Consider a silicon pn junction solar cell at 300 K with a reverse saturation current of 1x10-7 ampere. Calculate the open-circuit voltage of this solar cell when the photocurrent is 3.6 ampere. Lütfen birini seçin: 0.15 volts 0.55 volts 0.45 volts 0.5 volts 0.35 volts

Q: A diode at room temperature (VT=25mV) conducts 1.2 mA when its forward voltage is 0.7 volts. What…

A:

Q: Determine Zener diode voltage value as well as the ripple percentage of the circuit below. (Show…

A: The circuit diagram is shown below,

Q: (b) Design the circuit in the box to perform the function indicated in figure below Silicon diodes…

A: Please refer the attached images for the complete answer..

Q: The rate of fall of current in a diode with reverse recovery charge and reverse recovery current of…

A: Given : reverse recovery charge of diode and reverse recovery current of diode To find rate of fall…

Q: Draw band diagrams for below contacts.   b) metal-n-type semiconductor for Φm> Φs

A: we need to draw the band diagram for metal and n type semiconductor contact for Φm> Φs

Q: A diode at room temperature (VT=25mV) conducts 1.8 mA when its forward voltage is 0.7 volts. What…

A:

Q: What is the temperature coefficient of the given Zener diode with nominal voltage of 10V, when the…

A:

Q: Sketch the IV curve of a diode using the on/off model where VON = 0.6V

A: diode  I-V characteristics VON = 0.6 V

Q: Calculate the small signal diode conductance for Ip = 7.6 x10-4. Diode is at room temperature and n…

A:

Q: What will be the intrinsic carrier concentration of Silicon at 300k temperature

A: Silicon is a very widely used semiconductor material. The intrinsic carrier concentration of silicon…

Q: T11. Fermi energy level for p-type extrinsic semiconductors lies (a) At middle of the band gap (b)…

A: The fermi energy lies middles between conduction band and valance band for Intrinsic semiconductor.…

Q: ompare between insulators for different OPL voltages (low, medium and hig

A: Compare between insulators for different OPL voltages (low, medium and high).

Q: For what voltage will reverse current germanium diode reach 90% of saturation value at 300°k.

A: Given, Reverse current of germanium diode reach 90% of saturation at 300o K IDO=0.9IO T = 300o K =…

Q: 8. If kr = Eripplerms/Eave, determine kr of the given waveform. 2Vp-p 10v O 1 0.5 0.06 0.3

A:

Q: 2. Design a clamper circuit to perform the function indicated. Vin 10 V -10V + Vin DESIGN + Vout…

A: We need to design a clamper circuit for given input and output waveform . We will design it with the…

Q: What are the p-layers of silicon separated by a depletion layer from an n-type layer

A: The explanation is as follows.

Q: What is the value of p0 in silicone T=300K if Fermi energy is above 0.22 eV of the value band…

A: consider the following electrical properties of silicon at temperature 300 kelvin

Q: Calculate the conductivity of intrinsic silicon at 100°C.

A: According to the question, we need to calculate the conductivity of intrinsic silicon at 100°C.

Q: Q1: ideal diodes are used in the circuit shown in figure. Sketch the output voltage 1Kohm D3…

A:

Q: Suppose a semiconductor has ND=1016/cm3and ni =1010/cm3. What are the equilibrium electron and hole…

A: Given information: The donor impurity concentration is ND=1016/cm3 The intrinsic carrier…

Q: 2-13. In a compensated semiconductor, p. = 4 x 106 cm-³ and N₁-N₂ = 4.99 × 10¹8 cm-³. What is the…

A:

Q: Determine the threshold voltage of silicon diode when it operates at 90 degree F.

A:

Q: current of 8.75MA is flowing through the diode during forward bias at 25.5°C [2] room temperature.…

A:

Q: 1 (b) When EF touches intrinsic Fermi energy EFi, comment on whether an extrinsic semiconductor will…

A: In this question, we have to check the state of semi conductorwhen EF touches intrinric femi energy…

Q: Trace the output of the network  if the input is a 30V triangle wave, repeat for a sine wave of 8V .…

A: In the circuit, 2 zener diode is connected to back to back. Draw the output waveform 1. f the input…

Q: For the following circuit, determine the waveform of R1. Consider diodes ideals

A:

Q: R2 D1 1800 D2 V1 E12 V R1 D3 R3 2000 1500

A: First we will check which diode will be on or off then we will find out current through diode

Q: What is the voltage across a silicon diode when a forward bias current of 2.39 mA is measured…

A: What is the voltage across a silicon diode when a forward bias current of 2.39 mA is measured…

Q: Draw the output voltage waveform. Show in step by step.

A: Diode is forward biased when anode voltage is greater than cathode voltage. And diode is reverse…

Q: 2. Draw the input and output waveform for the following clipper circuits if input signal is triangle…

A: Given data, Frequency f=1 kHz  =1×103 Hz Input triangular wave is given by 10 V. Given circuit,

Q: V1 D1 R1 R2 1ka 2k0 10 V Figure 3.

A:

Q: In a given circuit below is connected to an AC signal with 240V peak in a 4:1 transformer. Sketch…

A: It is given that:

Q: What should be the value of Vi, if we have a Zener Diode with a breakdown voltage of 6.2 volts and a…

A: Given  circuit-

Q: CHOICES: Oa. Ob. QUESTION #4. Assuming ideal diodes, select from the choices shown the output…

A: As given diode is ideal. Forward voltage drop of ideal diode is 0V i.e. act as short circuit.…

Q: A center-tapped FWR circuit have an output dc voltage of 54 V. What is the PIV rating for the…

A:

Q: What happens to the Fermi level of an intrinsic semiconductor when the temperature goes up?…

A: Semiconductor- Semiconductor is a material which have value of conductivity is between conductors…

Q: A Germanium diode has reverse saturation current of 5µA at 27 °C. Determine the value of its forward…

A: Here we know the diode current equation, we will put value of known parameters , and find out…

Q: Question 3: If we assume the reverse current is -99 pA, the built-in voltage is 0.64 V, and the…

A: Given data, Reverse Current IRC1=-99 pA Built-in-voltage IBV=0.64 V Applied voltage Va=-26 V

Q: what is the schemtic diagram of TP4056 and Li-ion battery when they connect to each other. The…

A: According to the question, we need to provide the connection diagram for the given figure.

Q: 3.) Design clamper to perform the function indicated in the figure. 01

A: The clamper circuit is used to shift the DC line of the waveform without altering the shape of the…

Q: Determine the maximum value of Vi for proper operation of the zener diode. 910 Vi 2200 Vz = 8v Pzm =…

A:

Q: Calculate the reverse saturation current of a diode if the current at 0.2V forward bias is 0.1mA at…

A:

Q: Resistor 10k Diode 1N914 VAC + SINE(0 20 10 0 0 0 40) Vdc 5v

A: The given clipper circuit is shunt positive clipper circuit with positive biasing. To get another…

Photoelectric

The photoelectric effect occurs when light (or similar incident radiation, including X-rays) falls on material together with a metal plate and causes it to emit electrons. The discovery of the photoelectric effect led to important new theories (and to a Nobel Prize for Albert Einstein). Photoelectric cells, or photocells, are utilized in burglar-alarm light detectors and garage-door openers (each employs a through-beam of light this is broken when something movements throughout it), and also to play soundtracks on film movies (in which a light beam shines through the soundtrack encoded at the film and is "read" with the aid of the photocells).