What is the airport reference temperature, if the monthly mean of average daily temperature for the hottest month of a study year = 24°C and the monthly mean of the maximum daily temperature for the same month of the same year = 30°C

What is the airport reference temperature, if the monthly mean of average daily temperature for the hottest month of a study year = 24°C and the monthly mean of the maximum daily temperature for the same month of the same year = 30°C

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Do it fast
For a sample of water, total solids was 1237 ppm, electrical conductivity reading was 1760 microSiemens per centimeter (uS/cm), what is the value of total suspended solids and total dissolved solids in ppm?
A 40 foot high window wall is on the exterior of a concrete building inChicago. What is an appropriate extreme temperature range?
Heat Transfer 1. If you have a piece of extruded polystyrene insulation that has an R-value of 5 hr ft?.°F/Btu per inch [or RSI = 0.8805 (m² · K)/W)]. How many inches of extruded polystyrene do you need in your wall if you want it to have an R-value of 20 hr ft2.°F/Btu [or RSI = 3.522 (m² · K)/W)]? L= 4" 2. What is the transfer of vibrational energy due to collisions between neighbouring atoms and molecules in a solid called? a. Conduction b. Convection c. Radiation d. Latent Heat Radiant Energy 3. Absorptance is a measure of the relative amount of radiant energy absorbed by a surface. Does a shiny and smooth polished aluminum surface have a high absorptance (closer to 1), or a low absortptance (closer to 0)? Absorptance is a ratio of the radiation absorbed to the radiation received, and thus is dimensionless. What about reflectance? Are absorptance and reflectance related? 4. Emissivity is a measure of the relative amount of radiant energy emitted by a surface. Does a shiny and smooth…
Civil Please show calculation with all steps
I need the answer as soon as possible
Answer 3
Imagine a parcel of air that has a temperature of 40°C at the surface and a dew-point temperature of 20°C at the lifting condensation level. Assume that the environmental lapse rate is 8°C per 1000 meters, the dry adiabatic lapse rate is 10°C per 1000 meters, and the wet adiabatic lapse rate is 6°C/1000 meters. In Table C , record the environmental temperature, the parcel temperature, and the temperature difference (parcel temperature minus the environmental temperature), and then determine whether the atmosphere is stable or unstable at each height. a. What is the height of the lifting condensation level? b. Does this example describe absolute stability, absolute instability, or conditional instability? c. Would you forecast thunderstorms under these conditions?
subject: engineering utilities
Show simple complete solution with formula
Estimate the vapor pressure, air pressure, relative humidity, and air density at a height of 1800 m into the atmosphere. The total pressure is 101 kPa, air temperature is 25°C and the dew point temperature is 15°C near the ground, the lapse rate 7.5°C/km, which is constant for both air temperature and dew point temperature. The gas constant R is 287 J/kg-K and constant with respect to altitude. Vapor Pressure at 1500m, in Pa Round to the nearest whole number Add your answer
A thermometer is removed from a room where the air temperature is 70°F and is taken outside, where the temperature is 10°F. After ½ minute the thermometer reads 50°F. What is the reading of the thermometer at t = 1 min? How long will it take for the thermometer to reach 15°F