Consider error control methods in digital signal transmission. Assume Hamming code is used with even parity. (a) Assume the received code word is 1110101001, determine if the code word is correct. If no, identify the wrong bit and obtain the original data word. (b) If the analogue signal before digitalisation is of frequency from 200 Hz to 1.5k Hz. What is the lowest sampling frequency? (c) Following (a) (b), determine the bandwidth requirement for transmitting the digital message.

Consider error control methods in digital signal transmission. Assume Hamming code is used with even parity. (a) Assume the received code word is 1110101001, determine if the code word is correct. If no, identify the wrong bit and obtain the original data word. (b) If the analogue signal before digitalisation is of frequency from 200 Hz to 1.5k Hz. What is the lowest sampling frequency? (c) Following (a) (b), determine the bandwidth requirement for transmitting the digital message.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

An a differential pulse code modulated system, the transmitted bits per sample is 7. How many levels are present in the quantizer?
There exists one or more discrete ime signal. What is it control system ? (a) discrete time or (b) continuous time
1. With the help of Octave program perform the Modulation and Demodulation (AM) of information signal with carrier signal, through subplots with following signals a. Modulating signal b. Modulated signal c. Demodulated signal
QUESTION 11 Describe the effect of sampling rate and quantizer bit number on the quality of the generated digital signal. For the toolbar. press ALT+F10 (PC) or ALT+FN+F10 (Mac).
Choose the correct answer low HDOP (Horizontal Dilution of Precision) number such as2 indicates a ........................... a.poor fix b.good fix c.poor signal quality d. good signal quality
Write a note on digital signal.
NUMERICAL DATA COMMUNICATION An analog signal in sine form is intended to be transmitted to the receiver by pulse code modulation.Given below Define the parameters and answer the questions asked from you. *Peak to peak amplitude = xxx volts *Signal frequency = xxx Hz *Medium height form factor: xxx level 1-)What should be the theoretical minimum sampling frequency for the signal to be reconstructed in the receiver without distortion? 2-) What should be the practical minimum sampling frequency for the signal to be recreated in the receiver without distortion?
[0 5] the signal in the volt range will be quantified. since n=4; a)Calculate what is the number of Qunta levels? b) Calculate what is the quantization interval? c)V=3.2 volts rounded to what quantization level? Let's draw with Quantalama level chart
Problem 2: The information in an analog signal voltage waveform is to be transmitted over a PCM system with an accuracy of ± 0.1 % of the peak-to-peak analog signal. The analog voltage waveform has a bandwidth of 100 Hz and an amplitude range of – 10 to + 10 Volts. Determine the minimum sampling rate required. b. Determine the number of bits in each PCM word. c. Determine the minimum bit rate required in the PCM system. d. Determine the minimum absolute channel bandwidth required for the transmission of the PCM signal.
5- Discuss the effect of changing the number of bits on the recovered analog waveform. 6- Discuss the effect of changing the frequency of input analog signal on the reconstructed analog output signal.
This is Digital Signal Processing Question. Attached please fnd my question.
Decoder circuit as shown in the following Figure. if A is LSB and C is MSB, the output expression F= YO Y Y, Y, D. Y. Decoder O a. B' O b. C O'c.B O d. C