Estimate the power for annealed low carbon steel strip 200 mm wide and 10 mm thick, rolled to a thickness of 6 mm The roll radius is 200 mm, and the roll rotates at 200 rev/min; use coefficient of friction at the die-work interface (p) 0.1. A low carbon steel such as AISI 1020 has K (strength coefficient) - 530 MPa and n ( strain hardening exponent) = 0.26

Draw the isometric drawing

how can I get the 85 α

Water at 30°C flows down a vertical pipe with no pressure drop.

Figure 3 of 3 D

So what is the answer? What is y (1)? What is the answer up to two decimal places.

ضحهقهصكسنتلوؤزذ

Incorrect please resolve both parta

In this case, the applied force is always pulls upward, but the amount of force that can be applied can vary between 0-350 N (maximum). The locations of the applied force and resistance cannot be changed. Which of these statement is true? Select one: O The system could lift any resistance less than, but could not lift a resistance = 250 N. The system could lift any resistance that was 350 N. O The system could raise, but would be unable to lower a resistance.

question 3 pls