en For uncontrolled full wave rectifier, R=80ohm, L=0.05H, f=50Hz and Vm=288V. Calculate the amplitude of the 2nd ac voltage (V) term of the output voltage. In your calculations, take 3 digits after the comma and take pi = 3,14; Enter your answer into the system in terms of the desired unit only as a number. Yanıt:

en For uncontrolled full wave rectifier, R=80ohm, L=0.05H, f=50Hz and Vm=288V. Calculate the amplitude of the 2nd ac voltage (V) term of the output voltage. In your calculations, take 3 digits after the comma and take pi = 3,14; Enter your answer into the system in terms of the desired unit only as a number. Yanıt:

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Which stability is called as load stability? Why it is called like that?
Q.6 A motor has a full-load current rating of 74.8 amperes and the terminations are rated for 75°C. What is the minimum conductor size and type? Select one: A. 4 AWG 90°C CONDUCTOR B. 2 AWG 75°C CONDUCTOR C. 2 AWG 60°C CONDUCTOR D. 3 AWG 75°C CONDUCTOR
if the armature winding has fractional pitch of 7/9, then coil span is ___ electrical degress
Explain the phase locked loop and its sub components. Also explain where it is used in real life scenarios.
The fuse in one of the supply phases of a running 3-phase I.M. blows off. Will the motor continue to run at ( i) original speed (ii) reduced speed (iii) come to stand still?
#10 When selecting conductors, from where is the motor full - load ampere rating to be taken
Q3 A)List the types of attraction and induction electomagnetic relays and draw schematic diagram for each type.
22)This multiple choice question from MEASUREMENTS INSTRUMENTATIONS course.
Determine the region where the poles of a second- order system without zeros must be so that the settling time is between 1 to 4 seconds, and the overshoot percentage is between 16.30% and 4.6%.
critically analyse the steady performance of a typical control system with the help of static erorr constans
What system type can track a ramp input with zero steady state error?
Determine the region where the poles of a second-order system without zeros must be so that the settling time is between 1 to 4 seconds, and the overshoot percentage is between 16.30% and 4.6%.