Convert 100 micro ohm to Fahrenheit degrees.

Q: Flag question Time period of voltage waveform(household power supply) in Sultanate of Oman is…

A: Oman country  using 50 hz supply frequency

Q: If a voltage spike lasts for 1.5 nanoseconds, what is the frequency of the spike?

A: Voltage spike is defined as sudden rise in voltage which is very higher than normal voltage for very…

Q: R= 60 X = 80 I= 20A 200V Figure 1

A:

Q: Find the unknown quantities indicated in Figure 1. (ANS: 10V) 2 V 20 V 3 6 V igure

A: Kirchhoff's Voltage Law states that The algebraic sum of all voltages in a loop must…

Q: e^-at (1)n C Ot^2 For the Photoflash unit, Vs= 9V, R1=5KQ, C=D1500 uf , R2= 120. The average power…

A:

Q: Question -07 A 0-10V PMMC meter reads 4V reading. Suddenly spring snaps at one place, then the meter…

A: When the spring snaps at one place , then the meter shows a reading of 0 V.

Q: alternative name for volt/ohm

A:

Q: Sisto of ohms. A 00r

A:

Q: Show all work. Please type so I card read. Calculate the voltage value of a sine wave at 135° whose…

A: Given: Phase angle, θ=135° RMS voltage, Vrms=1000 V

Q: Mark the WRONG statement. In induction type kWh meters

A: The induction type energy meter consists of an aluminium disc and it is placed between two…

Q: How to make Electrical Generator 9v

A:

Q: 3- The scale of dynamometer instrument

A: given dynamometer

Q: Find Ip in A (ampere) unit if E is 11 and R is 537. (Answer should roundoff to 3 decimal places) VD…

A:

Q: Vi (p-p)= 10 volt (Sinewave)

A: Clamper is a circuit which changes the DC level of input. It inserts a DC value in ac waveform.

Q: Which of the following shows the CORRECT unit of the lighting concept? a Illuminance: lumen (Im) b.…

A: The brightness seen by the human eye can be used to subjectively measure light. Candles, lumens,…

Q: 10 ohm 10 ohm 100 ohm OFF 20 V 200 ohm

A: Consider the following circuit diagram I=I1+I2............. equ 1

Q: 15) E.M.F has the unit of (A) Power (B) Energy (C) Charge (D) None of the above.

A: Generally the units of E.M.F is Volts .

Q: b. The apparent power absorbed by the resistor c. The peak power absorbed by the resistor d. The…

A:

Q: The unit of current is: Select one: O a. volt O b. coulomb O c. ampere O d. joule

A: The SI unit of current is Ampere which measures the flow of electric charge across a surface at the…

Q: Draw rough sketches showing the following: a. A current which lags the voltage by 60°. b. A current…

A: Phasors rotates in anti clockwise. Current lags the voltage means current comes after voltage.

Q: V_c(00) is found to be (in Volt) None of the choices

A: The solution is given below

Q: If the average of set of voltage reading is 55.2V. The precision for one of the reading 50.1, will…

A: In this question we need to find a precision of the voltmeter.  Precision refers to how close we get…

Q: Wb / m2 represents O a. watt O b. Henry O c. Joule O d. Tesla

A: Given, WB/m2 represents=?

Q: Moving Iron meter displays value. (a) RMS (b) average (c) peak (d) instantaneous

A: Moving iron instrument measure RMS value.

Q: Ibq=30 mikroamper B=99 R2=?

A: As we have given : VCC=15 VR1=10 kΩRC=2 kΩR=1 kΩIB=30 μAβ=99

Q: Differentiate between Solar Irradiance, Solar Irradiation and Peak Sun Hour. State the explaination

A: Solar Irradiance is as follows: - The sun based irradiance is the yield of light energy from the…

Q: Frequency of power supply is 50 Hz. The time period to complete 8 cycles in seconds is:

A: In this question, choose the correct option What is value from peak positive to peak negative?  What…

Q: A low duty cycle will indicate; Low peak power  High Average power  Low Average power  High…

A:

Q: Determine the magnitude of the current 12 (expressed in Ampere! ( please answer max 20 minutes thank…

A: Apply KVL in two loops and than solve the equation for current I2. According to KVL sum of voltages…

Q: A tungsten lamp filament has a temperature of 20.5 degrees Celsius and a resistance of 500 ohms when…

A:

Q: An A C voltmeter reads 250 V What is ts peak and nstantaneous values if the frequency of alternating…

A: Answer for the circit is as follows

Q: has a value of 1 ohm. 1 ohm. in ww-

A:

Q: Convert 10hr, 100 min and 100s into ms

A:

Q: sistance of the resistor is 100 Ohm. urce is 100 W. what is the rms voltao

A:

Q: Identify the color code for each of the following resistance values: a ) 150 Ω+ 10 b) 720 kQ ± 5%

A: Given: a) 150Ω±10b) 720 kΩ±5%

Q: Match The following. pyrolysis reactor produces liquid of 75%. Choose. pyrolysis reactor produces…

A:

Q: 210345 999 -24/7 A

A:

Q: 7,00 mH 2,00N b. 3,00N 9,002 5,00N d e 5,002 11,02 3,00 V 1,002 S h

A:

Q: 1A 1n Vo

A:

Q: please determine the voltage measured by the voltmeter

A: Apply KCL at node connecting 6 , 6 , 3 ohms resistors and using ohms law write the equation in terms…

Q: Q3\ The following values were obtained from the measurements for a resistor in ohms: 220.2, 221.1,…

A:

Q: What current will flow in a 10 ohms resistor if the voltage wave increases linearly from 50 to 100…

A:

Q: 1. An ammeter reads 22 A through a resistive load. What is the peak value of the alternating…

A:

Q: my 220A ふも 12 0 Volt 4.7 Draw the out Pu

A:

Q: Which of the following can be the unit of reactive power? a. Mega Volt Ampere b. Mega Watt Reactive…

A:

Antenna Characteristics

The antenna is an important concept in the domain of electronics and communication engineering. An antenna forms an integral part of many commonly used devices such as wireless modems, routers, game controllers, mobile phones, bluetooth devices, and so on. In simple terms, any wireless communication makes use of antennas to serve the purpose. An antenna, also known by the term 'arial', is an electrical device that converts electrical signals into electromagnetic waves or electromagnetic waves into electrical signals. An antenna contains a transmission line usually made up of co-axial cable, it then receives the signals and converts them into electromagnetic waves, which are then transmitted via space into their required destination. A communication system essentially makes use of two antennas, a transmission antenna, which converts electrical signals into electromagnetic waves, and a receiving antenna, which receives the electromagnetic waves and converts them back into electrical signals.