Electric heating systems used in many homes consist of a simple duct with resistance heaters. As it flows over the resistance wires, the air is heated. Consider a 25 kW electric heating system. Air enters the heating section with an air flow rate of 120 m3 / min at 100 kPa and 12 ° C. If 150 W of heat is lost from the air in the duct to the environment, determine the exit temperature of the air

Q: Steam flows steadily through an adiabatic turbine. The inlet conditions of the steam are 4 MPa and…

A:

Q: Air at a pressure of 100 kPa and a temperature of 20 °C enters a compressor. It exits the compressor…

A: (i) Write the given data. P1=100 kPaT1=20+273=293 Kηc=0.75P2=400 kPa

Q: Steam flows steadily through an adiabatic turbine. The inlet conditions of the steam are 6 Mpa, 900…

A:

Q: Steam enters a steam turbine at a pressure of 4 MPa and a temperature of 450 ° C at 25 kg / s. At 1…

A:

Q: P6-18 Air flowing at 0.5 m³/min enters à compres kPa and 25°C. The air exits at 600 kPa and 300°C.…

A: Air flow rate = 0.5 m3/min =0.00833m3/s At entry pressure = 101 kPa At entry Temperature = 25°C=…

Q: Steam flows steadily through an adiabatic turbine. The inlet conditions the steam are 10 MPa, 450°C,…

A: The inlet pressure of steam is .The inlet temperature is The inlet velocity is .The exit temperature…

Q: The refrigerant R-134a enters the compressor of a refrigeration machine at a pressure of 140kPa and…

A:

Q: Steam flows steadily through an adiabatic turbine. The inlet conditions of the steam are 10 MPa,…

A:

Q: Refrigerant-134a enters a compressor at 180 kPa as a saturated vapor with a flow rate of 0.35 m³/min…

A:

Q: Water is heated in a boiler. The inlet water enters as a saturated liquid at 5000 kPa and exits at…

A:

Q: Water initially at 20 °C and having a mass of 100 kg is to be heated to 100°C in a boiler using…

A:

Q: Using the following table, draw a melting point diagram and estimate the eutectic temperature and…

A: Given data To  Draw a melting point diagram Estimate the eutectic temperature and composition

Q: A fan-cooled computer contains eight printed circuit boards, each dissipating 10 W of power. The…

A:

Q: Refrigerant-134a at 1 MPa and 90 degrees * C is to be cooled to 1 MPa and 30 degrees * C in a…

A: Given data as per question The pressure of Refrigerant at entry =1 Mpa The temperature of…

Q: steady flow thermodynamic system receives 100 lb/min of a fluid at 30 psia and 200°F and discharges…

A:

Q: Water flows through a horizontal coil heated from the outside by high temperature flue gases. As it…

A: given; inlet temperature (T1)=800cfinal temperature (T2)=1250cinlet velocity(V1)=3m/sexit…

Q: A cooling tower is a device that cools a spray of water by passing it through a stream of air. If 15…

A: Tdb1=T1=30oc Twb1=T2=20oc Patm=P1=P2=90 Kpa   To find: The partial vapor pressure of entering…

Q: A 1000-gallon compressed air receiver cylindrical tank of internal diameter equal to 5.75 ft is…

A: Given data:The volume of the tank is The internal diameter of the tank is The steady-state operating…

Q: Air flowing at 0.5 m3/min enters a compressor at 101 kPa and 25°C. The air exits at 600 kPa and…

A: Given data as per question Air flow rate = 0.5 m3/min =0.00833m3/s At entry pressure = 101 kPa At…

Q: Air enters a compressor of a jet engine at 0.65 atm and 275 K with a flow rate of 63.5 kg/s. The…

A:

Q: Steam enters the condenser of a steam power plant at 20 kPa and a quality of 90 percent with a mass…

A:

Q: Air enters an electric furnace at 100 KPa and 28°C with a volume flow rate of 22 m3/min. At the exit…

A: Given data: P1=100 kPaT1=28°C=301 KQ˙=22 m3/min=0.3667 m3/sV1=3.7 m/sd1=d2=16 cmd3=0.3 m Need to…

Q: Air is compressed in a piston-cylinder device in a reversible isothermal process at a temperature of…

A:

Q: Steam flows steadily through an adiabatic turbine. The inlet conditions of the steam are 4 MPa,…

A:

Q: NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to…

A:

Q: The gas turbine unit is rejecting heat at certain rate but your client is unsure about it. To…

A:

Q: ater flows through a horizontal coil heated from the outside by high temperature flue gases. As it…

A: given

Q: In a steady flow apparatus, 135 kJ of work is done by each kg of fluid. The specific volume of the…

A: Answer: The specific internal energy is -20 kJ/kg (Decreases). Hence, the correct answer is option…

Q: NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to…

A:

Q: An adiabatic open feedwater heater in an electric power plant mixes 0.2 kg/s of steam at 100 kPa and…

A: Outlet mass flow rate= 11.7Kg/s And the outlet velocity= 16.83m/s

Q: Steam enters the condenser of steam power plant at 20 kPaa and quality of 95% with a mass flow rate…

A: Answer: (a) The heat rejected by the condenser is 12446.58333 kW. (b) The mass flow rate of the…

Q: The refrigerant R-134a enters the compressor of a refrigeration machine at a pressure of 140kPa and…

A:

Q: he refrigerant R-134a enters the compressor of a refrigeration machine at a pressure of 140kPa and a…

A:

Q: Steam enter a turbine stage with an enthalphy of 3628 kJ/kg at 70m/s and leaves the same stage with…

A:

Q: The refrigerant R-134a enters the compressor of a refrigeration machine at a pressure of 140kPa and…

A: Refrigeration Refrigeration is the process in which heat is extracted from the body or space whose…

Q: A steady-flow thermodynamic system receives 100 lb/min of fluid at 30 psia and 200 Fahrenheit and…

A: given data  flow rate m=100 lb/min=0.755 kg/s  Inlet pressure P1=30 psia  Inlet temperature…

Q: A 3m³ rigid, insulated tank that is initially evacuated is connected through a valve to a supply…

A: