Answered: Example: A source has six messages with…

Example: A source has six messages with probabilities [0.5, 0.2, 0.15, 0.05, 0.04, 0.03]. Construct the 4-ary Huffman code and then compute the code redundancy?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: B A o CLK B K A CLR CLR CLR B

A: We need to tell about the given circuit, how bit counter ,it is .

Q: From the above bound, state Q5. A parity-check code has the parity-check matrix H. (A) Calculate the…

Q: Add signed binary numbers (+5) and (-12). Use 8 bits to represent your numbers

Q: , Implement the given Boolean function F(A,B,C,D) = m (0,3,6,8,10,11,12,14,15) using a multiplexer…

A: Given: FA, B, C, D=∑m0,3,6,8,10,11,12,14,15 To do: We have to implement the above logic function…

Q: a. 1001101 + 10010 = %3D b.1001101 - 10010 = %3D

Q: 5. QPSK is a modulation scheme where each symbol consists of a. 4 bits b. 2 bits c. 1 bits d. M…

Q: Given a base 9 number of 824, what is the bit position of digit 8? O a. zero O b. one c. two

A: To see the bit position of digit start seeing from right side. First digit is zeroth position,…

Q: (i) Below (figure 1) is an example of a VHDL code for a multiplexer. "00000010000001"WHEN…

A: A VHDL code for the multiplexer is given in the question. Consider the code line, SIGNAL input :…

Q: Q2) The conditional probabilities of a binary transmission system with non-return zero signaling are…

A: Conditional probability is known as the possibility of an event or outcome happening, based on the…

Q: Derive the of QPSK overall scheme. probability of symbol error

A: We need to derive the overall Probability of symbol error .

Q: What is meant by 4 to 16-line decoder? Draw the block diagram of that decoder (Please don't show the…

A: As per bartleby guidelines we are supposed to answer only question as it is not a subpart, So I have…

Q: Q: Add the following unsigned binary numbers. a) (11010011), & (11101110)2 b) (11000111), & (11111)2

Q: Design don't-care conditions. an excess-3-to-binary decoder using the unused combinations of the…

A: Design an excess 3 to binary decoder using the unused combinations of the code as dont care…

Q: Find the answers to the following questions? a) Find the excess-3 code of (152) Base 10. b)…

A: a) The excess-3 code of the decimal number can be written by using the following steps. 1- Convert…

Q: Example: A source has six messages with probabilities [0.3, 0.25, 0.15,0.12, 0.1, 0.08]. Construct…

A: To construct a 4-ary (quaternary) Huffman code for the given probabilities, follow these steps:1.…

Q: Question 15 A Boolean function simplified by using K-map in more simple than the sum of minterms…

A: Need to find true false

Q: 5. A) Design the following Boolean function using a 3-to-8 line decoder and an OR gate. F(A,B,C) =…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: a) i) Determine the number of bits per level required when using FSK with 4 different frequencies…

A: According to the question, i) Determine the number of bits per level required when using FSK with 4…

Q: The previous solution was not clear, and there was ambiguity in the abbreviations. I need the…

A: Answer 1. Converting Decimal Numbers to Different Bases Decimal 46 to Binary:To convert 46 to…

Q: Chose the correct data input for 2-1 multiplexer that used to Design the * (switching network F…

A: A multiplexer, sometimes known as a data selector, is an electrical component that chooses one of…

Q: The addition of two 5-bit binary numbers in parallel implies that all the bits of the augend and…

A: We need to draw the circuit diagram providing the carry output in carry-look ahead adder.

Q: Set the “Carry” and “Overflow” bits for each of the following. a. 00000110 + 01111110 b. 10000111…

A: In 8 bit signed number, over flow bit is 1 when if there is carry from d3 to d4 else overflow is…

Q: A source has six messages with probabilities [0.5, 0.2, 0.15, 0.05, 0.04, 0.03]. Construct the 4-ary…

A: To construct a 4-ary (quaternary) Huffman code for the given probabilities, follow these steps:1.…

Q: 3) Make a 4-to-1 line multiplexer and derive a Boolean expression from its table.

A: To do:We have to make 4:1 line multiplexer and to derive the boolean expression from its table.

Q: number? Q2/ Answer all branches: (7 1. By using BCD (8421) code express the (-849)10 in…

A: We will do complement and signed magnitude representation only for negative numbers.

Q: A dairy factory uses an 8255 PPI card at base address 5000 H. a) Explain how port address is changed…

A: Given that: Port A=Output Port B=Input Port C lower=output Port C Upper=Input By default Mode 0 is…

Q: :) Draw block diagram for asynchronous down binary counter that count the following sequences and…

A: In asynchronous counter when preset is 1 and clear is 0, all the bits of the counter are set to 1.…

Q: For the given Hexa-decimal number (2AC.3),6 Find the equivalent Octal number a. (1645.34)g b.…

A: Converting the hexadecimal to binary, 0010 1010 1100. 0011 Now we can convert this binary to octal…

Q: At the receiver the syndrome for a Hamming coded data was=[00100], in what bit there is an error,…

A: Given data is syndrome of Hamming code So, s=[0 0 1 0 0], From this data we can observe position of…

Q: 2) Design a 4-bit up/down gray counter?

A: Step -1-> Design a 4-bit up/down gray counter-:

Q: Q5: perform the following operations in Hexadecimal (with and without complement): • 7F + 9C • 164 -…

Q: 9. Rank the following Verilog operators according to their precedence. The operator with the highest…

A: Given some verilog operators like logical, conditional, shift, relational, unary, binary etc... So…

Q: Design a 4-to-1 multiplexer using a 2-to-4 decoder and only AND and OR gates? Briefly explain how…

Q: P(Type I Error)= 1 - P(Type II error) a) True b) False

A: WE NEED TO FIND OUT GIVEN STATEMENT IS TRUE OR FALSE.

Question

Example:
A source has six messages with probabilities [0.5, 0.2, 0.15, 0.05, 0.04, 0.03]. Construct the 4-ary Huffman code
and then compute the code redundancy?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: stating the given data

VIEW

Step 2: Answer

VIEW

Step 3: Finding the solution of A4-ary haffman code and code redundency,

VIEW

Solution

VIEW

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

mplement a 8:1 Multiplexer using 2:1 Multiplexers.NOTE: Please explain clearly, make a truth table, write design steps as much as possible to prove yourknowledge.
a) Convert the decimal number 158 into a signed binary number using (1) sign-magnitude method (2) 1's complement method (3) 2's complement method b) If the above decimal number is positive , that is + 158, then convert it to a signed binary number using 2 's complement method c) Do the following binary subtraction: 111001011.01011- 010010001.10 110
please quickly solve this. thank you
Design a 4-bit Gray code to 7-segment decoder using 3x8 decoders.- Provide the truth table and the Boolean expression. Simplification is not needed.
1. Implement the following Boolean function by using 4x1 multiplexer. F(A,B, C, D) = Em(1,3,5,6,8,11,14) 2. Construct a logical circuit of 64 x 1 multiplexer using 4 × 1 multiplexer. 3. Construct a priority encoder circuit of 8x3. 4. Design a 4-bit BCD to Gray Code Converter by using Programmable Array logic.
3- Implement the Boolean expression given below using 8*1 multiplexer, 2*4 decoder and 2 OR gates. (Not all entries are available.) F(A,B,C,D,E)=∑(0,7,10,13,16,17,18,19,21,22,28,30)
Design four way traffic lgiht signal using gray code and using logic vehicle on side long timer and short timer also by using d flip flop
3) This QUESTION FROM Information theory course. just write for me the the correct answer.
Write a VHDL program to implement a 2-bit adder. The Boolean functions for the 1-bit full adder are given in the diagram:
Show how a full adder can be implemented using a decoder.
Design a 3-bit Gray code counter. Counter have to be run, reversely.
??