Draw the shear diagram for the beam. Follow the sign convention. Click on "add vertical line off" to add discontinuity lines. Then click on "add segment" button to add functions between the lines. Note 1 - Make sure you place only one vertical line at places that require a vertical line. If you inadvertently place two vertical lines at the same place, it will appear correct visually because the lines overlap, but the system will mark it wrong. Note 2- Indicate the segments for all values of x shown in the diagram. Even if a segment is a constant value 0, it should be drawn in the diagram. > View Available Hint(s) 50 lb/ft 200 Ib-ft C 20 ft 10 ft No elements selected V, Ib 600 500 400 300 200 100 1, ft 30 + 10 20 -100 -200 -300 -400 -500 -600

Draw the 1st and 3rd Angle Orthographic sketch of the following part:

I have a drawing layout with a standard ( correct drawn) marking consisting of two concentric circles and to right a trapezoid lying on its side this indicates A. 1 angle projection is used  B. 3 angle projection is used  C. isometric projection is used D. orthogonal projection

Orthographic drawing Needed ( top, front and side view) there are no dimensions

If a drawing has 6 fillets with radius (1/2 inch) for imperial units drawing, name one way that you can dimension them? Remember the rule for imperial units for leading 0 for anything that is less than 1. Radius shall be in decimal.

Orthographics: Add missing lines and complete any missing views. Draw the isometric