Consider a short time span just before and afterthe spark plug in a gasoline engine ignites the fuel-air mixture andreleases 1970 J of thermal energy into a volume of 47.6 cm3thatis at a gas pressure of 1.17 * 106 Pa. In this short period of timethe volume of the gas can be considered constant. (a) Treating thefuel-air mixture as a monatomic ideal gas at an initial temperatureof 325 K, what is its temperature after ignition? (b) What is thepressure in the gas after ignition?

Q: Define T-v diagram for the heating process of water at constant pressure.

A: Consider the T-v diagram shown below.

Q: A 2.71 kg of air at 20.28 C underwent an isobaric process wherein its initial volume of 1.75 m3 was…

A:

Q: Formulate : isentropic process relation for perfect gas P f (p, T, )

A: For a perfect gas, it is known that, ds=0du=cvdTdh=cPdT Here, ds is the change in entropy, du is the…

Q: raction of the steam is 0.92. The air – steam mixture is then compressed to one-fifth of its…

A: Given data as per questionPressure of mixture of air and wet steam=130 kN/m2Temperature,T1=76°CThe…

Q: A 6 m3 TANK CONTAINS HELIUM AT 400 K AND IS EVACUATED FROM ATMOSPHERIC PRESSURE TO A PRESSURE OF 740…

A:

Q: Hydrogen gas at 65 kPa, 200 °C is heated in a closed, rigid vessel until it reaches to 400 °C.…

A:

Q: P(KPA) Consider the following cyclic process. Heat is al- lowed to flow out of a 0.7 mol of ideal…

A:

Q: (a) For 3.35 moles of a monatomic ideal gas taken through the cycle in the figure, where V1 = 8.00VO…

A: As the given data V1=8.00 V0n=3.35moles

Q: A rigid container contains refrigerant-134a. The volume, the mass and the pressure of the…

A: Given:Volume of the container, V=79 LMass of the refrigerant, m=3.95 kgPressure of the container,…

Q: solve in peaper

A: In the given equation, T represents the final temperature of the gas mixture, A is a constant, Pi…

Q: In a rigid container with a volume of 0.4 m3, there is a mixture of 2 kg of liquid-steam at a…

A:

Q: 16. What is the most nearly the combined volume of 1.0g of hydrogen gas and 7.0g of helium gas when…

A:

Q: Who is right?

A: To Find:- Who is right

Q: (a) An 88-litre gas cylinder is filled with propane gas at a pressure of 1.15 MPa and 18°C. The…

A:

Q: Which is the physical property to express deviations of pressure between an ideal mixture and a real…

A: Given question : Which is the physical property to express deviations of pressure between an ideal…

Q: Shown in the figure, an insulated rigid tank is divided into two equal parts by a partition.…

A: Giveninsulated tankm=4kgP1=600kPaT1=300KR=0.287 kJ/kgKCv=0.7180 kJ/kgK∆U=mCvT2-T1

Q: Consider a perfect gas that undergoes 1) isobaric heating or 2) isochoric heating,in each case…

A: The objective of the question is to compare the final values of specific internal energy (e) and…

Q: A Styrofoam bucket of negligible mass contains 1.75 kgof water and 0.450 kg of ice. More ice, from a…

A: Given, Initially mw = 1.75 kg mice = 0.45 kg mass of ice at equilibrium m = 0.884 kg

Q: A mixture of 1.6 kg of N2 (Cp=1.049 kJ/kg.K) and 0.75 kg of H2 (CP3D14.501 kJ/kg.K) is contained in…

A:

Q: A 2.01 kg of air at 24.10 C underwent an isometric process wherein its initial pressure of 53.63 kPa…

A:

Q: Steam at 101.325 kPa and 373.15 K was isothermally compressed. Which is expected to happen? A It…

A:

Q: Air is initially at 50 °C (dry-bulb temperature). Its specific volume is 0.95 m³/kg dr air. It is…

A:

Q: ۱/۱ : 0 о ) العنوان Prave the temp vay For the adiabatic mixing of mixtures of gases, prove the…

A: Adiabatic mixing is a process in which two or more gases are mixed together without any heat…

Q: Classify internal combustion engines taking various factors into consideration. What is a…

A: Internal combustion engines can be classified into categories based on the following factors: Based…

Q: Calculate the specific volume of an air-vapor mixture in cubic meters per kilogram of dry air when…

A: The given information in the problem is shown in the following attached image:

Q: The instrument reads a height equivalent to 0.95 atm. The air is compressed adiabatically to 87,000…

A: GIVEN DATA- INTIAL PRESSURE = 0.95atm FINAL PRESSURE =87000Pa WE HAVE TO FIND PROPERTY AT FINAL…

Q: onditions of the given phase change material. (1) In refrigerant R134a, calculate the temperature…

A:

Q: 2. Humid air at 35o C and a pressure of 1 atm and with 98% relative humidity enters a condenser in…

A: Given: Properties of humid air  T1=35oCP=1 atmRelative Humidity φ=98%Tcond=15oC=288…

Q: Please show complete (not shortcut) solution with derivation of formulas. Two tanks are connected…

A:

Q: Using the Clapeyron equation, determine the latent heat of vaporization of saturated Propane. Data:…

A:

Q: kg 2kg Of air at 500 K is mixed with 1.6 of air at 900 K in an insulated chamber S The resulting…

A:

Q: Consider an ideal monatomic gas. Here, take N as constant. We can take any two arguments like (p, V)…

A: Given that  Consider an ideal monatomic gas. Here, take N as constant. We can take any two…

Q: A tank occupied by saturated liquid-vapor mixture of refrigerant-134a at 1.6 MPa. If the fraction of…

A: Given, P=1.6 MPa VgV=0.92

Q: 3. Calculate the work done by the ga:

A: To find the work done by gas.

Q: Calculate the specific volume of air-vapor mixture (m3/kgda) when the following conditions prevail:…

A:

Q: A mixture of gases expands from 0.03 m to 0.06 m at a constant pressure of 1 MPa and absorbs 84 kJ…

A: Initial volume = 0.03 m3 Final volume = 0.06 m3 Heat absorbed = 84 kJ Answer is (b) 54 kJ

Q: Steam enters a diffuser steadily at 300 kPa and 300 °C having a velocity of 80 m/s. The inlet…

A:

Q: shown in the figure, a tank fitted with an electrical resistor of negligible er a period of 10…

A: Given data as per questionNitrogenm=2 kg, T1=27°CP1=0.1 MPaTime, t=10 minPower, P=0.35 kWHeat…

Q: Hydrogen at 200 kPa and 500 Ki: contained in a 3-m3 rigid tank. The cooling of the gas is continued…

A:

Q: All the Evaluations carried out so far for U, H, S , Cp and Cv on the molar basis can be re-written…

A: To convert thermodynamic properties from a molar basis to a mass basis, you need to consider the…

Q: A 4.16-ft container is filled with 2.22-lbm of oxygen at a pressure of 84.17 psia. What is the…

A:

Properties of Pure Substances

A substance with fixed chemical composition throughout is called a pure substance like water, air, and nitrogen. A pure substance does not have to be a single element or compound. A mixture of two or more phases of a pure substance is also a pure substance as long as the chemical composition is the same for all phases. These substances mainly have a constant/ uniform composition. The substances also have fixed boiling and melting points. A pure substance takes part in a chemical reaction to form predictable products.