Answered: Discuss the two cases, constructive…

Discuss the two cases, constructive and destructive interferences, as a result of thin-film interference. (Provide figure/s to support your statement.)

University Physics Volume 3

17th Edition

ISBN:9781938168185

Author:William Moebs, Jeff Sanny

Publisher:William Moebs, Jeff Sanny

Chapter4: Diffraction

Section: Chapter Questions

Problem 97AP: A diffraction grating with 2000 lines per centimeter is used to measure the wavelengths emitted by a...

See similar textbooks

Related questions

Q: The separation of the slits, d, is slowly increased. What happens to the pattern on the screen? The…

Q: What would you see in your viewing screen for double slit? Draw it

A: In Double slit experiment there would be regular pattern of bright and dark fringes.

Q: Sketch and explain the pattern that would have been on the screen of a single-slit setup if light…

A: Light is interesting and mysterious because it consists of both a beam of particles, and of waves in…

Q: Suppose the interference pattern shown in the figure below is produced by monochromatic light…

A: Consider the distance between the slits of the diffraction grating be d, the wavelength of the light…

Q: A piece of transparent material having an index of refraction n is cut into the shape of a wedge as…

A: The condition for constructive or bright fringe is

Q: Write the distinguishing features between a diffraction pattern due to a single slit and the…

A: Diffraction: It refers to the bending of light wave when passed through the corners of an obstacle…

Q: must be incident normally on the slit

A: Which of the following conditions must the light satisfy to obtain an observable double silt…

Q: Explain how the demonstration and the result of thin films changes if you look at transmitted rays…

Q: Which will give wider-spaced fringes, a double-slit experiment in air or in water? (Let Figure 29.18…

A: Given: double slit experiment

Q: A laser is shone on two narrow slits, fully illuminating both slits, producing an interference…

A: Interference pattern is seen when light waves from two sources do interference with each other . Due…

Q: In a double slit experiment, the distance between the slits is 0.2 mm and the distance to the screen…

Q: The figure shows the light intensity on a screen 2.7 m behind a double slit. The wavelength of the…

Q: The following questions refer to the following pattern obtained from a double-slit interference…

A: First order maxima is the position where we get bright fringe after the central maxima.

Q: The diagram below shows a double-slit interference in (a) and car headlights in (b). Would th…

A: For interference light sources must be coherent that is they should emit light waves of the same…

Q: In the figure 1 given below, b and c are filtered images of a. Identify the image that is low-pass…

A: Image resulting from the low pass and high pass filter is to be determined here.

Q: What happens to the diffraction pattern as the number of slits increases

A: If number of slits increases

Q: Suppose the interference pattern shown in the figure below is produced by monochromatic light…

Q: Consider the interference pattern in the diagram. (The crests are represented by thick lines and the…

A: Given: S1A = 49.5 cm S2A = 60.5 cm

Q: alculate the angle in degrees at which a 2.10 µm wide slit produces its first minimum for 410 nm…

A: Given Wavelength of violet light λv=410nm Wavelength of red light λr=715 nm Slit width d=2.10µm

Q: Evaluate the formula xm = (L m λ) / D for single slit diffraction experiment

A: To evaluate: xm=LmλD

Q: Two polarizing filters are set up, one vertical and one horizontal as show in the diagram below.…

Q: In a two slits experiment, write down the condition for obtaining interference and diffraction…

A: For obtaining interference and diffraction patterns on screen the sources of waves should be…

Q: Give the theory of formation of fringes in Michelson interferometer. How will you use to determine…

A: Interference refers to superposition of 2 light waves. These two light waves comes from coherent…

Q: What would you see in your viewing screen for seven slit? Draw it

A: The interference pattern in a double-slit experiment is modulated by diffraction from each slit. The…

Q: The diffraction pattern seen below is due to N-slits. What is the number of slits that are capable…

A: There are 4 small maxima in between 2 maxima. So total number of slits = 2+4 = 6

Q: please explain these Due to the increase in number of slits the diffraction become more sharper,…

Q: What would you expect to see on the screen intuitively if diffraction was not present?

A: Required : What would we expect to see if diffraction were not present.

Q: The analysis of any two-point source interference pattern and a successful determination of…

A: In Young's double-slit experiment -Distance between slit = dDistance from Slits to Screen =…

Q: The following patterns are created by the interference of monochromatic light. The shaded regions…

Q: If the distance between the slits and the screen in Young's double slit experiment is increased,…

A: In YDSE we know that for maxima y = nλD / d D= distance between the screen and slit For minima y=…

Q: Which of the following results to reduced separation of bright fringes from a double slit? A.…

A: As we know, the slit separation is given by the formula -…

Q: If white light is used in young's double slit experiment, how would be the pattern change?

A: Young’s double-slit experiment shows the light’s wave nature. In this, when a light wave is passed…

Q: Christopher uses monochromatic light and shines it on a material with index of refraction 1.5,…

A: Given: Refractive index μ=1.5 wavelength λ = 526nm

Q: Consider the single-slit diffraction pattern created by each slit. How do these single slit patterns…

A: Interference and diffraction are the phenomenons that prove treat light as a wave. Diffraction is…

Q: A beam of 604 nm light passes through two closely spaced glass plates, as shown in Figure. For what…

Q: For a double-slit configuration where the slit separation is four times the slit width, how many…

Q: The analysis of any two-point source interference pattern and a successful determination of…

Q: : For the geometry below, assume the carrier frequency is 900 MHz Tx Rx 50 m 50 m 500 m 500 m…

A: in this knife edge diffraction method is used to find height of obstacle.

Concept explainers

Diffraction of light

In physics, the term diffraction is defined as the bending of light around the corners of the obstacle. As a light ray passes by an aperture, it bends around the edges or through slits, it spreads out through a narrow opening. The diffracted light will produce fringes of bright and dark or colored bands which are labeled as a diffraction pattern.

Question

Discuss the two cases, constructive and destructive interferences, as a result of thin-film interference. (Provide figure/s to support your statement.)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

$Diffraction of light$

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

The analysis of any two-point source interference pattern and a successful determination of wavelength demands an ability to sort through the measured information and equating the values with the symbols in Young's equation. Apply your understanding by interpreting the following statements and identifying the values of y, d, m and L. Finally, perform some conversions of the given information such that all information share the same unit. Consecutive bright bands on an interference pattern are 3.5 cm apart when the slide containing the slits is 10.0 m from the screen. The slit separation distance is 0.050 mm. y= ________ d=________ m=_______ L=________
How far would you place a screen from the slit of the previous problem so that the second minimum is a distance of 2.5 mm from the center of the diffraction pattern?
In a double slit experiment, the distance between the slits is 0.2 mm and the distance to the screen is 100 cm. What is the phase difference (in degrees) between the waves from the two slits arriving at a point 5 mm from the central maximum when the wavelength is 400 nm? (Convert your result so the angle is between 0 and 360°.)
The analysis of any two-point source interference pattern and a successful determination of wavelength demands an ability to sort through the measured information and equating the values with the symbols in Young's equation. Apply your understanding by interpreting the following statements and identifying the values of y, d, m and L. Finally, perform some conversions of the given information such that all information share the same unit. If two slits 0.100 mm apart are separated from a screen by a distance of 300 mm, then the first-order minimum will be 1 cm from the central maximum. y= ________ d=________ m=_______ L=________
The analysis of any two-point source interference pattern and a successful determination of wavelength demands an ability to sort through the measured information and equating the values with the symbols in Young's equation. Apply your understanding by interpreting the following statements and identifying the values of y, d, m and L. Finally, perform some conversions of the given information such that all information share the same unit. a. Two slits separated by 0.250 mm produces an interference pattern in which the fifth dark band is located 12.8 cm from the central antinode when the screen is placed a distance of 8.2 meters away. y= ________ d=________ m=_______ L=________
Two radio antennas separated by d = 275 m simultaneously broadcast identical signals at the same wavelength. A car travels due north along a straight line at position x = 548 m from the center point between the antennas, and its radio receives the signals. If the car is at the position of the 3rd maximum after that at point O when it has traveled a distance y = 403 m northward, what is the wavelength of the signals? Note: Do not use the small-angle approximation in this problem. To continue enter the result in m. Round your answer to 0 decimal places
The analysis of any two-point source interference pattern and a successful determination of wavelength demands an ability to sort through the measured information and equating the values with the symbols in Young's equation. Apply your understanding by interpreting the following statements and identifying the values of y, d, m and L. Finally, perform some conversions of the given information such that all information share the same unit. Two slits that are 0.200 mm apart produce an interference pattern on a screen such that the central maximum and the 10th bright band are distanced by an amount equal to one-tenth the distance from the slits to the screen. y= ________ d=________ m=_______ L=________
An intereference pattern is produced by light with a wavelength of 560 nm from a distant source incident on two identical parallel slits seperated by a distance (between centers) of 0.580 mm. (A) if the slits are very narrow what would be the angular position of the first order two slit intereference maxima? Express your answer in radians. (B) what would be the angular position of the second order two slit intereference maxima in this case?
Write the distinguishing features between a diffraction pattern due to a single slit and the interference fringes produced in Young’s double slit experiment?
What minimum path length is needed to introduce a phase shift of 205° in light of wavelength 566 nm? (Give your answer in nm.) What phase shift will that path difference you calculated in part (a) introduce in light of wavelength 799 nm? (Give you answer in degree.)
What happens to the diffraction patters when the following are changed? Thoroughly describe each. a. The width of a single slit, w b. The width w and separation d of double slit c. The number of multiple slits N d. The distance from the slit plate to the sensor L e. The experimental y value collected from your data.
If X-ray diffraction peaks corresponding to the firstthree orders (m= 1,2 and 3) are measured, can both theX-ray wavelength λ and lattice spacing d be determined?Prove your answer