Consider the figure below for a real-time transmission. There are three packets to beplayed where first, second and third packets contain 12, 13 and 14 seconds of data,respectively. What is the units played for the second packet at time 28?ServerClientInternet00.00.0100.00.00First packet00.00.0400.00.1200.00.1400.00.16Second packet00.00.2500.00.2800.00.4200.00.29Third packet00.00.3900.00.43FlowPlay timeArrive timeSend timeSelect one:a.0b.12c.14d.1e.10

The correct answer of the questions is option("c") "14"

Consider the figure below for a real-time transmission. There are three packets to be played where first, second and third packets contain 12, 13 and 14 seconds of data, respectively. What is the units played for the second packet at time 28? Server

Consider the figure below for a real-time transmission. There are three packets to be played where first, second and third packets contain 12, 13 and 14 seconds of data, respectively. What is the units played for the second packet at time 28? Server

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter17: Commercial And Industrial Air-conditioning Control Systems

Section: Chapter Questions

Problem 25RQ

See similar textbooks

Related questions

Q: 1. Define: a) Communication b) Communication System c) Message d) Signal e) Transducer

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Given 7-bit message 1001101. Explain the process involved in Hamming code in sender and receiver…

Q: Consider g(x)= x3 + x + 1, with 1001 as the information sequence. Determine the transmitted…

A: The g(x) is given byg(x) =x3+x+1Data word is given by 1001 or 1+x3Now the code wordc(x)=d(x)g(x)

Q: Could you give brief explanation about LAN and WAN and write examples of network protocols that…

A: LAN (Local Area Network) It is a group of devices connected to each other in a small geographical…

Q: A TDMA system uses 25 MHz for the forward link, which is broken into radio channels of 200 kHz. If 8…

A: Given: TDMA system uses a total of 25 MHz bandwidth for the forward link. It is broken up into radio…

Q: Q.2) What is the method of arbitration of the PCI bus? Modify the following diagram arbitration,…

A: In order to attenuate the latency of access, PCI's arbitration mechanism relies on access instead of…

Q: SRAM uses RAS and CAS control lines. True False

A: The statement is false because the DRAM is associated with RAS and CAS and both help in refreshing…

Q: Problem 2 Consider a binary communications channel. Logical 0 is encoded with +1 Volt, and logical 1…

A: Given that logical zero was received and that +1 volt was delivered here, the probability necessary…

Q: Given that the Hamming (7,4) code has 1 word at a distance 7, 7 words at a distance 3 and 7 words at…

A: The Hamming codes were originally designed with dmin=3 which means that they can detect up to two…

Q: 5. Design a synchronous counter that counts from 0 to 32 and write its truth table?

A: Let us make the counter using the D flip-flops. Write the state table for the D flip-flop.…

Q: We know that P(transmitting a 0) = P(transmitting a 1). (a) Give the block diagram of the optimal…

A: Given the binary signalling scheme using the following two waveforms: a) We need to give the block…

Q: Consider ROP APP which deals with all traffic and individual citizen and expat details and…

Q: B. Why VSB modulation is used in TV picture transmission?

Q: Consider a CDMA system where transmitter A has the code 101010 and transmitter B has the code…

A: The given CDMA system transmitter A code is 101010. The given CDMA system receiver B code is 111001…

Q: -Q.1 B) Construct a 5-to-32-line decoder with four 3-to-8-line decoders with enable and a 2- to-…

A: Note: Since you have posted multiple independent questions in the same request, we will solve the…

Q: In an FDMA-based multiple access system, each user is assigned an 80 kHz channel for full-duplex…

Q: Subject: Computer Networks Note: Please answer in own words. copy from internet will very unhelpful…

A: Fragmentation: when a data packet is received at switch or router it checks the address of receiver…

Q: Q- To transmit the data 1011000 to his friend using hamming code technique. Calculate the…

A: To transmit the data 1011000 to his friend using hamming code technique. Calculate the transmitted…

Q: Which of the following statement is related to backward explicit congestion notification in frame…

Q: This elementary problem begins to explore propagation delay and transmission delay, two central…

Q: Construct a 4-to-16-line decoder with five 2-to-4-line decoders with enable. Use block diagrams.

Q: Question 3 For the network 129.120.0.0/16. How many 129.120.0.0/24 subnets exist? (numeric response)…

A: Given data:

Q: MMF method is called optimistic method as the regulation obtained is less than the actual value.…

A: MMF method us called as optimistic method as obtained regulation is less than actual value.

Q: b) Three stations share a 60 kbit/s ALOHA channel. The average bit rates transmitted from each of…

A: b. Given data is Channel bit rate is 60 kbps ALOHA Channel each station transmission time is…

Q: a) Find R, for On-off, Polar and Bipolar signaling schemes. b) For Line codes, why do we find the…

A: b) PSD feature is helpful technique in case one need to describe oscillatory signals in your time…

Q: What characteristics do Unified Communications Systems possess? What are the benefits of using them…

A: Communication is the exchange of information. Information can be imparted to either individuals or a…

Q: A. Given a fixed route and fixed link types between two end systems, which of the following delays…

A: Answer (A) From the given delay types the delay may vary depending on the level of congestion in the…

Q: Assume that we are using QAM-system that are capable of sending two messages simultaneously at the…

A: Since you have asked too many questions I will answer the first two questions, you can ask the other…

Q: Discuss Telecommunication Engineering, explaining all its key components and how telephone call is…

A: The communication systems enable fast transfer of information all over the world. Some modes of…

Q: In a telephone TDM system, a DS0 has a capacity of 64kbps and a T1 link rate is 1.544Mbps. How many…

Q: R₂1 to transmit a packet into its link (i.e., the packet transmission delay at the sender)?

A: Solution- GIVEN, Packet size = 1Mbit (106 bits) Transmission rate = 100 Mbps (100 x 106 bits per…

Q: a. Discuss briefly the Infrastructure Sharing Among Ghana’s Mobile Telecommunication Networks:…

Q: by using karnaugh map, what is the minimum POS form for this expresson

Q: B) Reduce the following function using Tabular (Quine_McCluskey) method? f(A, B, C, D, E) =…

A: Hi , Hope you are doing well I can answer only first question as per guidelines

Q: (b) In a particular implementation of ADSL2+, 400 downstream subchannels are being used to achieve a…

Q: Serial transmission have one wire and sends one bit at a time True False

A: Serial Transmission :- In this method data is sent or received using a single wire or single…

Q: What is the biggest disadvantage of the ASK scheme?

Q: Band gap between 300-3400 Hertz for voice transmission on telephone lines used in homes and offices…

A: As we have given : The above figure can be redrawn as :

Q: Q3) For the following 8-bit Transmitter-Receiver system; write a VHDL code to check received vector…

A: Q3 VHDL Transmitter code: library ieee;use ieee.std_logic_1164.all;entity UART_Transmitter…

Q: a) i. Distinguish between circuit and packet switching in communication system. a) ii. State…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Write a synopsis of JAD and RAD. Distinguish how they are different from conventional fact-finding…

A: Joint Application Development (JAD): • JAD is one of the Team Based Techniques. • It is a user…

Q: A bank has its head office in the financial district in the middle of a city. It has six branches,…

A: The cost of all branches is calculated as: Cb=3×6×100ε=1800ε The cost of all modem is determined as:…

Q: If there are 2800 calls arriving per hour to a trunk circuits without blocking, calculate the…

A: Calls per hour Qi=2800 Average calling time T=1.76 min

Q: What happen to a call in fixed channel strategy, if all the channels in a cell are occupied? a)…

A: As any call attempt that can be used by unused channels in a fixed channel plan. If all channels in…

Q: In a WLAN system which is using DSSS, following data 11010010001011011101 is transmitted. If 1101 is…

A: In a WLAN system which is using DSSS, following data 11010010001011011101 is transmitted. If 1101 is…

Question

Consider the figure below for a real-time transmission. There are three packets to be
played where first, second and third packets contain 12, 13 and 14 seconds of data,
respectively. What is the units played for the second packet at time 28?
Server
Client
Internet
00.00.01
00.00.00
First packet
00.00.04
00.00.12
00.00.14
00.00.16
Second packet
00.00.25
00.00.28
00.00.42
00.00.29
Third packet
00.00.39
00.00.43
Flow
Play time
Arrive time
Send time
Select one:
a.0
b.12
c.14
d.1
e.10

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Consider the line of code below. analogWrite(11, 84); The voltage at pin 11 is turns on (at 5V for Uno) and off at 500 Hz. This PWM frequency is the default value for Arduino boards. How many microseconds is the voltage at pin 11 high?
Given that the base address is FoH. 1. Create a new asm project “Lab2_Q1.asm". Assume that port A of 8255A PPI is connected to 8085. Write assembly code to send the value of FFH to FoH. Enter a delay of 2 ms for each transmission.
What is the expression for the following kmap? Assume the ? values are don't care values but if circled, they are 1. So assume 1100 has 1 instead of ?. What is the expression?
Q6: Sectoring is a way to do what? a. Achieve branch circuits. b. Put each phone call in a different time slot. c. Do SS7 look-ahead call placement. d. Partition Voice mail boxes e. It is an ISDN-PRI way of brining in trunks f. Achieve frequency reuse. g. None of the above
SIGNAL AND SYSTEM AS SOON AS POSSIPLE
In a TDMA system, the number of overhead bits and the number of total bits are 332 bits and 1250 bits. What will be the efficiency of the system?
Give the basic circuit for DRAM?
Question 5: a) In the context of WCDMA, answer the following questions: What is the chip rate of WCDMA? i. ii. What is the duration for WCDMA frame? iii. For the figure shown below, what is the spreading factor? Symbol iv. V. vi. vii. Data Spreading code Spread signal Datax code Spreading What is the corresponding processing gain? For the figure shown below, what is the multiplexing mode used? Uplink Downlink Frequency Time WCDMA has a frequency reuse of 1 between different cells. What does that mean? If fast fading occurs when the path difference between two received signals is half wavelength. Calculate the path difference at a frequency equals to 2 GHz.
1) (3526)= (?)2 & (25.316)10 = (?)2 & (2164) =(?) 10 & (142.37) 8 = (?) 10
In a public switch telephone network (PSTN),how the analog speech signal is converted to digital signal in the PCM? Also highlight the main functions of the given parts in the PSTN figure. Subject is Communication system.
19. Gate A has tPLH = tPHL = 6 ns. Gate B has tPLH = tPHL = 10 ns. Which gate can be operated at a higher frequency? Explain!
Please consider the digit ( dU5148 ). Print that specific combination using one 7 segment display in a serial. the following should be included in the report. 1. Generalized Equations (SOP & POS).