Explain with drawing Instruction set of PIC 16fxx Microcontroller List the Interrupt sources in PIC16F84
Q: For step -down chopper circuit, source voltage Vs=220V, Chopping period T=2000micro second, on…
A: Step- down chopper is the DC input voltage. It is the static device the average output DC voltage of…
Q: 4. For the circuit shown in the figure below find the following a. Write the name of the circuit....…
A: For the given circuit find the following parameters : Name of the circuit. Find the value of IB, IC…
Q: A decoder with 4-bit input signal has outputs 4 O 16 O 1 O none of the mentioned O 2 O
A: We need to select correct option for decoder .
Q: If a 10-bit ring counter has an initial state 1101000000, what is the state after the ?second clock…
A: We need to find out output state of given counter
Q: A fluid system has two sensors, a pressure sensor and a flow sensor. The pressure sensor has two…
A: Since it is asked to solve only subparts (3-c) and (3-d),so we are solving those two subparts only.…
Q: The progressive phase shift k=180, the direction of the main beam Bo for a uniform linear array with…
A:
Q: Answer whether each of the following questions is (True) or (False)? Write the true answer if it is…
A: Phasor diagram is widely used to represent various quantities in electrical circuits.
Q: 3- Two sinusoidal currents are given by the equations: il = 10 sin (oot + /3) and i2= 15 sin…
A: Given data, Current1(i1)=10sinωt+π3 Current2(i2)=15sinωt-π4
Q: What is the approximate value of Y? Use your calculator. Y=(21)(24.8 E311/2 (sin 38°) (3.89 x 10²)…
A: Given, To simply, Y=2π24.8E31/2sin38°3.89×102
Q: Which of the following could be the boundaries of the given shape? R=5 A=74° B=9°
A:
Q: we might have a picnic tomorrow.it depends ....... The weather.
A: ans:(b) on
Q: Consider the circuit shown in Figure 2. The transistor parameters are ß= 100 and VA 100 V. Determine…
A: For the above given question we need to calculate the value of input impedance, voltage and current…
Q: An ideal transformer has a turns ratio of 15:1 and is supplied at 180 V when the primary current is…
A:
Q: 4. The transistor in the circuit in Figure 4 has a dc current gain of 3 = 100. (a) Determine the…
A: For the above given common emitter amplifier circuit we need to derive all the small signal…
Q: A voltage divider has values of R1=10kΩ and R2=470kΩ. a.What is the attenuation? b.What amplifier…
A: It is given that:R1=10kΩR2=470kΩAT=1
Q: The R.M.S. value of a half-wave rectified current is 10A, its value for full-wave rectification…
A: Answer: 14.14 Explanation: a. It is not a valid option. The value is same as twice the value of peak…
Q: int(-expression-) converts the value of the expression to float value O character value string value…
A: Answer : Integer Value
Q: A rectifier circuit is used to charge a 12 Vdc battery using a 40 Vpp AC source, according to the…
A: The Given is to design rectifier circuit. In the Given rectifier circuit charge a V0=12 Vdc battery…
Q: s time Foirier transform relationship. 1.
A: NOTE_ “Since you have asked multiple questions, we will solve the first question for you. If you…
Q: An air-filled rectangular waveguide has dimensions, a = 2.5 cm and b = 1.2 cm. The decreasing order…
A: Rectangular waveguide is the hollow metal tube and cross section area is rectangular. The dimension…
Q: My name is Ahmed, I come from Mosul, A city in the North of Iraq. I'm a student at the University of…
A: Given: Details about Ahmad
Q: 1-Efficiency 2- Ripple factor 3- PIV
A: The power electronic circuit which is used to convert ac power to dc power is known as the…
Q: Diagram showing zero basing in field effect transistors as applied in electronics
A: The Field Effect Transistor is a semiconductor device which consists of two PN-junctions. This is a…
Q: Ex 1: a 50 Hz generator has e.m.f. to neutral 7.5 kV (r.m.s). the reactance of generator and the…
A:
Q: 2. Convert each decimal fraction to binary using the sum-of-weights method: (a) 0.32 (b) 0.246 (c)…
A:
Q: 15V $30 IA D + 552 1 Which of the following is the value of the power supplied by the voltage source…
A: Given, The circuit is,
Q: Solve the question in the simplest way Determine the y parameters for the two-port shown in Fig.…
A: We need to find out the Y parameters of given circuit
Q: 7. Differentiate FM and AM? 8.
A: Modulation:- The process in which imposing the signal of input into the carrier signal is called…
Q: Solve the question by hand do not using computer, explain each step please Example 3.8: ELECTRICA…
A: Given: vs(t)=10u(t)Current through inductor, at t=0, iL(0-)=-1AAnd voltage across capacitor is,…
Q: a) For the Current Locus shown Draw the equivalent electric circuit? Find the value of each element…
A:
Q: lectrical power (P) is given by P = E²/R, where is voltage and R is resistance. Approximate the…
A: Given that P=E2RE=200V R=200 ohm ∆EE=3%=0.03∆RR=4%=0.04
Q: A DC-DC boost converter has an input of 200 V with a load of 7.5 Ohm. Find the output voltage and…
A: Given data, DC DC Boost converter, Input voltage (VDC) = 200v , Load resistance ( R ) = 7.5 ohm ,…
Q: 1. A 3-phase, star-connected alternator is rated at 15000 kVA, 11 kV. The armature resistance is…
A: Given data, KVA rating S=15000KVA Terminal voltage Vt is 11kV Synchronous impedance Zs is (1.5+j30)…
Q: A silicon diode has reverse saturation current of 2.5 μA at 300 k . Find forward voltage for a…
A: Given data : reverse saturation current is=2.5mA For silicon diode VT=25.9mV Absolute temperature…
Q: 16. The following serial data are applied to the flip-flop through the AND gates as indicated in…
A:
Q: Compute the work done in carrying a 5C charge from P (1, 2, -4) to R (3, -5. 6) in ctric field E= ax…
A:
Q: H.W : Find the Parallel Realization for. ; Z² H(Z) (2-1) (2-0.5)
A: For the above given question we need to perform the parallel realization of the given transfer…
Q: The main difference between a register and a counter is a register has no specific sequence of…
A: In this questions we need to tell about the main difference between register and counter.
Q: Vols) Vols) = (5+ 85+18) (5+5) 3²+ &5 3 How? 5+85+18 3 3 [S+ 2.4.5+4+2 (5+2)+2 G
A:
Q: 5. a. If an electric heater draws 5 A when connected to a 220 V supply, what is the internal…
A: Given, Current drawn by heater, I=5 A Supply, Vs=220 V
Q: A 3-phase, star-connected alternator has a resistance of 0-5 2/phase and a synchronous reactance of…
A:
Q: Compared between three_ phase induction generator and synchronous them at impedance field and EMF…
A:
Q: put waveforms in Figure 5-61, what logic circuit will generate the output waveform shown? A Inputs B…
A:
Q: The gray code has the property of when going from any number to the next only one bit is flip O none…
A: We need to select correct property of gray code .
Q: Q5:Choose the correct answer from the given alternatives 4. A transformer has negative voltage…
A: As per the guidelines of Bartleby for MCQ question we solve first three questions only for solution…
Q: Provide at least 3 Examples of Control Systems Models or Representations and its corresponding…
A: Following control system models are mostly used- Differential equation model Transfer function…
Q: 2. For the circuit shown below, calculate: a) The gain (G) of the amplifier associated with the 1.5…
A:
Q: 3. Perfect resistor of resistance R=42, a perfect capacitor of reactance Xc=992 and a perfect coil…
A:
Q: Ex. 1: Determine the PSM (plug setting multiplier) of a 5A, 2.2 sec over current relay having a plug…
A: In this question we need to find a PSM .
Q: Q5) A linear variable differential sensor gives the movement signal shown in Figure 2. If the sensor…
A: Here both opamps are in inverting configuration which means output is exactly 180° phase shift to…
Please I need asnwer fast
Step by step
Solved in 3 steps with 7 images
![Digital Modulation Scheme (Amplitude-Shift Keying [ASK], Phase-Shift Keying [PSK], Frequency-Shift Keying [FSK])](/static/compass_v2/subjects/engineering/electrical-engineering.svg)
- 4) Design and draw these memory units with their control circuits. Explain operations. a) A single EPROM 2716 is used with an 8088 microprocessor so that this microprocessor will see only X bytes of memory between the address range of DF800 –DFFFF or DD800 - DDFFF instead of 1M byte that it expects. Draw this circuit. What are X bytes? Do not use 74138 decoders. b) Design and show a 16K x 16-bit memory circuit by using 8K x 8-bit RAMS. Explain its operation. Do not use decoder 74138 chip.State the differences between Microprocessor and Microcontroller in general and then identify the major hardware differences in 8086 MPU vs. PIC18F4052. In addition, Compare the x86 Instruction Set Architecture with PIC18F series Instruction set in detail.How does Arduino microcontroller differentiate an input logic signal 0 to logic signal 1 given a 5V source?
- 1- What does the VoH parameter of a logic IC refer to? a) The highest permissible output voltage. b) The lowest output voltage recognized as logic 1. c) The highest output voltage recognized as logic 1. d) The highest output voltage recognized as logic 0.A 9 bit asynchronous counter has a 128 - kHz clock signal applied. i) What the mod Number of this counter ? ii) What will be the frequency at the MSB output ? iii) Assume that the counter starts at zero.What will be the count after 6.15 input pulse?P Flag question Explain the MUL instruction of 8086. Compare it with IMUL instruction. (1 +1 Marks) Write a Assembly language program for 8086 to find the cube of a number using MUL instruction. (5 Marks) (Note : Solve the question in paper, scan and upload along with the other Part B and C answers) B I III
- Briefly answer the following questions: a) List at least 5 SFRs in PIC18F87J11. b) Given an instruction example for each addressing mode in PIC18F87J11. c) Describe and draw the memory architecture for PIC18F87J111. Letter A at the end of PIC16F877A means that this MCU is an -- 2. Technology approach for microcontroller is- 3. when type the body of the program, any program must contain some important lines, the fuses line will set the -------- in the PIC. 4. for simulating PIC response, We will use- 5. suppose that we need to display number 5 on a common cathode 7-seg then we must feed segments --------- with Vcc and segment -- with GND. program.8085 microprocessor went through its manipulation operation in the ALU, the results was transferred on the data bus and status of the results was stored in the flag register for indications . With your knowledge and understanding illustrate a complete bit configuration of 8085 flag register and show the functions of the represented bits in the register.
- Explain the program memory structure of 8051 microcontroller. Write an ALP using 8085 online simulator tool to perform logical XOR operation for two 8 bit data. Load the accumulator with 34 H and load the B register with 1AH.Q4(a) Adder is divided into three types which are half adder, full adder, and parallel adder. Illustrate the implementation of full adder using half adder with necessary logic gates. (i) (ii) Figure Q4(a)(ii) shows the input timing diagram for a full adder. Illustrate the timing diagrams for output S and Cout- Cin Cout Figure Q4(a)(ii)3. Draw the block diagram of an 8255 PPI chip and describe its different programming modes. Configure 8255 as follows: port A as output, B as input, and all the bits in port C as output. Determine the content of the Control Register and program the 8255 to get data from port B and send it to both port A and port C. (Assume the standard port addresses of 8255)