Considering two parallel three-phase circuits that are close together, when calculating the equivalent series- impedance and shunt-admittance matrices, mutual inductive and capacitive couplings between the two circuits can be neglected. a. True b. False

Considering two parallel three-phase circuits that are close together, when calculating the equivalent series- impedance and shunt-admittance matrices, mutual inductive and capacitive couplings between the two circuits can be neglected. a. True b. False

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.29P: Consider three ideal single-phase transformers (with a voltage gain of ) put together as ...

See similar textbooks

Related questions

Q: Determine v(t) for the circuit shown in the figure.

Q: In a certain magnetic circuit, the core is represented two reluctances as shown below. Assume a…

A: The magnetic circuit diagram is shown below, Number of turns, N=640 turns.Current, I=2.2 A.

Q: 49. The inductance of a moving iron instrument is given by L-(0.02 +8 x 10 e) pH, where is angular…

A: It is given that: L=0.02+8+103θ2 μHI=3 Aθ=π3

Q: What will be the value of the Unknown inductance Lx (in mH) and the effective resistance Rx (in 2)…

A: In this question We need to determine the value of inductance Lx (in mH) and resistance Rx . At…

Q: Determine X(z) and specify its ROC, if the following facts are given about a discrete-time signal…

A: In this question, We need to determine the X(z). The facts of the X(z) are given.

Q: The low voltage side of a particular transformer has 1367 turns while its high voltage side has…

Q: Find impulse response of the following causal linear time invariant system: a. b. O c O d. y[n] −…

Q: V1, V2, and V3 are inputs, io is the current across the 25 ohm resistor, and V2 is the voltage…

A: Given Data: A DC circuit of, Consider the node voltages and branch currents as above. To Find:…

Q: find 10 mesh analysis Practice Problem 10.3 6/0° A 8 Ω +j2 Ω 6Ω j4 Ω 30/30° V

A: Circuit is given, To find the current I0 using mesh analysis.

Q: A series DC motor has a series-field winding of 25 turns per pole. Its armature resistance is 0.15…

Q: In an experiment, it is desired to obtain equal electron and hole drift currents. How should the…

A: How to obtain equal electron and hole drift currents?

Q: Shield wires located above the phase conductors protect the phase conductors against lightning. a.…

A: The given statement is related to the use of shield wires in protecting the phase conductors against…

Q: Use voltage division twice to find V₁ 100/20°V + 10Ω m j200 www 15Ω m + V₁ T -j30n

Q: I = 9 A T VR1 PR1 = R₁ 10 Q2 = Using superposition, find the voltage across, the current I through,…

Q: For a three-phase three-wire line consisting of three solid cylindrical conductors each with radius…

A: The value of total inductance of a three-phase, three-wire line which consists of three solid…

Q: The value of R₁ which results in maximum power transferred to the load in the circuit given below is…

A: Given circuit- To find- The value of load resistance RL for maximum power transfer.

Q: 80 V 40 2 3F 3012 0.51 5002

Q: The Laplace transform of the function i(t) is 5s+3 I (s) = s(s+4)(s²+3s+2) Its final value will be

A: Given function, Is=5s+3ss+4s2+3s+2

Q: Question 4 Design a filter that has the transfer function H(s) 1) Please determine the filter type,…

A: The transfer function of a second-order filter is given as Hs=1000ss2+500s+40000. To find: (i)…

Q: ₂2 50 2 +(s) R MAA A Find хс B) write the AC signal Formula c) what type of filter? why? Vout с

A: For , this circuit we need to solved A)The value of Xc . B) The AC signal formula . C) The type of…

Q: Find the output y(n) of the system h(n)= u(n)-u(n-3) if its input x(n)= (-)"u(n), by using a) y(n)=…

Q: 2. The figure here depicts a long solenoid that contains two different magnetic materials. The…

A: The long solenoid figure is shown below,

Q: Input voltage is 0.4V. Find the voltage output of speaker. Voltage gain =200.

A: The given circuit diagram is shown below. The input voltage is Vin=0.4 Volts. The voltage gain is…

Q: Compute the Fourier transform of the following signal e-3|t| sin 2t

Q: Problem5. Find the A.C. steady state current i using nodal analysis. Hint: Covert the problem to…

A: In this question, We need to determine the steady state current i as shown the circuit. We know…

Q: (Q)The number of cells in a cluster is 11 and the number of channels present in a particular cell is…

A: We need to find out the channel capacity for given system.

Q: Find the output voltage in the circuit below. Vin looks 100k52 200ks 200k S Vout

Q: ) Given an input voltage from power supply battery, V dc-12V, f=3 kHz and ON time is 0.2m Calculate…

A: Given : Vdc=12 Vf=3 kHzTON=0.2 ms

Q: Problem4.Find V.(t) for t20. Use differential equation approach to get credit for this problem.…

A: In steady state capacitor act as open circuit. In steady state inductor act as short circuit. The…

Q: The following transfer functions describe digital systems. a. H(z) b. H(z) c. H(z) = z+0.5 (z-0.5)…

Q: Q9 The discrete-time signals x1[n] is shown in the figure. Carefully sketch each of the following…

Q: 2. Two systems are interconnected in parallel as shown in Figure 1a. The impulse response for each…

Q: At an operating frequency of 3GHz, what value of capacitance (in pF) is required to shunt resonate a…

A: In this question we need to find value of capacitor required to shunt resonate at frequency of 3…

Q: 7.57. Consider the discrete-time LTI system shown in Fig. 7-25. Figure 7-25 x[n] Open in new tab Σ +…

A: Given block diagram is We need to determine a) The state space representation of the system with…

Q: Design and implement a 2-bit integer division circuit. The circuit has four inputs A1,A0,B1,B0 and…

Q: A conducting filamentary triangle joins points A(3,1,1), B(5,4,2), and C(1,2,4). The segment AB…

A: A conducting filamentary triangle joins points A(3,1,1), B(5,4,2), and c(1,2,4). The segment AB…

Q: An experimenter is working in his laboratory with an electromagnet, as shown in the figure. He…

A: In this question we discuss about whenever he turns off the electromagnet, it appears a large spark…

Q: 2. Calculate Thevenin voltage and Thevenin resistance (Ans: VTH = 7V, RTH = 8.92)

A: It is given that:

Q: Derive BF: af 1-af from the definitions of Ic IB BF and Ic = af IE

A: To derive, βF=αf1−αf. Using the equations, βF=ICIB and IC=αfIB.

Q: synchronous motor

Q: The following timer block depicts a(n) B001 Tra Rem = off 00:00s+ O a. Off-delay O b. Asynchronous…

Q: A transmitter sends a 5W of power to a 75 ohm line. Suppose the transmitter and the line is matched…

A: A transmitter sends a 5W of power to a 75 ohm line. Suppose the transmitter and the line is matched…

Q: Problem # 2: Find the current and voltage across each resistor from Fig#2. The Supply Voltage is 10V…

A: For the given circuit we have to find the current through the resistor and voltage across all the…

Q: Consider the RL-circuit below: + V ZL Assume: V = 14.14 20°, R = 20°, Z₁ =jXL; XL = Lw = 152 (a) -…

Q: Q3. A logic gate circuit is designed as follows, where R₁=5.9 k 2 and R₂=4 k 2, Vcc=14 V, A is input…

A: R1 = 5.9 kΩR2 = 4 kΩAnd Vcc = 14 V

Q: The current in the 60 resistor of the network shown in below figure is 2A. Determine the current in…

Q: Ug(t) ( ww 100 Ω 150 Ω 12 Η 40 Ω 8 Η i(t)

Q: Find io(t) if vs(t)=400sin2500tV. Suppose that io(t)=I0cos(ωt+ϕ), where −180∘<ϕ≤180∘. Determine the…

A: In this question, we need to determine the value of Io , w and Φ in the current io(t). The given…

Q: R R₁ 2 Ω R₂- 12 Ω I 3 A Find the Thévenin equivalent circuit for the network external to the…

Q: Consider the network shown in figure 12/45-V 20 -30 Mm The Thevenin equivalent impedance at…

A: It is given that:

Question

Considering two parallel three-phase circuits that are close together, when calculating the equivalent series-
impedance and shunt-admittance matrices, mutual inductive and capacitive couplings between the two circuits can
be neglected.
a. True
b. False

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: To determine

VIEW

Step 2: Explanation

VIEW

Solution

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

in distribution transformers; What is 30 degrees phase shift in delta-star connection? What are the disadvantages? (can you explain with drawing?)
Describe the star-delta connection configuration types in three phase transformers and their necessity by drawing and writing. Thank you very much if you answer.
In the T-Model method which among these are divided into two halves. a. Both (A) and (B) b. None of these c. Shunt capacitance d. Series impedance
4. An Open-Wye/Open-Delta transformer, as shown in Figure, is formed by two identical single-phase transformers. The primary line-to-line voltage is 12.47 kV, and the secondary line-to-line voltage is 208 V. Take
The mutual inductance coupling coefficient standard unit is .. * Ohm Henery O Unit-less Mho
3. At three winding transformer at no-load case, the current flows through the tertiary windings is large current load current secoundary current no-current 4.We can correct P.f (Power Factor) by using: * impedance Inductance capacitance non 5. There are two basic types of capacitor installations which used in power factor correction which are: used in power factor correction which are: series, shunt series, individual individual capacitors, and banks of fixed or automatically switched capacitors.
The ............. sequence components are in phase with each other.
Subject - Design electrical circuits for single phase AC networks Question - Compare the effect of varying resistance, capacitance and inductance in a pararllel and series AC circuits on voltage resistance and impedance.
Consider a 3-phase, 50 HZ, 11 KV distribution system. Each of conductors is suspended by an insulator string having two identical porcelain insulators. The self-capacitance of the insulator is 5 times the shunt capacitance between link and ground. Find the voltages across two insulators.
Please help with this balanced three-phase circuit problem.
Describe the On-load and No-load in transformers
Three single-phase transformers, each rated 10 MVA , 66.4/12.5 kV, 60 Hz , with an equivalent series reactance of 0.1 per unit divided equally between primary and secondary, are connected in a three-phase bank. The high-voltage windings are Y-connected and their terminals are directly connected to a 115-kV three-phase bus. The secondary terminals are all shorted together. Find the currents entering the high-voltage terminals and leaving the low-voltage terminals if the low-voltage windings are (a) Y-connected and (b) Δ- connected.