Example 7.1 A two-conductor single-phase line operates at 50 Hz. The diameter of conductor is 20 mm and the spacing between the conductors is 3 m. Calculate (a) the induction of each conductor per km, (b) the loop inductance of the line per react per km, and (d) the loop inductance per km of the line when the conductor material is steel relative permeability 50. km, (c) the inductive

Example 7.1 A two-conductor single-phase line operates at 50 Hz. The diameter of conductor is 20 mm and the spacing between the conductors is 3 m. Calculate (a) the induction of each conductor per km, (b) the loop inductance of the line per react per km, and (d) the loop inductance per km of the line when the conductor material is steel relative permeability 50. km, (c) the inductive

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

In a three-phase overhead line, the conductors have an overall diameter of 3.0 cm each and are arranged in delta formation. Assuming a critical disruptive voltage of 250 kV between the lines, an air density factor of 0.90 and mo= 0.95, find the minimum spacing between conductors that is allowable. Assume fair weather conditions.
The Power transfer capability of transmission line is most affected by: it) shunt conductance b) capacitance c) Resistance. d) inductance
q10/ Complete the blank The inductive reactance of the line conductor is 60 Ω per km, then the inductance of the conductor in Henry for the 41 km long transmission line operating with 20 kV, 50Hz supply is ................................................
The capacitance of a single phase two-wire transmission line depends on: Select one: a. All the above O b. the material of cables c. the radius of cables d. the distance between the cables O e. None of above
Q2(a) Figure Q2(a) shows the spacing of a double circuit 3-phase overhead line. The phase sequence is UVW and the line is completely transposed. i) Critically assess the advantages of double circuit line over single circuit line Calculate the inductance per phase for 500 meter length of line using Table 2(a) data for the Figure Q2(a). Table 2(a) GMR of the line 0.01m Distance a-b' 6.m Distance c-c' 8.3m a b Figure Q2(a)
A two conductor single phase line operates at 55 Hz. The diameter of each conductor is 25 mm and the spacing between the conductor is 3 m. Calculate i) the inductance of each conductor per km ii) the loop inductance of the line per km iii) the inductive reactance per km, and iv) the loop inductance per km of the line when the conductor material is steel of relative permeability 55.
The capacitance between the line to neutral of a three-phase 50 Hz, 66KV overhead line conductors with horizontal configuration is 8.5 x 10- Farad/ph/m. Then the line to line capacitive reactance in 2/km is ..
Q1: A 1-ph, 220 V, 50 Hz overhead line has a distance of 4 m between its .conductors and 7 m above the ground. The diameter of each conductor is 15 mm The capacitance between conductors (in pF) for a length of 50 km .2 *.----- without the effect of ground is (2) uhi هذا السؤال مطلوب The capacitance between conductors (in uF) for a length of 50 km with .1 * .----- the effect of ground is (2) Jahi هذا السؤال مطلوب (2) Jihi * The charging current (in Ampere) without the effect of ground is .3
None