Determine the change in internal energy of 1.00 liter of water (mass 1.00 kg) at 125°C when it is fully boiled from liquid to gas, which results in 1850 liters of steam at 125°C. Assume the process is done at atmospheric pressure.

Determine the change in internal energy of 1.00 liter of water (mass 1.00 kg) at 125°C when it is fully boiled from liquid to gas, which results in 1850 liters of steam at 125°C. Assume the process is done at atmospheric pressure.

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter3: The First Law Of Thermodynamics

Section: Chapter Questions

Problem 80AP: A car tile contains 0.0380 m3 of air at a pressure of 2.20105 Pa (about 32 psi). How much more...

See similar textbooks

Related questions

Q: Sean & Shawn are in a laboratory in Earth's rest frame and say that Mo & Neji's spaceship's…

A: The ratio of the speed of spaceship to the speed of light is 0.750Explanation:

Q: The figure shows a conical pendulum, in which the bob (the small object at the lower end of the…

A: a.) Tension in the string,T=0.336Nb.) Period of the motion,t=1.70s (Period can also be calculated…

Q: 7. Find the distance a person can be from the wall and still be in equilibrium. Hanging mass = 21 kg…

A: Draw the free-body diagram of the system.

Q: Suppose you run 3 A through a 5 cm long wire. You apply a 1000 μT field perpendicular to the wire.…

Q: The figure shows a ball with mass m = 0.471 kg attached to the end of a thin rod with length L =…

Q: Write the equation for the magnetic moment of a current carrying loop. Use the right hand rule to…

A: A current carrying loop is showing in figure.

Q: q1= 2.0 nC q2= 2.0

A: A) Free body diagram is shown in the figure.B) Magnitude of net electric field at A is 2×104N/C. And…

Q: A copper block with an initial temperature of 12°C is dropped into 550g of water initially at 79°C,…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: A monatomic ideal gas with y = 1.67 undergoes a process that changes the pressure linearly with…

Q: Consider a point charge q = 1.3 µμC, point A at distance d₁ = 2.0 m from q, and point B at distance…

Q: 4. What is the equation of motion of a point-like particle with charge q and mass m in an…

A: dW/dt=qE.vThis expression gives us the rate at which the energy of the particle is changing in the…

Q: Three resistors are made out of three different materials and have different (but uniform) corss…

A: R1=2.03Ω R2=1589.4986Ω R3=0.0177ΩExplanation:

Q: In a paragraph could you explain in your own words, how you would distinguish Inelastic collision,…

A: The collision is defined as the contact of two objects with each other for an instant or very short…

Q: 17.15 rad/s 14. The total acceleration of a point on a rim of a 1.5-m diameter pulley is 9m/s² when…

Q: A 35.0 V battery with negligible internal resistance, a 50.02 resistor, and a 1.25 mH inductor with…

A: Voltage is Resistance is Inductance is Note:Find:(a) Time in which the current through the inductor…

Q: Crates A and B have equal mass. Crate A is at rest on an incline that makes and angle of theta =…

A: Draw the free-body diagram for situation 1.Apply the equilibrium condition of forces along the…

Q: A dime is dropped from a hot-air balloon that is 64 m above the ground and rising vertically at 17…

Q: 6. How is electricity produced in most nuclear power plants? A. They use the heat from fission…

A: Production of electricity in nuclear plant:

Q: X 4.92 J 9. A certain spring has 13.0 J of elastic potential energy stored when compressed 0.26 m.…

Q: 1 GV 2 حد w R1= 1000 Ohms R2=2000 Ohms R3=4000 Ohms FinD the voltage Drop and current Flowing…

Q: Problem 1: What are 11, 12, and 13 in the circuit below? Answers: I₁ = 4.75 A, I₂ = −3.5 A, 13 =…

A: All the three currents marked in the circuit have been calculated . If any doubt please feel free to…

Q: A magnetic field directed into the page changes with time according to B = 0.031 0+2 + 1.40, where B…

A: The derivation and solution is provided with explanation for clarity.Explanation:

Q: 8. A spring of 21 cm length reaches 30.8 cm after hanging a mass of 1/4 kilogram on it. The medium…

A: 8A spring of 21 cm length reaches 30.8 cm after hanging a mass of 1/4 kilogram on it.Initial length…

Q: 2. A circular plane, with a radius of 2.2 m, is immersed in an E-Field with a magnitude of 800 N/C.…

Q: 23. An airplane travels due south at an airspeed of 800 km/h. It encounters a wind blowing at 85…

Q: Re write again text form not handwriting. Also need substitutions please do it. 1 and 2. Physics…

Q: Ronaldo is playing outside and shoots a ball of mass 2 kg horizontally with a speed of 8.0 m/s…

A: velocity of the cart after the ball strikes it = (-1/17) m/sInitial kinetic energy of the system =…

Q: 4πke c2 By how much is the approximation B = μonI [or in terms of Coulomb's constant k₁, B = ] in…

A: Draw the schematic diagram of the system.Write the expression of the tangent of angle .

Q: (a) What is the characteristic time constant of a 24.2 mH inductor that has a resistance of 4.10 ?…

Q: A uniform electric field exists everywhere in the x, y plane.This electric field has a magnitude of…

A: The uniform electric field in the x y plane is the direction of the electric field in the direction…

Q: g.pearson.com/?courseld=12649908&key=11586169831721112952112024#/ A simple series circuit consists…

A: As per student's request I am only solving part D.

Q: 18. A beam of light passes from air into a transparent petroleum product, cyclohexane, at an…

A: 1.44Explanation:

Q: A semi-permeable membrane separates the contents of cell. The concentration of sodium ions is 2 mol…

A: Pressure outside: Tonicity: HypotonicExplanation:

Q: What is the resultant force in terms of the force vectors F1, and F2?

A: The objective of the question is to find the resultant force when two forces F1 and F2 are acting on…

Q: Two pucks are placed on an air table. The projectile puck of mass 0.15 kg is launched towards the…

A: mass of projectile puck = m1 = 0.15 kgmass of target puck = m2 = 0.1 kginitial speed of projectile…

Q: Two cars collide at an icy intersection and stick together afterward. The first car has a mass of…

Q: The pilot of an aircraft flies due east relative to the ground in a wind blowing 13 km/h toward the…

A: The objective of this question is to find the speed of the aircraft relative to the ground when…

Q: .A neutral sodium atom has an ionization potential of 5.1 eV from its ground state. (1) What is the…

A: For a neutral sodium atom - Ionization potential= 5.1 eV

Q: Find the position of the ball (magnitude and direction) and its velocity (magnitude and direction) A…

A: The position of the ball along the vertical direction is 44.48The position of the ball along the…

Q: Hello please help answer this PH question? See attachement

A: 1. Crate is the object of interest, as it is the motion of crate which we are studying and not the…

Q: As shown in the figure, a 4.0-kg block is moving at 5.0 m/s along a horizontal frictionless surface…

A: The objective of the question is to find the speed of the block when the spring is compressed to a…

Q: In the figure, a 4.1 kg block is accelerated from rest by a compressed spring of spring constant 660…

Q: Consider the systemshown in Fig. P6.86. The ropeand pulley have negligible mass,and the pulley is…

A: Final Velocity (Vf) = 2.90 m/sExplanation:Step 1: Draw the figure. Step 2: Write all the given.…

Q: Two mL of water passes a given cross-section of a pipe in 5s. The flow rate Q is For this value of…

Q: For an incompressible fluid flow, the flow rate increases in the narrow sections of the flow…

A: We need to select the correct property of flow rate of incompressible flow.

Q: A 35.0 V battery with negligible internal resistance, a 50.02 resistor, and a 1.25 mH inductor with…

A: Voltage is Resistance is Inductance is Note:

Q: A student launches a small rocket which starts from rest at ground level. At a height 1.74 km, the…

A: The objective of the question is to calculate the acceleration of the rocket during its launch until…

Q: Figure 2 of 2 An electron moves with a speed of 3.5 x 107 m/s in the directions shown in (Figure 1)…

Q: Find the equivalent resistance of the combination of resistors R1 = 42.0 Ohms, R2 = 75.0 Ohms, R3 =…

A: The equivalent resistance = {(1/((1/R1+1/R2) +R3 +R4)) +1/R5)} + R6Explanation:R1 and R2 are in…

Q: (c) For the work done by the force on the crate, we have WF=F. Ar = 111 N ( (m) о m cos = J.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Given :-

VIEW

Step 2: Calculation of Change in internal energy :-

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A car tile contains 0.0380 m3 of air at a pressure of 2.20105 Pa (about 32 psi). How much more internal energy does this gas have than the same volume has at zero gauge pressure (which is equivalent to normal atmospheric pressure)?
One mole of an ideal gas does 3 000 J of work on its surroundings as it expands isothermally to a final pressure of 1.00 atm and volume of 25.0 L. Determine (a) the initial volume and (b) the temperature of the gas.
If a gas is compressed isothermally, which of the following statements is true? (a) Energy is transferred into the gas by heat. (b) No work is done on the gas. (c) The temperature of the gas increases, (d) The internal energy of the gas remains constant, (e) None of those statements is true.
An ideal gas with specific heat ratio confined to a cylinder is put through a closed cycle. Initially, the gas is at Pi, Vi, and Ti. First, its pressure is tripled under constant volume. It then expands adiabatically to its original pressure and finally is compressed isobarically to its original volume. (a) Draw a PV diagram of this cycle. (b) Determine the volume at the end of the adiabatic expansion. Find (c) the temperature of the gas at the start of the adiabatic expansion and (d) the temperature at the end of the cycle. (e) What was the net work done on the gas for this cycle?
The energy input to an engine is 3.00 times greater than the work it performs. (i) What is its thermal efficiency? (a) 3.00 (b) 1.00 (c) 0.333 (d) impossible to determine (ii) What fraction of the energy input is expelled to the cold reservoir? (a) 0.333 (b) 0.667 (c) 1.00 (d) impossible to determine
A sample of a monatomic ideal gas occupies 5.00 L at atmospheric pressure and 300 K (point A in Fig. P17.68). It is warmed at constant volume to 3.00 atm (point B). Then it is allowed to expand isothermally to 1.00 atm (point C) and at last compressed isobarically to its original state. (a) Find the number of moles in the sample. Find (b) the temperature at point B, (c) the temperature at point C, and (d) the volume at point C. (e) Now consider the processes A B, B C, and C A. Describe how to carry out each process experimentally. (f) Find Q, W, and Eint for each of the processes. (g) For the whole cycle A B C A, find Q, W, and Eint. Figure P17.68
A gas in a cylindrical closed container is adiabatically and quasi-statically expanded from a state A (3 MPa, 2 L) to a state B with volume of 6 L along the path 1.8pV= constant. (a) Plot the path in the pV plane. (b) Find the amount of work done by the gas and the change in the internal energy of the gas during the process.
When a gas undergoes an adiabatic expansion, which of the following statements is true? (a) The temperature of the gas does not change. (b) No work is done by the gas. (c) No energy is transferred to the gas by heat. (d) The internal energy of the gas does not change. (e) The pressure increases.