Sol this Q fast plz ICin a DAC acts as an amplifier toamplify the analog output voltage. flag will be reset whenever the resultis positive.

741 op-amp IC is an circuit which can provide high voltage gain hene act as an amplifier.

Answered: IC in a DAC acts as an amplifier to…

Engineering

Electrical Engineering

IC in a DAC acts as an amplifier to amplify the analog output voltage.

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter2: Basic Electricity

Section: Chapter Questions

Problem 18RQ: True or False: All atoms tend to lose electrons.

See similar textbooks

Related questions

Q: At high frequencies in an AC bridge, the source is _______ a) tuned amplifiers b) oscillators c)…

A: Electronic oscillators are used as a source of bridge measurement in the AC bridge circuit on high…

Q: sing a thermistor, an amplifier, a transistor, and some basic ele omponents. Sketch the schematic…

Q: 4. For the FET Hartley Oscillator in Figure 5: a) Explain how it works and give its practical…

A: I have answered all three subparts below.

Q: In a digital voltmeter, the oscillator frequency is 400 kHz. A ramp voltage to be measured by this…

A: Given, In a digital voltmeter, The oscillator frequency, f = 400 kHz So, time period, T=1f=1400…

Q: An oscillator produces.... A) Damped. Oscillations: OModulated. B) Undamped. D) None of the above

A: In this question, Choose the correct option An oscillator produces..... Oscillations.

Q: 3. A FET Wien-bridge oscillator is shown in the following figure. out FET Given: C = 0.05 µF. The…

A: For the given FET Wien bridge oscillator shown below we need to (1) Explain the working of the…

Q: +10 V Q1 R3 Calculate the frequency of 5 mH C2 C3 oscillation for each circuit in Figure below and…

A: (a)

Q: Q1 R1 Calculate the frequency of C3 1000 pF 5 mH C2 oscillation for each circuit in Figure below and…

Q: 3x8 multiplexer Ca,b,c are mux inputs): a フ+

A: The function at each output terminal of a decoder is a min term and the function is given is max…

Q: Use the following circuit to design an oscillator of 5 kHz output. The amplifier used in this…

Q: evice acti | tank circuit |op amp | transistor inductor e drawback of LC oscillators are | Poor…

A: These are the few basic questions related to the understanding of oscillators such as LC and RC…

Q: Given: a) analyze and draw the output waveform of Vo. Vi = 15 V E = 8 V b) identify what type of…

Q: PMMC Instrument can be used to measure ac current if . is added ..... .. Rectfier Amplifier A/D…

A: In this question we need to choose a correct option.

Q: An oscillator differs from an amplifier because it * Requires no DC Has more gain Requires no input…

A: In this question we will write about oscillator etc...

Q: Consider R1=10 kN, R2=30kN, R3=R4=20 kN, C= 0.5µF; Connect =Vs to =12V for the Wein bridge…

A: Given that R1=10KΩR2=30KΩR3=20KΩR4=20KΩC3=C4=C=0.5μF In the case of wein bridge of oscillator,…

Q: c. In Digital IC applications a MOSFET transistor is a symmetrical device i.e. the source and the…

A: MOSFET (Metal Oxide Semiconductor Field Effect Transistor) transistors are semiconductor devices…

Q: A JFET is set up as a follower, with = 200, r = 100 kn and source load resistor R₂ = 1 k. The output…

A: Given: A JFET is set up as follower with, The amplification factor, μ=200Drain resisatnce, rd=100…

Q: V Draw a Wien bridge oscillator Write the frequency of oscillation Write the condition of…

A: Wien bridge oscillator is an audio frequency sine wave oscillator of high stability and simplicity.…

Q: An oscillator is to have the following parameters f = 700 Hz; Av = 29; C = 3300 pF; Vi = 276 mV. %3D

A: Given in the question: Capacitance = 3300 pF Voltage gain AV = 29 Frequency, f = 700 Hz Input…

Q: Q 5. A circuit diagram of the Wein bridge oscillator is shown in figure 6. Derive the necessary…

A: Given Circuit of Wein Bridge, Given conditions, C1C2=a, R1R2=1b

Q: Q 5. A cireuit diagram of the Wein bridge oscillator is shown in figure 6. Derive the necessary…

A: Given oscillator is Wein bridge oscillator. In this circuit feedback is given to non-inverting…

Q: Q3: In a wien- bridge oscillator circuit, Z1 consists of R,C and L in se only a resistor R3. find…

Q: Q3: In a wien- bridge oscillator circuit, Z1 consists of R,C and L in series, and Z2 is only a…

Q: The voltage follower circuit is used as a Amplifier oscillator Buffer comparator

A: The voltage follower circuit is used as ....

Q: The samples of analog signal is converted to digital signals by using which of the following…

Q: Determine the period and frequency of oscillation for an astable multivibrator with component values…

A: The astable multivibrator generate square wave. It doesn't require any external triggering pulse.…

Q: Q2/ for the Circuit shown below, find the frequany if the oscillator is loaded to apoint andrp where…

A: The above given circuit is known as Colpitts oscillator circuit.

Q: IV Draw a Wien bridge oscillator Write the frequency of oscillation Write the condition of…

A: To design a wein bridge oscillator

Q: Use the following circuit to design an oscillator of 5 kHz output. The amplifier used in this…

A: According to the question we have Use the following circuit to design an oscillator of 5 kHz output.…

Q: Q 5. A circuit diagram of the Wein bridge oscillator is shown in figure 6. Derive the necessary…

A: Oscillator circuit must satisfy the following two conditions known as Barkhausen conditions:1.…

Q: Determine vo and io in the Op-amp circuit.

A: The operational-amplifiers are made up of various active circuit components. These have some major…

Q: Which of the following is not a part of the PLL O a. Loop filter O b. phase detector O c.…

A: In this question, choose the correct options Which is the following is not a part of PLL. as per…

Q: Calculate the output voltage for i ) R - 2R DAC and ii ) weighted register type DAC with appropriate…

A: (i) The R-2R ladder Digital to analog converter (DAC) is drawn below for four inputs,V1, V2, V3 and…

Q: Calculate Vo and Io in the op-amp circuit

A: In this question , opamp is given...We have to find out voltage Vo and current io..

Q: 11. An SCR turn-off requires anode current falls below holding current. reverse voltage is applied…

A: The answer as given below:

Q: ١-Draw a Wien bridge oscillator Write the frequency of oscillation Write the condition of…

Q: The output voltage of an opamp is v(t)=10sin(200t) V. Find out the value of the slew rate of the…

A: The slew rate (SR) of an operational amplifier (opamp) is defined as the maximum rate of change in…

Q: OR Q 5. A circuit diagram of the Wein bridge oscillator is shown in figure 6. Derive the necessary…

A: Given circuit of Wein bridge oscillator, Given conditions, C1C2=a, R1R2=1b

Q: draw a wine bridge oscillator write the frequency of oscillation write the conditions of…

A: A Wien-Bridge Oscillator is a kind of phase-shift oscillator which depends on a Wien-Bridge network…

Q: Identify the Signal Processor. a. Thermistor O b. Thermocouple O c. R to V Convertor O d. RTD

A: A signal processor is a device that processes input signals and provides an output signal.…

Q: n ADC circuit ,the input will be signal.

A: In ADC Circuit,input to it is analog voltage signal. Analog voltage signal is send to the ADC…

Q: o 15V R 10 k2 8. 5 566 220 pF

Q: the correct name of this oscillator is * R1 R3 Tank Circuit crystal RC LC Hartley Feedback R2 www ww…

A: Brief description: For the given oscillator diagram we need to justify name of the oscillator…

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

Sol this Q fast plz

IC
in a DAC acts as an amplifier to
amplify the analog output voltage.

flag will be reset whenever the result
is positive.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Please write legibly, prioritize letter B (86/9 Ohms is the answer Rcd), the answers are A) 8 B)86/9 C) 32/9 D)80/9A) Rab B) Rcd C) Rac D) Rbc
A meter has a square law scale .for 2A current the deflection in 90°. for of a deflection of 45 °, the current is
The correct voltage waveform of the following clipper is
Q1 The magnetic circuit of Figure Q1(a) consists of rings of magnetic material in a stack of height h. The rings have inner radius R¡ = 3.2 cm, outer radius R, = 9.2 cm, stack height, h = 2.0 cm, air gap, g = 0.05 cm and the number of turns, N = 200 turns. If the fringing in the air gap increases the effective cross-sectional area of the air gap by 5% and the relative permeability µ, = 4000, determine: (а) The mean core length l, and the core cross-sectional area A. (b) The reluctance of the core R. and reluctance of the air gap R,. (c) The current i that required to produce a flux density of Bg = 1.25 T at an air gap. (d) If the current i is double from Q1(iii), determine the flux density in the air gap.
Answer M1 reading
Asap within 30 minutes will definitely upvote plz all parts
show part b answer clearly thank you
Number 16 (letters a and b)
For each of the following Cercuit Dia gram. (uie two flipplop Aand B Drive the state Epuateom Dnive the slate table state diagram Dnive the EN A clk CU
degrade the diagram
Final answer upto three decimal places
Answer it per number with step by step process pls