethylpentane (an isomer ...

A: Given that there are two component mixed i.e isomer of octane and n-heptane x1 =87% =0.87 T =25 C =2...

Q: 2.1 If the half-life time, t'2, of the initiator AIBN in an unknown solvent is 22.6 h at 60°C, calcu...

A: The rate is dependent on the concentration. The rate constant is obtained from the rate of reaction....

Q: What is the heating value of black liquor at 75% solids? How much energy will you produce per day if...

A: The fuel burned per day is obtained in kilograms. The total energy produced per day is a product of ...

Q: A 2.25-g sample of magnesium nitrate, Mg(NO3)2, contains mol of this compound A 38.4 (В) 65.8 148.3 ...

A: Given: m = 2.25 g (magnesium nitrate)

Q: I need the answer as soon as possible

A: Given data: Number of moles of CO2 produced = 2 mol % excess air = 20 %  

Q: A 200 MW steam power plant operates on a simple Rankine cycle with superheated steam entering the tu...

A:

Q: II. The adiabatic exothermic irreversible gas-phase reaction 2A + B→ 20 is to be carried out in a fl...

A:

Q: . Which of the following condition(s) is/are held when we say that dG is the maximum energy of a pro...

A: Since you have asked multiple question, we will solve the first question for you. If you want any sp...

Q: Given: m2 F - 20 hr A- 20m? Required: a. Unit of K so the flow rate is in b. Get the unsteady state ...

A:

Q: A feed stream containing 15% wt solids and 85% wt water is introduced in a certain process where the...

A: Given Feed=15wt% solid+85% wt water Solid/ preservatives=4/5 Residue=1/3 of water by mass Product r...

Q: In an industrial process, nitrogen is heated to 500 K at a constant volume of 1.000 m3. The gas ente...

A: Given that T = 500 KV = 1 m3T1 =300 kP1 =100 atm m =92kg a = 1.352 dm6atm mol2b =0.0387 dm3mol

Q: Name the type of reaction and balance the equation: STATE TYPE OF REACTION 1. NH3+ (NH.),SO, 2. РЬ +...

A:

Q: The three lines below represent grain boundary, surface and self -diffusion in an unspecified metal....

A:

Q: (NO3)2 Pbl2 + 2 NANO3 1) How many moles of lead (1) nitrate are needed to react completely with 10 m...

A: Given that there is reaction given Pb(NO3)2 +2NaI →PbI2  +2NaNO3     According to bartleby rule, I c...

Q: Example 2.1 : Calculate the rate of heat loss Q, through a wall of red brick [k = 0.70 W/(m·K)] 5 m ...

A:

Q: Methane is fed to a combustion chamber at the rate of 9 lbm/min where it is burned completely with 7...

A: Given that, The mass flow rate of methane CH4 = 9 lb/min The molecular weight of CH4 = 16 lb/lbmol T...

Q: A chemist attempts to prepare some very pure crystals of borax by dissolving 100g of Na 2 B 4 O 7 in...

A: The percentage of sodium tetraborate and water. The molar mass of borax and sodium tetraborate are o...

Q: Carbon disulfide is a common solvent that is produced by reacting sulfur vapor with methane. It is p...

A: By using Gaussian elimination method,we can determine the number of independent reactions. Step-1: C...

Q: Q3: A 300 litre of CO2 gas at 8000 kPa is compressed to one third its initial volume. Given Constant...

A:

Q: 5.10 To produce more hydrogen from "synthesis gas" (CO + H2) the water gas shift reaction is used: C...

A: Given that there is water shift reaction given we have to calculate K T =1000K

Q: Find H, V, S, for steam at 1.5 atm and 320 C

A: Given: P = 1.5 atm T = 320 °C

Q: Water flows in a steel pipe (d = 40 mm, µ = 0.001 kg/ms) with a rate of 1 lit/s. Calculate the Reyno...

A: Given that, Diameter D = 40 mm = 0.04 m Viscosity μ = 0.001 kgm.s Volumetric flow rate Q = 1 lits = ...

Q: An air stream is contaminated with benzene, and your task is to remove the toxic benzene. An air-ben...

A: In mass transfer separation process. we use theoretical plates. These are also known as the equilibr...

Q: For the gas phase reaction: 4 NH3 + 50, → 4 NO + 6 H,O YNH3,0 = 0.15; Yo2,0 = 0.8 ; y10 = 0.05 CTo =...

A: Reaction is 4NH3+5O2⇌ 4NO+6H2O yNH3,0=0.15 yO2,0=0.8 yI,0=0.05 CT0=1mol/L FT0=1mol/s Find Stoichi...

Q: An unknown metal Y has a density of 655.2 lb per cu. ft. The edge of the FCC unit cell of the said m...

A: Given data: Density of unknown metal = 655.2 lb/ft3 Edge length = 4.09 A0

Q: note on shale oil exploration from Paleocene-early Eocene sequence in Cambay rift basin, India

A: A shale may be defined as fine-grained, soft stratified sedimentary rock, which is formed as a resul...

Q: You are about to sail a Great Circle from A (12°20’N, 25°22’ W) to Port B (55°19' S, 75°17'E). Find ...

A: A = (12°20' N, 25°22' W) B = (55°19' S, 75°17' E) LatA = 12°20' LatB = 55°19' D.LongAB = 360°- (25°2...

Q: A An open test tube is filled at the bottom with 12.1 cm of Hg and 5.6 cm of water is placed above t...

A:

Q: For a certain gas the vdw constants are a = 6.69 atm-l2/mol 2 and b = 0.057 liter/mol. what will be ...

A: Given that, Van der Waals constants: a = 6.69 atm.L2mol2b = 0.057 Lmol Number of moles of gas n = 2 ...

Q: . You are about to sail a Great Circle from A (12°20’N, 25°22' W) to Port B (55°19' S, 75°17'E). Fin...

A: A = (12°20' N , 25° 22' W) B = ( 55° 19' S, 75° 17' E) LatA = 12° 20' N LatB = 55° 19' S D.LongAB = ...

Q: In the gas phase reaction, A+ 28 = 20 + 3D, it was found that when 1 mol A 2.2 mol B and 0.6 mol D w...

A: The given reaction initial moles, change in moles, and moles after equilibrium are considered. This ...

Q: 2. The two graphs shown below represent the distillation results for two different distillations. Di...

A: Since you have posted a question with multiple sub-parts, we will solve first three subparts for you...

Q: Consider the dissociation of Hydrogen Sulfide: 2 H2S (g) = 2 H2(g) + S2 (g) (endothermic reaction) W...

A: Given reaction, 2H2Sg ⇌ 2H2g + S2g       Endothermic reaction It is required to determine the effect...

Q: If 100 grams of lead (II) nitrate and 100 grams of sodium iodide were initially used in the reaction...

A: 4) Given that, PbNO32 + 2NaI → PbI2 + 2NaNO3 The mass of Pb(NO3)2 = 100 g The molecular weight of Pb...

Q: The initial mixture contains nbutanol / acetic acid, in the molar proportions 4.97/1. The catalyst i...

A: The reaction is, Mole ratio of butanol : acetic acid = 4.97:1 Catalyst is H2SO4 = 0.032 wt% Density...

Q: Air enters a compressor operating at steady state at a pressure of 1 bar, a temperature of 290K and ...

A: The Air compressor must operate at steady-state conditions. The inlet and outlet states must be know...

Q: Consider the dissociation of Hydrogen Sulfide: 2 H2S (g) = 2 H2g) + S2 (g) (endothermic reaction) Wh...

A:    To answerwhat is the effect if the system at equilibrium is cooled   

Q: Carbon is to be diffused into iron with an initial C concentration of 0.25 wt% at 763°C. If the surf...

A: Activation energy = 84 kJ/mol Pre-exponential factor = 6.2 × 10–7 m2/s Initial concentration of C = ...

Q: 2 What is the wavelength for the energy maximum of blackbody radiation at 30,000°F?

A: From the Wien's displacement law we have         λmaxT = b Where,  b is a constant  And for black bo...