Coal analyzes 0.23 VCM, 0.64 FC, 0.08 Ash, 0.016 S,and 0.016 N and has a calorific value of 30MJ/kg. It is burned with 40% excess air to give a flue gas with a molar ratio of CO2 to CO of 12:4. Calculate the ultimate analysis of the coal.

Q: 5. Calculate the pH after 0.100 mole of HCI(g) is bubbled through a buffer solution prepared by…

A: Note: As per our guidelines, we are supposed to solve only one question of multiple questions.…

Q: Water is flowing through a horizontal pipe of diameter 250 mm. If the pressure drop between two…

A: Given: D = 250 mm ΔP = 825 Pa

Q: 1-the reason of using heat plate exchanger for sterilization of milk in dairy industry .??? 2-the…

A: From many years heat exchangers have been widely used in dairy industry for various purposes…

Q: The Nitrogen gas is in a container of 0.45 L ', it is compressed adiabatically, up to a final volume…

A:

Q: Professor Modyn's steady state flow reactor is now fed acetylene (C, H,) at 2.000 mol/s. The…

A: Acetylene is burnt with air in a flow reactor.

Q: Suppose an irreversible process takes 1.0 mol of monoatomic ideal gas from state 1 to state 2, where…

A:

Q: A sample consisting of 2.5 mol of perfect gas molecules with Cp,m = 29.4 J K-1 mol-1 is initially at…

A: Given that- Gas is a ideal (perfect) for which, number of moles, n= 2.5 mol Initial temperature, T1=…

Q: 5. Write a balanced equation for the given chemical reaction. CH3COF + H20 → CH3COOH + HF

A: Write the reaction as follows: CH3COF + H2O  →  CH3COOH + HF

Q: A pitot tube is installed in a pipe (ID= 0.6m) where air is flowing at 66°F. Manometer reading is…

A: Given Data: Internal Diameter of pitot tube; D=0.6 mManometer Reading; h1=0.11 mStatic Reading;…

Q: A 30 g/l solution of a fluorescent tracer was discharged into a stream at a constant rate of 12…

A: Given data: Concentration of tracer = 30 g/L Volumetric flow rate = 12 cm3/s

Q: A liquid mixture containing 30.0 mole% benzene (B), 25.0% toluene (T), and the balance xylene (X) is…

A: Given, Composition of liquid mixture, overhead product and bottom product

Q: 8. The reactants A and B are mixed, and the reaction is timed until a color change occurs. The data…

A:

Q: One mole of Fuel (CH) with 2.5 mole of pure-Oxygen. If the products analysis show: Xeo=Xco2=XH20,…

A: Given that- Moles of fuel CxHy = 1 mol Mole of pure O2= 2.5 mol For products the mole fractions are,…

Q: In comparison to liquids, solids have a specific heat capacity of 500 ?

A: There is a need of adding energy to increase the temperature of the system. Similarly, to decrease…

Q: What is Tg and Tm. Compare them in terms of polymeric chain motion.

A:

Q: A food product with an initial moisture content of 32.0% is to be dried to a final moisture content…

A:

Q: Joe, the maintenance man, dumps the contents of a 55-gal drum of water into the tank pro- cess shown…

A:

Q: Calculate the heat of reaction of the following reactions. Please note that the reaction…

A: BALANCE EQUATION C6H12O6  + 6 O2   -> 6CO2 + 6H20 WEKNOW THAT,  heat of FORMATION OF CO2  = HFCO2…

Q: A liquid that is almost entirely water is reported to contain 125 ppb phenol (mass basis). (a) What…

A: Given, Liquid contains 125 ppb phenol

Q: I want the theory part about the MULTI-COMPONENT DISTILLATION. PLZ I want a perfect answer with…

A: Introduction: Multicomponent distillation: Multicomponent distillation is a chemical technique…

Q: Identify the process industries in Oman where these mass transfer operations are deployed and…

A: Introduction Some of the prominent chemical industrial complexes in Oman are Sohar International…

Q: ) Suppose that 5.5 mmol argon gas occupies 72 dm³ at 500 °R and expands to 100 dm³. Calculate AG for…

A: The temperature is maintained constant in this system. The expansion is said to be an isothermal…

Q: A parallel-flow double-pipe heat exchanger operates with hot water flowing inside the inner pipe and…

A: Given data: Mass Flow rate of water; m.=2 Kg/sInlet Temperature of water; Thi=90 °COutlet…

Q: Adsorption Isotherm Curve: The low pressure (beginning region) of an adsorption isotherm curve can…

A: We are given the following data P X* 0 0 2 0.084 3.5 0.15 5 0.27 7 0.38 10 0.525…

Q: The following reaction is carried out in a batch reactor in which there is pure A initially. The…

A:

Q: A Carnot heat engine is supplied with heat through the combustion of gasoline that has a specific…

A:

Q: identify the degress of freedom of a mixture composed of ethanol, water and ice cubes

A: Given: Mixture of ethanol, water, ice cubes

Q: Explain in half a page how you would determine the reactor volume when provided with the influent…

A: The concentration of BOD (in mg/l) in the influent can be used to calculate the total BOD load per…

Q: ou receive a Pt/Al2O3 catalyst of unknown surface area to be used for dehydrogenating cyclohexane…

A:

Q: Y2 QI. Use block diagram manipulations to compute the transfer functions 4 and 4 for the following…

A: Answer: 1) From Diagram we get,  y1y2 = 1ZKB*ZM11 + 1ZKB*ZM1 y1y2 = ZM1ZKB+ ZM1 y1y2 = ZM1ZKB+ ZM1 =…

Q: 26 What is the molarity of each solution? (a) 47 g of KCl dissolved in enough water to give 26 375…

A: Molarity

Q: Consider the gas phase reaction A(g) + B(g)= 2C(g). (i) Show that the reaction Gibbs energy is given…

A: Given : A+B ⇔2C

Q: 2. A 6-L pressure cooker contains 0.6 kg water at 175 kPa at the end of the cooking period. By…

A:

Q: Calculate (a) the rate of evaporation, or the rate of water evaporated at the evaporator, and (b)…

A: The potassium chromate in feed is obtained in kilograms. The water in feed and cake is obtained. The…

Q: Q1:-prepare a standard solution of a Sodium Chloride (CaCL2), 222000 PPM in 100 ml of water. And…

A:

Q: Develop the equation of the external isothermal and non-isothermal efficiency factor for a zero…

A: An isothermal process is a sort of thermodynamic process in which the temperature T of a system…

Q: A falling-cylinder viscometer consists of a long vertical cylindrical tube (of radius R), capped at…

A: We have to prove that for Newtonian fluid, the equation for velocity profile becomes equation (1.2)

Q: A 200-gram Aluminum cup contains 400 grams of water at 40°C. Aluminum shot with a mass equals to 300…

A: Given that- Mass of Aluminium cup, mAl =200 g = 0.2 kg Mass of water, H2O= 400 g =0.4 kg Mass of…

Q: :- Find the mobilities, and resistivities of silicon samples at 300 K, for each of the following…

A: Use law of mass action

Q: What are the coordinates of the point at the center of the cube for a BCC? ½, ½, ½ O 0,0,0 O%, %, O…

A: The simplest repeating structure in a crystal is a unit cell. The unit cell is given in terms of…

Q: The following information one needs to know about in order for a solid to be well characterized…

A: A solid is characterised with the aid of structural pressure and resistance to a pressure utilized…

Q: Illustrate the preparation of porous carbon materials using sugarcane biomass

A:

Q: Q1:- prepare a standard solution of a Sodium Chloride (CaCL2), 222000 PPM in 100 ml of water. And…

A:

Q: Imagine we calculate Z and the molar volume of ethylene at 25°C, 12 bar using the following…

A:

Q: Develop the equation of the external isothermal and non-isothermal efficiency factor for a zero…

A: An isothermal process is a sort of thermodynamic process in which the temperature T of a system…

Q: The reversible (elementary) reaction 2A C+D is conducted in a CSTR at a feed rate of 100 L/min with…

A: Dear User, According to Bartleby policy, we can answer only one problem, we are gonna solve the…

Q: Isopropyl alcohol is mixed with water to produce a 32.0% (v/v) alcohol solution. How many…

A: Given, 32% v/v alcohol solution

Q: The partial molar volumes of two liquids A and B in a mixture in which the mole fraction of A is…

A:

Q: flow is 3 kg/s, calculate the throat area, exit pressure, exit temperature, exit velocity, and the…

A:

Q: 3.Which has higher ionization energy, potassium cation or chlorine anion? Why?

A: Given data Which has higher ionization energy, potassium cation or chlorine anion? why?